|
Sheerness Boat Store
Shed Number 78, Sheerness Dockyard (also known as Boat Store Number 78 or simply Sheerness Boat Store) is a disused industrial building at Sheerness Dockyard, on the Isle of Sheppey in north Kent. The building was constructed at the Royal Navy Dockyard in Sheerness in 1856–60, as a store for small boats and a warehouse. It became a listed building in 1962, upgraded to Grade I in 1999, but it has been on the Heritage at Risk Register for many years. History The building was constructed for the Admiralty Works Department by Colonel Godfrey Thomas Green CB of the Royal Engineers (1807-1886) (formerly from the Bengal Sappers and Miners, and later Director of Admiralty Works), and William Scamp (1801-1872), with ironwork cast by Henry Grissell's Regent's Canal Ironworks. The design was based on slip covers at naval dockyards built during the 1830s and 1840s, for example the Grade I listed covered slips at Chatham Dockyard, but, unlike those buildings, it relies on the rigid ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sheerness Medway KC 7741
Sheerness () is a port town and civil parish beside the mouth of the River Medway on the north-west corner of the Isle of Sheppey in north Kent, England. With a population of 13,249, it is the second largest town on the island after the nearby town of Minster, Swale, Minster which has a population of 16,738. Sheerness began as a fort built in the 16th century to protect the River Medway from naval invasion. In 1665 plans were first laid by the Navy Board for Sheerness Dockyard, a facility where warships might be provisioned and repaired. The site was favoured by Samuel Pepys, then Clerk of the Acts of the navy, for shipbuilding over Chatham, Medway, Chatham inland. After the raid on the Medway in 1667, the older fortification was strengthened; in 1669 a Royal Navy dockyard was established in the town, where warships were stocked and repaired until its closure in 1960. Beginning with the construction of a pier and a promenade in the 19th century, Sheerness acquired the added at ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Iron Frame
The term iron frame describes the structural use of either cast iron or wrought iron in the columns and Beam (structure), beams of a building. While popular in the 19th century, the iron frame was displaced by the steel frame in the early 20th century. Cast iron Columns made of cast iron were introduced in the 1770s, the first building with multiple storeys using cast iron for both columns and beams is the Ditherington Flax Mill in Shrewsbury (1797). Columns were joined usually at the floor level and sometimes bolted together, the longer beams were made of sections that were also kept together by bolts. At first, the stiffness of the frame was achieved through the use of masonry that filled the openings in the frame, but since 1844, a ''rigid frame'' was used that was stable by itself (former fire station at the Portsmouth Dockyard). With its high compression strength, the cast iron is well-suited for columns. At first, the cruciform profile was used, later displaced by the hol ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Grade I Listed Buildings In Kent
The county of Kent is divided into 13 Districts of England, districts. The districts of Kent are Ashford (borough), Ashford, City of Canterbury, Canterbury, Dartford (borough), Dartford, Dover (district), Dover, Gravesham, Maidstone (borough), Maidstone, Medway, Tonbridge and Malling, Tunbridge Wells (borough), Tunbridge Wells, Sevenoaks (district), Sevenoaks, Folkestone and Hythe (District), Shepway, Borough of Swale, Swale and Thanet District, Thanet. As there are 435 Grade I listed buildings in the county they have been split into separate lists for each district. * Grade I listed buildings in Ashford (borough) * Grade I listed buildings in City of Canterbury * Grade I listed buildings in Dartford (borough) * Grade I listed buildings in Dover (district) * Grade I listed buildings in Folkestone and Hythe * Grade I listed buildings in Gravesham * Grade I listed buildings in Maidstone * Grade I listed buildings in Medway * Grade I listed buildings in Sevenoaks District * Grade ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Stairs
Stairs are a structure designed to bridge a large vertical direction, vertical distance between lower and higher levels by dividing it into smaller vertical distances. This is achieved as a diagonal series of horizontal platforms called steps which enable passage to the other level by Walking, stepping from one to another step in turn. Steps are very typically rectangular. Stairs may be straight, curved, or may consist of two or more straight pieces connected at angles. Types of stairs include staircases (also called stairways) and escalators. Some alternatives to stairs are elevators (also called lifts), stairlifts, inclined moving walkways, ladders, and ramps. A stairwell is a vertical shaft or opening that contains a staircase. A flight (of stairs) is an inclined part of a staircase consisting of steps (and their lateral supports if supports are separate from steps). History ''This is an excerpt from Staircase.'' The concept of stairs is believed to be 8000 years old, and is ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
I-beam
An I-beam is any of various structural members with an - (serif capital letter 'I') or H-shaped cross section (geometry), cross-section. Technical terms for similar items include H-beam, I-profile, universal column (UC), w-beam (for "wide flange"), universal beam (UB), rolled steel joist (RSJ), or double-T (especially in Polish language, Polish, Bulgarian language, Bulgarian, Spanish language, Spanish, Italian language, Italian, and German language, German). I-beams are typically made of structural steel and serve a wide variety of construction uses. The horizontal elements of the are called flanges, and the vertical element is known as the "web". The web resists shear forces, while the flanges resist most of the bending moment experienced by the beam. The Euler–Bernoulli beam equation shows that the -shaped section is a very efficient form for carrying both bending and shearing (physics), shear loads in the plane of the web. On the other hand, the cross-section has a reduced ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Corrugated Iron
Corrugated galvanised iron (CGI) or steel, colloquially corrugated iron (near universal), wriggly tin (taken from UK military slang), pailing (in Caribbean English), corrugated sheet metal (in North America), zinc (in Cyprus and Nigeria) or custom orb / corro sheet (Australia), is a building material composed of sheets of hot-dip galvanizing, hot-dip galvanised mild steel, cold forming, cold-rolled to produce a linear ridged pattern in them. Although it is still popularly called "iron" in the UK, the material used is actually steel (which is iron alloyed with carbon for strength, commonly 0.3% carbon), and only the surviving vintage sheets may actually be made up of 100% iron. The corrugations increase the bending strength of the sheet in the direction perpendicular to the corrugations, but not parallel to them, because the steel must be stretched to bend perpendicular to the corrugations. Normally each sheet is manufactured longer in its strong direction. CGI is lightweight ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Wrought Iron
Wrought iron is an iron alloy with a very low carbon content (less than 0.05%) in contrast to that of cast iron (2.1% to 4.5%), or 0.25 for low carbon "mild" steel. Wrought iron is manufactured by heating and melting high carbon cast iron in an open charcoal or coke hearth or furnace in a process known as puddling. The high temperatures cause the excess carbon to oxidise, the iron being stirred or puddled during the process in order to achieve this. As the carbon content reduces, the melting point of the iron increases, ultimately to a level which is higher than can be achieved by the hearth, hence the wrought iron is never fully molten and many impurities remain. The primary advantage of wrought iron over cast iron is its malleability - where cast iron is too brittle to bend or shape without breaking, wrought iron is highly malleable, and much easier to bend. Wrought iron is a semi-fused mass of iron with fibrous slag inclusions (up to 2% by weight), which give it ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Heritage At Risk
An annual ''Heritage at Risk Register'' is published by Historic England. The survey is used by national and local government, a wide range of individuals and heritage groups to establish the extent of risk and to help assess priorities for action and funding decisions. This heritage-at-risk data is one of the UK government's official statistics. ''Heritage at risk'' is term for cultural heritage assets that are at risk as a result of neglect, decay, or inappropriate development; or are vulnerable to becoming so. England's ''Heritage at Risk Register'' The ''Heritage at Risk Register'' covers: * Grade I and II* listed buildings (the baseline register is 1999); Grade II listed buildings in London only (the baseline register is 1991) * Structural scheduled monuments (base year is 1999) and scheduled monuments (base year is 2009) * Registered parks and gardens (base year is 2009) * Registered historic battlefields (base year is 2008) * Protected wreck sites * Conservation areas ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Victorian Society
The Victorian Society is a UK charity and amenity society that campaigns to preserve and promote interest in Victorian and Edwardian architecture and heritage built between 1837 and 1914 in England and Wales. As a statutory consultee, by law it must be notified of any work to a listed building which involves any element of demolition or structural alteration. Goals The society, a registered charity, fights to protect Victorian and Edwardian heritage from demolition or careless alteration. As a membership organisation, the majority of its funding comes from subscription fees and events. As one of the National Amenity Societies, The Victorian Society is a statutory consultee on alterations to listed buildings, and by law must be notified of any work to a listed building which involves any element of demolition. The society: * Provides advice to churches and local planning authorities on how Victorian and Edwardian buildings and landscapes can be adapted to modern use ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Historic England
Historic England (officially the Historic Buildings and Monuments Commission for England) is an executive non-departmental public body of the British Government sponsored by the Department for Culture, Media and Sport. It is tasked with protecting the historic environment of England by preserving and listing historic buildings, scheduling ancient monuments, registering historic parks and gardens, advising central and local government, and promoting the public's enjoyment of, and advancing their knowledge of, ancient monuments and historic buildings. History The body was created by the National Heritage Act 1983, and operated from April 1984 to April 2015 under the name of English Heritage. In 2015, following the changes to English Heritage's structure that moved the protection of the National Heritage Collection into the voluntary sector in the English Heritage Trust, the body that remained was rebranded as Historic England. The body also inherited the Historic Engla ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Skyscraper
A skyscraper is a tall continuously habitable building having multiple floors. Most modern sources define skyscrapers as being at least or in height, though there is no universally accepted definition, other than being very tall high-rise buildings. Skyscrapers may host offices, hotels, residential spaces, and retail spaces. One common feature of skyscrapers is having a steel frame that supports curtain walls. These curtain walls either bear on the framework below or are suspended from the framework above, rather than resting on load-bearing walls of conventional construction. Some early skyscrapers have a steel frame that enables the construction of load-bearing walls taller than those made of reinforced concrete. Modern skyscraper walls are not load-bearing, and most skyscrapers are characterized by large surface areas of windows made possible by steel frames and curtain walls. However, skyscrapers can have curtain walls that mimic conventional walls with a small surfa ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
South Kensington Museum
South is one of the cardinal directions or compass points. The direction is the opposite of north and is perpendicular to both west and east. Etymology The word ''south'' comes from Old English ''sūþ'', from earlier Proto-Germanic ''*sunþaz'' ("south"), possibly related to the same Proto-Indo-European root that the word ''sun'' derived from. Some languages describe south in the same way, from the fact that it is the direction of the sun at noon (in the Northern Hemisphere), like Latin meridies 'noon, south' (from medius 'middle' + dies 'day', ), while others describe south as the right-hand side of the rising sun, like Biblical Hebrew תֵּימָן teiman 'south' from יָמִין yamin 'right', Aramaic תַּימנַא taymna from יָמִין yamin 'right' and Syriac ܬܰܝܡܢܳܐ taymna from ܝܰܡܝܺܢܳܐ yamina (hence the name of Yemen, the land to the south/right of the Levant). South is sometimes abbreviated as S. Navigation By convention, the ''bottom or down-f ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
