|
IEEE 802.1aq
IEEE 802.1aq is an amendment to the IEEE 802.1Q networking standard which adds support for Shortest Path Bridging (SPB). This technology is intended to simplify the creation and configuration of Ethernet networks while enabling multipath routing. SPB is designed to replace the older Spanning Tree Protocols: IEEE 802.1D STP, IEEE 802.1w RSTP, and IEEE 802.1s MSTP. These block any redundant paths that can result in a switching loop, whereas SPB allows all paths to be active with multiple equal-cost paths, provides much larger topologies, supports faster convergence times, and improves the efficiency by allowing traffic to load share across all paths of a mesh network. It is designed to preserve the plug-and-play nature that established Ethernet as the de facto protocol at layer 2. The technology provides VLANs on native Ethernet infrastructures using a link-state protocol to advertise both topology and VLAN membership. Packets are encapsulated at the edge either ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IEEE 802
IEEE 802 is a family of Institute of Electrical and Electronics Engineers (IEEE) standards for local area networks (LANs), personal area networks (PANs), and metropolitan area networks (MANs). The IEEE 802 LAN/MAN Standards Committee (LMSC) maintains these standards. The IEEE 802 family of standards has had twenty-four members, numbered 802.1 through 802.24, with a working group of the LMSC devoted to each. However, not all of these working groups are currently active. The IEEE 802 standards are restricted to computer networks carrying variable-size packets, unlike cell relay networks, for example, in which data is transmitted in short, uniformly sized units called cells. Isochronous signal networks, in which data is transmitted as a steady stream of octet (computing), octets, or groups of octets, at regular time intervals, are also outside the scope of the IEEE 802 standards. The number 802 has no significance: it was simply the next number in the sequence that the IEEE used fo ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Software-defined Networking
Software-defined networking (SDN) is an approach to network management that uses abstraction to enable dynamic and programmatically efficient network configuration to create grouping and segmentation while improving network performance and monitoring in a manner more akin to cloud computing than to traditional network management. SDN is meant to improve the static architecture of traditional networks and may be employed to centralize network intelligence in one network component by disassociating the forwarding process of network packets ( data plane) from the routing process ( control plane). The control plane consists of one or more controllers, which are considered the brains of the SDN network, where the whole intelligence is incorporated. However, centralization has certain drawbacks related to security, scalability and elasticity. SDN was commonly associated with the OpenFlow protocol for remote communication with network plane elements to determine the path of network pac ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Link State Routing
Link-state routing protocols are one of the two main classes of routing protocols used in packet switching networks for computer communications, the others being distance-vector routing protocols. Examples of link-state routing protocols include Open Shortest Path First (OSPF) and Intermediate System to Intermediate System (IS-IS). The link-state protocol is performed by every ''switching node'' in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). The basic concept of link-state routing is that every node constructs a ''map'' of the connectivity to the network in the form of a graph, showing which nodes are connected to which other nodes. Each node then independently calculates the next best logical ''path'' from it to every possible destination in the network. Each collection of best paths will then form each node's routing table. This contrasts with distance-vector routing protocols, which work by having each node shar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IP Multicast
IP multicast is a method of sending Internet Protocol (IP) datagrams to a group of interested receivers in a single transmission. It is the IP-specific form of multicast and is used for streaming media and other network applications. It uses specially reserved multicast address blocks in IPv4 and IPv6. Protocols associated with IP multicast include Internet Group Management Protocol, Protocol Independent Multicast and Multicast VLAN Registration. IGMP snooping is used to manage IP multicast traffic on layer-2 networks. IP multicast is described in . IP multicast was first standardized in 1986. Its specifications have been augmented in to include group management and in to include administratively scoped addresses. Technical description IP multicast is a technique for one-to-many and many-to-many real-time communication over an IP infrastructure in a network. It scales to a larger receiver population by requiring neither prior knowledge of a receiver's identity nor prior k ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Equal-cost Multi-path Routing
Equal-cost multi-path routing (ECMP) is a routing strategy where packet forwarding to a single destination can occur over multiple best paths with equal routing priority. Multi-path routing can be used in conjunction with most routing protocols because it is a per-hop local decision made independently at each router. It can substantially increase bandwidth by load-balancing traffic over multiple paths; however, there may be significant problems in deploying it in practice. History Load balancing by per-packet multipath routing was generally disfavored due to the impact of rapidly changing latency, packet reordering and maximum transmission unit (MTU) differences within a network flow, which could disrupt the operation of many Internet protocols, most notably TCP and path MTU discovery. RFC 2992 analyzed one particular multipath routing strategy involving the assignment of flows through hashing flow-related data in the packet header. This solution is designed to avoid these p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
OSPF
Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS). OSPF gathers link state information from available routers and constructs a topology map of the network. The topology is presented as a routing table to the internet layer for routing packets by their destination IP address. OSPF supports Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) networks and is widely used in large enterprise networks. IS-IS, another LSR-based protocol, is more common in large service provider networks. Originally designed in the 1980s, OSPF version 2 is defined in RFC 2328 (1998). The updates for IPv6 are specified as OSPF version 3 in RFC 5340 (2008). OSPF supports the Classless Inter-Domain Routing (CIDR) addressing model. Concepts OSPF is an interior gateway protocol (IGP ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IPv6
Internet Protocol version 6 (IPv6) is the most recent version of the Internet Protocol (IP), the communication protocol, communications protocol that provides an identification and location system for computers on networks and routes traffic across the Internet. IPv6 was developed by the Internet Engineering Task Force (IETF) to deal with the long-anticipated problem of IPv4 address exhaustion, and was intended to replace IPv4. In December 1998, IPv6 became a Draft Standard for the IETF, which subsequently ratified it as an Internet Standard on 14 July 2017. Devices on the Internet are assigned a unique IP address for identification and location definition. With the rapid growth of the Internet after commercialization in the 1990s, it became evident that far more addresses would be needed to connect devices than the 4,294,967,296 (232) IPv4 address space had available. By 1998, the IETF had formalized the successor protocol, IPv6 which uses 128-bit addresses, theoretically all ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IPv4
Internet Protocol version 4 (IPv4) is the first version of the Internet Protocol (IP) as a standalone specification. It is one of the core protocols of standards-based internetworking methods in the Internet and other packet-switched networks. IPv4 was the first version deployed for production on SATNET in 1982 and on the ARPANET in January 1983. It is still used to route most Internet traffic today, even with the ongoing deployment of Internet Protocol version 6 (IPv6), its successor. IPv4 uses a 32-bit address space which provides 4,294,967,296 (232) unique addresses, but large blocks are reserved for special networking purposes. Purpose The Internet Protocol ("IP") is the protocol that defines and enables internetworking at the internet layer of the Internet Protocol Suite. It gives the Internet a global-scale logical addressing system which allows the routing of IP Network packet, data packets from a source host to the next router that is one Hop (networking), hop closer t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network-layer Protocols
In the seven-layer OSI model of computer networking, the network layer is layer 3. The network layer is responsible for packet forwarding including routing through intermediate routers. Functions The network layer provides the means of transferring variable-length network packets from a source to a destination host via one or more networks. Within the service layering semantics of the OSI (Open Systems Interconnection) network architecture, the network layer responds to service requests from the transport layer and issues service requests to the data link layer. Functions of the network layer include: ; Connectionless communication : For example, Internet Protocol is connectionless, in that a data packet can travel from a sender to a recipient without the recipient having to send an acknowledgement. Connection-oriented protocols exist at other, higher layers of the OSI model. ; Host addressing :Every host in the network must have a unique address that determines where it is. Th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
