Atmospheric icing

Atmospheric icing occurs in the atmosphere when water droplets suspended in air freeze on objects they come in contact with. It is not the same as freezing rain, which is caused directly by precipitation.

Atmospheric icing occurs on aircraft, towers, wind turbines, boats, oil rigs, and trees. Unmanned aircraft are particularly sensitive to icing. In cold climates, particularly those at higher elevations, atmospheric icing is common in winter as elevated terrain interacts with supercooled clouds that can cause icing on contact. Ice loads are a major cause of catastrophic failures of overhead electrical power lines, as power lines can break under the weight of accumulated ice. Therefore, estimation of maximum potential ice load is crucial in the structural design of power line systems to withstand ice loads, and this can be done with numerical icing models and examples that include meteorological data.

Formation

Water does not always freeze at . Water that persists in liquid state below this temperature is said to be supercooled, and supercooled water droplets cause icing on aircraft. Below , icing is rare because clouds at these temperatures usually consist of ice particles rather than supercooled water droplets. Below , supercooled water always freezes; therefore, icing is impossible.

In aviation

Icing conditions can be particularly dangerous to aircraft, as the built-up ice changes the aerodynamics of the flight surfaces and airframe and results in structural icing, which can increase the risk of a stall and potentially accidents.

There are three types of structural icing: rime icing, clear (or glaze) icing, and mixed icing. Rime ice is rough, milky, and opaque. It forms rapidly from small supercooled water droplets and is the most reported icing type. Colder temperatures, lower liquid water content, and small droplets favors the forming of rime icing. Clear ice is glossy, clear, or translucent. Compared to rime ice, clear ice forms relatively slowly and tends to appear with warmer temperatures, higher liquid water contents, and larger droplets. Mixed ice is a mixture of rime and clear ice.

The structural icing of an aircraft is largely determined by three factors: supercooled liquid water content, which decides how much water is available for icing; air temperature, with half of all reported icing occurring between and ; and droplet size, with small droplets influencing aircraft's leading edges and large droplets can impact further aft of the airfoil. Airspeed influence the icing too. In general, the faster the speed, the more ice accumulation. However, this is counteracted by airframe skin surface at higher airspeed, and as a result, structural icing is minimal when speed is above . Additionally, the design of the aircraft will also influence the icing.

In stratiform clouds, icing is more mild. It generally form as rime or mixed icing and tends to be confined in a thick layer. In contrast, icing intensity level in cumuliform clouds may range from trace for small cumulus to severe for large ones in the form of clear or mixed icing in the upper levels and can extend to great heights.

To ensure flight safety, on-board ice protection systems have been developed on aircraft intended to fly through these conditions.

See also

* Condensation
* Frost
* Hard rime
* Soft rime
* Icing (nautical)

References

;Sources

FAA (U.S.) Advisory Circular 20-113
Pilot Precautions and Procedures to be taken in Preventing Aircraft Reciprocating Engine Induction System and Fuel System Icing Problems

FAA (U.S.) Advisory Circular 20-117
Hazards Following Ground Deicing and Ground Operations in Conditions Conducive to Aircraft Icing

FAA (U.S.) Advisory Circular 20-147
Turbojet, Turboprop, and Turbofan Engine Induction System Icing and Ice Ingestion


Icing on wind turbines

External links

Airline Regulators Grapple With Engine-Shutdown Peril
WSJ April 7, 2008
*
Supercooled liquid water and airframe icing

{{Authority control

Precipitation