|
Multicast-Broadcast Single Frequency Network
Multimedia Broadcast multicast service Single Frequency Network (MBSFN) is a Channel (communications), communication channel defined in the 4G, fourth-generation cellular networking standard called 3GPP Long-Term Evolution, Long-Term Evolution (LTE). The transmission mode is intended as a further improvement of the efficiency of the MBMS, enhanced Multimedia Broadcast Multicast Service (eMBMS) service, which can deliver services such as mobile TV using the LTE infrastructure, and is expected to MBMS#Competing technologies, compete with dedicated mobile/handheld TV broadcast systems such as DVB-H and DVB-SH. This enables network operators to offer mobile TV without the need for additional expensive licensed spectrum and without requiring new infrastructure and end-user devices. The eMBMS service can offer many more TV programs in a specific radio frequency spectrum as compared to traditional terrestrial TV broadcasting, since it is based on the principles of Interactive Multicast, w ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Channel (communications)
A communication channel refers either to a physical transmission medium such as a wire, or to a logical connection over a multiplexed medium such as a radio channel in telecommunications and computer networking. A channel is used for information transfer of, for example, a digital bit stream, from one or several '' senders'' to one or several '' receivers''. A channel has a certain capacity for transmitting information, often measured by its bandwidth in Hz or its data rate in bits per second. Communicating an information signal across distance requires some form of pathway or medium. These pathways, called communication channels, use two types of media: Transmission line-based telecommunications cable (e.g. twisted-pair, coaxial, and fiber-optic cable) and broadcast (e.g. microwave, satellite, radio, and infrared). In information theory, a channel refers to a theoretical ''channel model'' with certain error characteristics. In this more general view, a storage d ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Multicast
In computer networking, multicast is a type of group communication where data transmission is addressed to a group of destination computers simultaneously. Multicast can be one-to-many or many-to-many distribution. Multicast differs from physical layer point-to-multipoint communication. Group communication may either be application layer multicast or network-assisted multicast, where the latter makes it possible for the source to efficiently send to the group in a single transmission. Copies are automatically created in other network elements, such as routers, switches and cellular network base stations, but only to network segments that currently contain members of the group. Network assisted multicast may be implemented at the data link layer using one-to-many addressing and switching such as Ethernet multicast addressing, Asynchronous Transfer Mode (ATM), point-to-multipoint virtual circuits (P2MP) or InfiniBand multicast. Network-assisted multicast may also be im ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Information Theory
Information theory is the mathematical study of the quantification (science), quantification, Data storage, storage, and telecommunications, communication of information. The field was established and formalized by Claude Shannon in the 1940s, though early contributions were made in the 1920s through the works of Harry Nyquist and Ralph Hartley. It is at the intersection of electronic engineering, mathematics, statistics, computer science, Neuroscience, neurobiology, physics, and electrical engineering. A key measure in information theory is information entropy, entropy. Entropy quantifies the amount of uncertainty involved in the value of a random variable or the outcome of a random process. For example, identifying the outcome of a Fair coin, fair coin flip (which has two equally likely outcomes) provides less information (lower entropy, less uncertainty) than identifying the outcome from a roll of a dice, die (which has six equally likely outcomes). Some other important measu ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
3GPP Standards
The 3rd Generation Partnership Project (3GPP) is an umbrella term for a number of standards organizations which develop protocols for mobile telecommunications. Its best known work is the development and maintenance of: * GSM and related 2G and 2.5G standards, including GPRS and EDGE * UMTS and related 3G standards, including HSPA and HSPA+ * LTE and related 4G standards, including LTE Advanced and LTE Advanced Pro * 5G NR and related 5G standards, including 5G-Advanced * An evolved IP Multimedia Subsystem (IMS) developed in an access independent manner 3GPP is a consortium with seven national or regional telecommunication standards organizations as primary members ("organizational partners") and a variety of other organizations as associate members ("market representation partners"). The 3GPP organizes its work into three different streams: Radio Access Networks, Services and Systems Aspects, and Core Network and Terminals. The project was established in Decembe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Wireless Networking
A wireless network is a computer network that uses wireless data connections between network nodes. Wireless networking allows homes, telecommunications networks, and business installations to avoid the costly process of introducing cables into a building, or as a connection between various equipment locations. Admin telecommunications networks are generally implemented and administered using radio communication. This implementation takes place at the physical level (layer) of the OSI model network structure. Examples of wireless networks include cell phone networks, wireless local area networks (WLANs), wireless sensor networks, satellite communication networks, and terrestrial microwave networks. History Wireless networks The first professional wireless network was developed under the brand ALOHAnet in 1969 at the University of Hawaii and became operational in June 1971. The first commercial wireless network was the WaveLAN product family, developed by NCR in 198 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Signal-to-interference Ratio
The signal-to-interference ratio (SIR or ''S/I''), also known as the carrier-to-interference ratio (CIR or ''C/I''), is the quotient between the average received modulated carrier power ''S'' or ''C'' and the average received co-channel interference power ''I'', i.e. crosstalk, from other transmitters than the useful signal. The CIR resembles the carrier-to-noise ratio (CNR or ''C/N''), which is the signal-to-noise ratio (SNR or ''S/N'') of a modulated signal before demodulation. A distinction is that interfering radio transmitters contributing to ''I'' may be controlled by radio resource management, while ''N'' involves noise power from other sources, typically additive white Gaussian noise (AWGN). Carrier-to-noise-and-interference ratio (CNIR) The CIR ratio is studied in interference limited systems, i.e. where ''I'' dominates over ''N'', typically in cellular radio systems and broadcasting systems where frequency channels are reused in view to achieve high level of area cover ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Intersymbol Interference
In telecommunications, intersymbol interference (ISI) is a form of distortion of a signal in which one symbol interferes with subsequent symbols. This is an unwanted phenomenon as the previous symbols have a similar effect as noise, thus making the communication less reliable. The spreading of the pulse beyond its allotted time interval causes it to interfere with neighboring pulses. ISI is usually caused by multipath propagation or the inherent linear or non-linear frequency response of a communication channel causing successive symbols to blur together. The presence of ISI in the system introduces errors in the decision device at the receiver output. Therefore, in the design of the transmitting and receiving filters, the objective is to minimize the effects of ISI, and thereby deliver the digital data to its destination with the smallest error rate possible. Ways to alleviate intersymbol interference include adaptive equalization and error correcting codes. Causes Multip ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cyclic Prefix
In telecommunications, the term cyclic prefix refers to the prefixing of a symbol with a repetition of the end. The receiver is typically configured to discard the cyclic prefix samples, but the cyclic prefix serves two purposes: * It provides a guard interval to eliminate intersymbol interference from the previous symbol. * It repeats the end of the symbol so the linear convolution of a frequency-selective multipath channel can be modeled as circular convolution, which in turn may transform to the frequency domain via a discrete Fourier transform. This approach accommodates simple frequency domain processing, such as channel estimation and equalization. For the cyclic prefix to serve its objectives, it must have a length at least equal to the length of the multipath channel. The concept of a cyclic prefix is traditionally associated with OFDM systems, however the cyclic prefix is now also used in single carrier systems to improve the robustness to multipath propagation. Princ ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single-frequency Network
A single-frequency network or SFN is a broadcast network where several transmitters simultaneously send the same signal over the same frequency channel. Analog AM and FM radio broadcast networks as well as digital broadcast networks can operate in this manner. SFNs are not generally compatible with analog television transmission, since the SFN results in ghosting due to echoes of the same signal. A simplified form of SFN can be achieved by a low power co-channel repeater, booster or broadcast translator, which is utilized as a gap filler transmitter. The aim of SFNs is efficient utilization of the radio spectrum, allowing a higher number of radio and TV programs in comparison to traditional multi-frequency network (MFN) transmission. An SFN may also increase the coverage area and decrease the outage probability in comparison to an MFN, since the total received signal strength may increase to positions midway between the transmitters. SFN schemes are somewhat analogous to w ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OFDM
In telecommunications, orthogonal frequency-division multiplexing (OFDM) is a type of digital transmission used in digital modulation for encoding digital (binary) data on multiple carrier frequencies. OFDM has developed into a popular scheme for wideband digital communication, used in applications such as digital television and audio broadcasting, DSL internet access, wireless networks, power line networks, and 4G/ 5G mobile communications. OFDM is a frequency-division multiplexing (FDM) scheme that was introduced by Robert W. Chang of Bell Labs in 1966. In OFDM, the incoming bitstream representing the data to be sent is divided into multiple streams. Multiple closely spaced orthogonal subcarrier signals with overlapping spectra are transmitted, with each carrier modulated with bits from the incoming stream so multiple bits are being transmitted in parallel. [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
User Equipment
In the Universal Mobile Telecommunications System (UMTS) and 3GPP Long Term Evolution (LTE), user equipment (UE) is any device used directly by an end-user to communicate. It can be a hand-held telephone, a laptop computer equipped with a mobile broadband adapter, or any other device. It connects to the base station Node B/eNodeB as specified in the ETSI 125/136-series and 3GPP 25/36-series of specifications. It roughly corresponds to the mobile station (MS) in GSM systems. The radio interface between the UE and the Node B is called ''Uu''. In the context of UMTS (Universal Mobile Telecommunications System), Uu stands for the interface between UTRAN (UMTS Terrestrial Radio Access Network) and the UE (User Equipment). Functionality UE handles the following tasks towards the core network: * Mobility management Mobility management is one of the major functions of a GSM or a UMTS network that allows mobile phones to work. The aim of mobility management is to track where the s ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Node B
{{Unreferenced, date=May 2019, bot=noref (GreenC bot) Node B is the telecommunications node for mobile communication networks, namely those that adhere to the UMTS standard. The Node B provides the connection between mobile phones (User equipment, UEs) and the wider telephone network. UMTS is the dominating 3G standard. Node B corresponds to BTS (base transceiver station) in GSM. Functionality This is the hardware that is connected to the mobile phone network that communicates directly with mobile handsets. In contrast with GSM base stations, Node B uses WCDMA/TD-SCDMA as the air interface technology. As in all cellular systems, such as UMTS and GSM, the Node B contains radio frequency transmitter(s) and the receiver(s) used to communicate directly with mobile devices, which move freely around it. In this type of cellular network, the mobile devices cannot communicate directly with each other but have to communicate with the NodeB. Traditionally, the Node Bs have minimum func ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
