|
PPPoE
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for Encapsulation (networking), encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling protocol, tunneling network packet, packets over the DSL connection to the ISP's Internet Protocol, IP network, and from there to the rest of the Internet. A 2005 networking book noted that "Most DSL providers use PPPoE, which provides authentication, encryption, and Data compression, compression." Typical use of PPPoE involves leveraging the PPP facilities for authenticating the user with a username and password, via the Password Authentication Protocol, PAP protocol or via Challenge-Handshake Authentication Protocol, CHAP. PAP was dominant in 2007 but service providers have been transitioning to the more secure CHAP, because PAP is a plain-text protocol. Around 2000, PPPoE was also starting to become a replacement meth ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Point-to-Point Protocol
In computer networking, Point-to-Point Protocol (PPP) is a data link layer (layer 2) communication protocol between two routers directly without any host or any other networking in between. It can provide loop detection, authentication, transmission encryption, and data compression. PPP is used over many types of physical networks, including serial cable, phone line, Trunking#Trunk line, trunk line, cellular telephone, specialized radio links, ISDN, and Fiber-optic communication, fiber optic links such as SONET. Since IP packets cannot be transmitted over a modem line on their own without some data link protocol that can identify where the transmitted frame starts and where it ends, Internet service providers (ISPs) have used PPP for customer dial-up access to the Internet. PPP is used on former dial-up networking lines. Two derivatives of PPP, Point-to-Point Protocol over Ethernet (PPPoE) and Point-to-Point Protocol over ATM (PPPoA), are used most commonly by ISPs to establish a d ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Password Authentication Protocol
Password Authentication Protocol (PAP) is a password-based authentication protocol used by Point-to-Point Protocol (PPP) to validate users. PAP is specified in . Almost all network operating systems support PPP with PAP, as do most network access servers. PAP is also used in PPPoE, for authenticating DSL users. As the Point-to-Point Protocol (PPP) sends data unencrypted and "in the clear", PAP is vulnerable to any attacker who can observe the PPP session. An attacker can see the users name, password, and any other information associated with the PPP session. Some additional security can be gained on the PPP link by using CHAP or EAP. However, there are always tradeoffs when choosing an authentication method, and there is no single answer for which is more secure. When PAP is used in PPP, it is considered a weak authentication scheme. Weak schemes are simpler and have lighter computational overhead than more complex schemes, such as Transport Layer Security (TLS), but they are mu ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Challenge-Handshake Authentication Protocol
In computing, the Challenge-Handshake Authentication Protocol (CHAP) is an authentication protocol originally used by Point-to-Point Protocol (PPP) to validate users. CHAP is also carried in other authentication protocols such as RADIUS and Diameter (protocol), Diameter. Almost all network operating systems support PPP with CHAP, as do most network access servers. CHAP is also used in PPPoE, for authenticating DSL users. As the PPP sends data unencrypted and "in the clear", CHAP is vulnerable to any attacker who can observe the PPP session. An attacker can see the user's name, CHAP challenge, CHAP response, and any other information associated with the PPP session. The attacker can then mount an offline dictionary attack in order to obtain the original password. When used in PPP, CHAP also provides protection against replay attacks by the peer through the use of a challenge which is generated by the authenticator, which is typically a network access server. Where CHAP is used in ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Tunneling Protocol
In computer networks, a tunneling protocol is a communication protocol which allows for the movement of data from one network to another. They can, for example, allow private network communications to be sent across a public network (such as the Internet), or for one network protocol to be carried over an incompatible network, through a process called encapsulation. Because tunneling involves repackaging the traffic data into a different form, perhaps with encryption as standard, it can hide the nature of the traffic that is run through a tunnel. Tunneling protocols work by using the data portion of a packet (the payload) to carry the packets that actually provide the service. Tunneling uses a layered protocol model such as those of the OSI or TCP/IP protocol suite, but usually violates the layering when using the payload to carry a service not normally provided by the network. Typically, the delivery protocol operates at an equal or higher level in the layered model than the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Residential Gateway
A residential gateway is a small consumer-grade gateway which bridges network access between connected local area network (LAN) hosts to a wide area network (WAN) (such as the Internet) via a modem, or directly connects to a WAN (as in EttH), while routing. The WAN is a larger computer network, generally operated by an Internet service provider. History The term residential gateway was popularized by Clifford Holliday in 1997 through his paper entitled "The residential gateway". Devices Multiple devices have been described as ''residential gateways'': * Cable modem * DSL modem * FTTx modem * IP-DECT telephone (base station) * Network switch * Smart home hub * TV/ VoD set-top box * Voice over Internet protocol (VoIP) analog telephone adapter * Wired router * Wireless access point * Wireless router A modem (e.g. DSL modem, cable modem) by itself provides none of the functions of a router. It merely allows ATM or PPP or PPPoE traffic to be transmitted acro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IP Routing
IP routing is the application of traffic routing methodologies to IP networks. This involves technologies, protocols, structure, administrations, and policies of the worldwide Internet infrastructure. In each IP network node, IP routing involves the determination of a suitable path for a network packet from a source to its destination. The process uses rules, obtained from either static configuration or dynamically with routing protocols, to select specific packet forwarding methods to direct traffic to the next available intermediate network node one ''hop'' closer to the desired final destination. The total path potentially spans multiple computer networks. Networks are separated from each other by specialized hosts, called gateways or routers with specialized software support optimized for routing. IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Ethernet
Ethernet ( ) is a family of wired computer networking technologies commonly used in local area networks (LAN), metropolitan area networks (MAN) and wide area networks (WAN). It was commercially introduced in 1980 and first standardized in 1983 as IEEE 802.3. Ethernet has since been refined to support higher bit rates, a greater number of nodes, and longer link distances, but retains much backward compatibility. Over time, Ethernet has largely replaced competing wired LAN technologies such as Token Ring, FDDI and ARCNET. The original 10BASE5 Ethernet uses a thick coaxial cable as a shared medium. This was largely superseded by 10BASE2, which used a thinner and more flexible cable that was both less expensive and easier to use. More modern Ethernet variants use Ethernet over twisted pair, twisted pair and fiber optic links in conjunction with Network switch, switches. Over the course of its history, Ethernet data transfer rates have been increased from the original to the lates ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Router (computing)
A router is a computer and networking device that Packet forwarding, forwards data packets between computer networks, including internetworks such as the global Internet. Routers perform the "traffic directing" functions on the Internet. A router is connected to two or more data lines from different IP networks. When a data packet comes in on a line, the router reads the network address information in the packet header to determine the ultimate destination. Then, using information in its routing table or routing policy, it directs the packet to the next network on its journey. Data packets are forwarded from one router to another through an internetwork until it reaches its destination Node (networking), node. The most familiar type of Internet Protocol, IP routers are Residential gateway, home and small office routers that forward IP packet (other), IP packets between the home computers and the Internet. More sophisticated routers, such as enterprise routers, conne ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Customer-premises Equipment
In telecommunications, a customer-premises equipment or customer-provided equipment (CPE) is any terminal and associated equipment located at a subscriber's premises and connected with a carrier's telecommunication circuit at the demarcation point ("demarc"). The demarc is a point established in a building or complex to separate customer equipment from the equipment located in either the distribution infrastructure or central office of the communications service provider. CPE generally refers to devices such as telephones, routers, network switches, residential gateways (RG), set-top boxes, fixed mobile convergence products, home networking adapters and Internet access gateways that enable consumers to access providers' communication services and distribute them in a residence or enterprise with a local area network (LAN). A CPE can be an active equipment, as the ones mentioned above, or passive equipment such as analog telephone adapters (ATA) or xDSL-splitters. This i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Protocol Stack
The protocol stack or network stack is an implementation of a computer networking protocol suite or protocol family. Some of these terms are used interchangeably but strictly speaking, the ''suite'' is the definition of the communication protocols, and the ''stack'' is the software implementation of them. Individual protocols within a suite are often designed with a single purpose in mind. This modularization simplifies design and evaluation. Because each protocol module usually communicates with two others, they are commonly imagined as layers in a stack of protocols. The lowest protocol always deals with low-level interaction with the communications hardware. Each higher layer adds additional capabilities. User applications usually deal only with the topmost layers. General protocol suite description T ~ ~ ~ T ____ Imagine three computers: ''A'', ''B'', and ''C''. ''A'' and ''B'' both have radio equipment and can communicate via the airwaves using a suitable net ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Data Compression
In information theory, data compression, source coding, or bit-rate reduction is the process of encoding information using fewer bits than the original representation. Any particular compression is either lossy or lossless. Lossless compression reduces bits by identifying and eliminating statistical redundancy. No information is lost in lossless compression. Lossy compression reduces bits by removing unnecessary or less important information. Typically, a device that performs data compression is referred to as an encoder, and one that performs the reversal of the process (decompression) as a decoder. The process of reducing the size of a data file is often referred to as data compression. In the context of data transmission, it is called source coding: encoding is done at the source of the data before it is stored or transmitted. Source coding should not be confused with channel coding, for error detection and correction or line coding, the means for mapping data onto a sig ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
DSL Modem
A digital subscriber line (DSL) modem is a device used to connect a computer or Router (computing), router to a telephone line which provides the digital subscriber line (DSL) service for connection to the Internet, which is often called ''DSL broadband''. The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a Router (computing), router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point. Also called a residential gateway, a DSL router usually manages the connection and sharing of the DSL service in a home or small office network. Different DSL routers and modems support different DSL technology variants: VDSL, Symmetric digital subscriber line, SDSL, and ADSL. Description A DSL router consists of a box with an RJ11 jack to connect to a standard subscriber ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
