|
Saturn IB-B
The proposed Saturn IB-B was to be essentially an uprated Saturn IB using the new MS-IVB-2 upper stage A multistage rocket or step rocket is a launch vehicle that uses two or more rocket ''stages'', each of which contains its own engines and propellant. A ''tandem'' or ''serial'' stage is mounted on top of another stage; a ''parallel'' stage ..., using the HG-3 engine, developed from the S-IVB and an uprated S-IB-A first stage. External links astronautix.com IB-B {{Rocketry-stub ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Saturn IB
The Saturn IB (also known as the uprated Saturn I) was an American launch vehicle commissioned by the National Aeronautics and Space Administration (NASA) for the Apollo program. It uprated the Saturn I by replacing the S-IV second stage (, 43,380,000 lb-sec total impulse), with the S-IVB (, 96,000,000 lb-sec total impulse). The S-IB first stage also increased the S-I baseline's thrust from to and propellant load by 3.1%. This increased the Saturn I's low Earth orbit payload capability from to , enough for early flight tests of a half-fueled Apollo command and service module (CSM) or a fully fueled Apollo Lunar Module (LM), before the larger Saturn V needed for lunar flight was ready. By sharing the S-IVB upper stage, the Saturn IB and Saturn V provided a common interface to the Apollo spacecraft. The only major difference was that the S-IVB on the Saturn V burned only part of its propellant to achieve Earth orbit, so it could be restarted for trans-lunar injectio ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Upper Stage
A multistage rocket or step rocket is a launch vehicle that uses two or more rocket ''stages'', each of which contains its own engines and propellant. A ''tandem'' or ''serial'' stage is mounted on top of another stage; a ''parallel'' stage is attached alongside another stage. The result is effectively two or more rockets stacked on top of or attached next to each other. Two-stage rockets are quite common, but rockets with as many as five separate stages have been successfully launched. By jettisoning stages when they run out of propellant, the mass of the remaining rocket is decreased. Each successive stage can also be optimized for its specific operating conditions, such as decreased atmospheric pressure at higher altitudes. This ''staging'' allows the thrust of the remaining stages to more easily accelerate the rocket to its final speed and height. In serial or tandem staging schemes, the first stage is at the bottom and is usually the largest, the second stage and subs ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
HG-3 (rocket Engine)
The HG-3 was a liquid-fuel cryogenic rocket engine which was designed for use on the upper stages of Saturn rockets in the post-Apollo era. Designed in the United States by Rocketdyne, the HG-3 was to have burned cryogenic liquid hydrogen and liquid oxygen propellants, with each engine producing of thrust during flight. The engine was designed to produce a specific impulse (''I''sp) of in a vacuum, or at sea level. Developed from Rocketdyne's J-2 engine used on the S-II and S-IVB stages, the engine was intended to replace the J-2 on the upgraded S-II-2 and S-IVB-2 stages intended for use on the Saturn MLV, Saturn IB-B and Saturn V/4-260 rockets, with a sea-level optimised version, the HG-3-SL, intended for use on the Saturn INT-17. The engine was cancelled, however, during the post-Apollo drawdown when development of the more advanced Saturn rockets ceased, and never flew, although the engine was later used as the basis for the design of the RS-25 The Aerojet Rocketdyne ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
