SPAD S.XIII

The SPAD S.XIII is a French biplane fighter aircraft of the First World War, developed by '' Société Pour L'Aviation et ses Dérivés'' (SPAD) from the earlier and highly successful SPAD S.VII.

During early 1917, the French designer Louis Béchereau, spurred by the approaching obsolescence of the S.VII, decided to develop two new fighter aircraft, the S.XII and the S.XIII, both using a powerful new geared version of the successful Hispano-Suiza 8A engine. The cannon armament of the S.XII was unpopular with most pilots, but the S.XIII proved to be one of the most capable fighters of the war, as well as one of the most-produced, with 8,472 built and orders for around 10,000 more cancelled at the Armistice.Sharpe 2000, p. 272.

By the end of the First World War, the S.XIII had equipped virtually every fighter squadron of the ''Aéronautique Militaire''. In addition, the United States Army Air Service also procured the type in bulk during the conflict, and some replaced or supplemented S.VIIs in the Royal Flying Corps (RFC), pending the arrival of Sopwith Dolphins. It proved popular with its pilots; numerous aces from various nations flew the S.XIII during their flying careers. Following the signing of the Armistice of 11 November 1918, which effectively marked the end of the First World War, surplus S.XIIIs were sold in great numbers to both civil and military operators throughout the world.

Development

Background

The origins of the SPAD S.XIII lies in the performance of its predecessor, the SPAD S.VII, a single-seat fighter aircraft powered by a direct drive Hispano-Suiza 8A water-cooled V-8 engine and armed with a single synchronised Vickers machine gun. The type demonstrated excellent performance for the time, entering operational service with the French ''Aéronautique Militaire'' during August 1916.Bruce ''Air Enthusiast'' Fifteen, pp. 58–60. By early 1917, however, the S.VII had been surpassed by the latest German fighters such as the Albatros D.I.Andrews 1965, p. 4.

The emergence of increasingly capable German fighters, which soon resulted in a shift in aerial supremacy towards the Central Powers, led to calls for superior aircraft to be developed and procured.Andrews 1965, pp. 4-5. French flying ace Georges Guynemer personally lobbied for an improved version of the S.VII, telling the SPAD designer Louis Béchereau that "The 150 hp SPAD is not a match for the Halberstadt ... More speed is needed."Bruce ''Air International'' May 1976, p. 240. An initial and quick solution to the problem was to increase the compression ratio of the Hispano-Suiza engine, which increased its power to to provide for significantly improved performance, allowing the SPAD S.VII to remain competitive for the time being.Bruce ''Air Enthusiast'' Fifteen, pp. 61–62.

Spanish manufacturer Hispano-Suiza were already in the process of developing a more powerful geared version of the 8A engine, and this engine was unsurprisingly chosen by Béchereau to power two developed versions of the S.VII. The British S.E.5a and Sopwith Dolphin fighters would also be powered by the same engine.

Intro flight

The first of Béchereau's designs to fly with the new, gear-reduction HS.8B engine design series was the S.XII in its HS.8BeC (or "HS-38") version, which was armed with an unusual cannon that fired through the propeller shaft. However, this aircraft only saw limited use, having been rapidly followed into production by the more conventionally armed S.XIII, which was deemed to be a preferable configuration by several French pilots and officials.Bruce ''Air International'' May 1976, pp. 240–242. Aviation author C.F. Andrews has claimed that a large portion of the credit for the S.XIII lies with Marc Birkigt, the designer of the engine, who had chosen to introduce various innovative features upon it, such as monobloc aluminium cylinders, which were furnished with screwed-in steel liners, which improved its performance.Andrews 1965, p. 5.

On 4 April 1917, the SPAD S.XIII performed its maiden flight. An early distinguishing feature of the S.XIII - as with the SPAD S.XII - was that its similarly-geared HS.8Be V8 engine mandated a left-handed propeller rotating in the opposite rotation to the earlier, direct-drive HS.8A-powered S.VII. Early on, similarly to the British Sopwith Dolphin also powered with HS.8B-series geared V8s, problems were encountered with the HS.8B engine's gearing; however, Béchereau opted to persist with the engine, which was soon refined and became fairly reliable. Efforts to ramp up production of the type commenced almost immediately after the first flight was conducted. Within months of its first flight, the S.XIII had not only entered service with the ''Aéronautique Militaire'' but had quickly proven itself to be a successful fighter.

Design

The SPAD S.XIII was a single-engine biplane fighter aircraft. In terms of its construction, it shared a similar configuration and layout to the earlier S.VII, featuring a mainly wooden structure complete with a fabric covering;Andrews 1965, pp. 7–8. however, it was generally larger and heavier than its predecessor. Other changes included the tapered chord of its ailerons, the rounded tips of the tailplanes, bulkier cowling accommodating the gear-drive Hispano-Suiza 8B engine choice, and enlarged fin and rudder. The S.XIII was armed with a pair of forward-mounted Vickers machine guns with 400 rounds per gun, which took the place of the single gun that had been used on the earlier aircraft.Bruce ''Air International'' June 1976, p. 289.

The S.XIII featured relatively conventional construction, that being a wire-braced biplane with a box-shaped fuselage and a front-mounted engine, except for its interposed wing struts located half-way along the wing span, which gave the fighter the deceptive appearance of being a double-bay aircraft instead of a single bay. This change prevented the landing brace wires from whipping and chafing during flight, and was attributed by Andrews as a key factor for the aircraft's high rate of climb. Otherwise, it had an orthodox structure, comprising wooden members attached to metal joint fixtures.Andrews 1965, pp. 6–7. The fuselage consisted of four square-section longerons, complete with wooden struts and cross-members while braced with heavy-gauge piano wire; wire cable was instead used for the flying and landing wires.Andrews 1965, p. 7.

To facilitate its two-hour endurance, the S.XIII was furnished with an assortment of underbelly fuel tanks were held within the forward fuselage area; these were fed into the main service tank located in the center of the upper wing by an engine-driven pump.Andrews 1965, p. 8. Similar pumps were used for supplying pressurised oil and water circulation between the engine's radiator and a header tank in housed within the upper wing. The circular nose radiator incorporated vertical Venetian-style blinds as a means of regulating the temperature of the engine.

The upper wing was a single-piece structure, featuring hollow box-section short spars which connected with linen-bandaged scarf joints, Andrews claims that long runs of spruce were difficult to obtain. The ribs consisted of plywood webs and spruce capping strips, which were internally braced with piano wire. The upper wing was provisioned with ailerons, which were actuated by the pilot via a series of tubular pushrods which ran vertical directly beneath the ailerons, with external, 90º bellcranks exposed above the lower wing panels' top fabric covering. The lower wing consisted of spruce leading edges and wire-cable trailing edges, while the surfaces were fabric-covered and treated with aircraft dope to produce a scalloped effect, much as with the contemporary German Fokker D.VII that also used a wire trailing-edge component, along the trailing edges.

While the forward Vickers machine guns were installed as standard, they were not always present upon all aircraft. As a result of fears of a shortage of Vickers guns during the last few months of the war, several American squadrons equipped with the S.XIII decided to replace their existing Vickers .303 machine guns with the lighter (25 lbs/11.34 kg apiece) .30/06-calibre Marlin Rockwell M1917 and M1918 aircraft machine guns,Bruce ''Air International'' June 1976, p. 312.Maurer 1978, pp. 146–147. saving some sixteen pounds (7.3 kg) in weight over the twin-mount Vickers' total weight of 66 lbs (29.94 kg) for the guns alone. Reportedly, by the end of the war, roughly one half of the aircraft in American service had been converted in this fashion.

The powerplant of the S.XIII was a geared Hispano-Suiza engine, at first a 8Ba providing , but in later aircraft a high-compression 8Bc or 8Be delivering was often used.Bruce ''Air International'' June 1976, p. 292. The sum of these improvements was a notable improvement in flight and combat performance. It was faster than its main contemporaries, the British Sopwith Camel and the German Fokker D.VII and its relatively higher power-to-weight ratio gave it a good rate of climb. The SPAD was renowned for its speed and strength in a dive, although the maneuverability of the type was relatively poor and the aircraft was difficult to control at low speeds: needing to be landed with power on, unlike contemporary fighters like the Royal Aircraft Factory SE.5 which could be landed with power off.

While giving the Spad XIII outstanding performance, the geared engines proved to be unreliable, suffering from vibration and poor lubrication. This significantly and severely affected serviceability, with it being stated in November 1917 that the Spad S.XIII was "incapable of giving dependable service". Even in April 1918, an official report stated that two-thirds of the 200 hp SPADs were out of use at any one time due to engine problems.Bruce ''Air International'' June 1976, p. 291. At least one American observer believed at the time that the French were giving the US SPAD XIII squadrons lower-quality engines from their least favored manufacturers while keeping the best for themselves. Allegedly, the reliability issues encountered with the engine were considered an acceptable price to pay for the improved performance, however,Bruce ''Air International'' June 1976, p. 293. as time went by, a combination of improved build quality and changes to the engine design led to increased levels of serviceability.Bruce et al. 1969, p. 9.

At the beginning of 1918 the Aviation Militaire issued a requirement for a more powerful fighter, in a C1 (''Chasseur'' single-seat) specification. SPAD responded by fitting the Hispano-Suiza 8Fb in the SPAD XIII airframe. The structure was strengthened and improved aero-dynamically, retaining the dimensions of the SPAD XIII. Twenty SPAD XVII fighters were built and issued to units with GC 12 (''Les Cigones'').

Operational history

During May 1917, only one month following the type's maiden flight, deliveries to the commenced.Bruce ''Air International'' June 1976, p. 280. The new aircraft quickly became an important element in the French plans for its fighter force, being expected to replace the SPAD S.VII as well as the few remaining Nieuport fighters in front line service. However, these plans were disrupted by deliveries occurring at a much slower rate than had been initially forecast; by the end of March 1918, 764 fighters had been delivered compared with a planned force of 2,230.Bruce ''Air International'' June 1976, pp. 290–291.

Eventually, the S.XIII equipped virtually every French fighter squadron, 74 escadrilles, during the First World War.Bruce ''Air International'' June 1976, pp. 293–294. At the end of the war, plans were underway to replace the S.XIII with several fighter types powered by the Hispano-Suiza 8F, such as the Nieuport-Delage NiD 29, the SPAD S.XX and the Sopwith Dolphin II.Bruce ''Air International'' June 1976, p. 310. These plans lapsed following the signing of the Armistice of 11 November 1918, which ended the First World War and the SPAD S.XIII remained in French service as a fighter aircraft until 1923.

The S.XIII was flown by numerous famous French fighter pilots such as Rene Fonck (the highest scoring Allied ace, credited with 75 victories), Georges Guynemer (54 victories), and Charles Nungesser (45 victories), and also by the leading Italian ace Francesco Baracca (34 victories).Andrews 1965, pp. 8-10. Aces of the United States Army Air Service who flew the S.XIII include Eddie Rickenbacker (America's leading First World War ace with 26 confirmed victories) and Frank Luke (18 victories). Andrews attributes the S.XIII's natural stability, which lent itself to being a steady gun platform, as having been a key attribute for its success.Andrews 1965, p. 9.

USAAS

Other Allied forces were quick to adopt the new fighter as well; the SPAD XIII equipped 15 of the 16 operational American pursuit squadrons of the USAAS by the signing of the Armistice. Even prior to America's entry into the conflict, American volunteers flying with the Allies had been piloting the type.Andrews 1965, p. 10. Nearly half of the 893 purchased by the United States were still in service by 1920. In the United States, some S.XIIIs were re-engined with 180 hp Wright-Hispano engines to improve reliability and to prepare pilots for the new Thomas-Morse MB-3 fighter (which used SPAD-type wings in its construction) in 1922; according to Andrews, the Wright-Hispano engine was incapable of matching the performance of the original powerplant.

RFC

During December 1917, No 23 Squadron of the Royal Flying Corps (RFC) equipped with the SPAD S.XIII, retaining them until April 1918 when it re-equipped with the Dolphin, while No. 19 Squadron (officially equipped with the earlier S.VII) also operated at least a single S.XIII for a time.Bruce 1982, pp. 561–563. It was alleged by Andrews that the type was sometimes used as an interim fighter while awaiting the delivery of British-built aircraft.

In his memoir Sagittarius Rising, Cecil Lewis described an aerial competition between himself and a SPAD flown by Guynemer, while Lewis was flying an SE5, "Their speeds were almost identical, but the high-compression Spad climbed quicker. After the race was over, Guynemeyer and I held a demonstration combat over the aerodrome. Again I was badly worsted. Guynemeyer was all over me. In his hands the Spad was a marvel of flexibility. In the first minute I should have been shot down a dozen times".

Corpo Aeronautico Militare

The S.XIII was also acquired by Italy for the Corpo Aeronautico Militare. Andrews has claimed that Italian pilots expressed an overall preference for another French-built fighter, the Hanriot HD.1, which was more maneuverable but considerably less powerful in comparison. Belgium also operated the S.XIII; one Belgian ace, Edmond Thieffry, came to prominence while piloting the type. After the end of the war, the S.XIII was also exported to further nations, including Japan, Poland and Czechoslovakia.

Gallery

File:SPADXIIIguynemerweb.jpg, SPAD XIII Georges Guynemer
File:SPADXIIIrenéfonckweb.jpg, SPAD XIII René Fonck
File:SPADXIIIrickenbackerweb.jpg, SPAD XIII Edward Rickenbacker

HOME


Content is Copyleft
Website design, code, and AI is Copyrighted (c) 2014-2017 by Stephen Payne


Consider donating to Wikimedia



As an Amazon Associate I earn from qualifying purchases