|
Serial SCSI
A SCSI connector ( ) is used to connect computer parts that use a system called SCSI to communicate with each other. Generally, two connectors, designated male and female, plug together to form a connection which allows two components, such as a computer and a disk drive, to communicate with each other. SCSI connectors can be electrical connectors or optical connectors. There have been a large variety of SCSI connectors in use at one time or another in the computer industry. Twenty-five years of evolution and three major revisions of the standards resulted in requirements for Parallel SCSI connectors that could handle an 8, 16 or 32 bit wide bus running at 5, 10 or 20 megatransfer/s, with conventional or differential signaling. Serial SCSI added another three transport types, each with one or more connector types. Manufacturers have frequently chosen connectors based on factors of size, cost, or convenience at the expense of compatibility. SCSI makes use of cables to connect ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
SCSI
Small Computer System Interface (SCSI, ) is a set of standards for physically connecting and transferring data between computers and peripheral devices. The SCSI standards define commands, protocols, electrical, optical and logical interfaces. The SCSI standard defines command sets for specific peripheral device types; the presence of "unknown" as one of these types means that in theory it can be used as an interface to almost any device, but the standard is highly pragmatic and addressed toward commercial requirements. The initial Parallel SCSI was most commonly used for hard disk drives and tape drives, but it can connect a wide range of other devices, including scanners and CD drives, although not all controllers can handle all devices. The ancestral SCSI standard, X3.131-1986, generally referred to as SCSI-1, was published by the X3T9 technical committee of the American National Standards Institute (ANSI) in 1986. SCSI-2 was published in August 1990 as X3.T9.2/86-109 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Insulation-displacement Connector
An insulation-displacement contact (IDC), also known as insulation-piercing contact (IPC), is an electrical connector designed to be connected to the conductor(s) of an insulated cable by a connection process which forces a selectively sharpened blade or blades through the insulation, bypassing the need to strip the conductors of insulation before connecting. When properly made, the connector blade cold-welds to the conductor, making a theoretically reliable gas-tight connection. History Modern IDC technology developed after and was influenced by research on wire-wrap and crimp connector technology originally pioneered by Western Electric, Bell Telephone Labs, and others. Although originally designed to connect only solid (single-stranded) conductors, IDC technology was eventually extended to multiple- stranded wire as well. Initially, IDCs were seen only in extra-low voltage applications, such as telecommunications, networking and signal connections between parts of a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Micro Ribbon
The micro ribbon or miniature ribbon connector is a common type of electrical connector for a variety of applications, such as in computer and telecommunications equipment having many contacts. The connector contains two parallel rows of contacts within a shielded case having a characteristic D-shape similar to that used in D-subminiature connectors. The contacts are not pins, but small flat bands of metal, called ribbon contacts. The connectors are manufactured in many capacities, including 14-, 24-, 36-, 50-, 64-, and 100- pin varieties. They may be mounted on boards, panels, or may terminate cables. Wires are attached by means of solder, crimping or insulation displacement. Female connectors have bail locks for a sturdy connection to the male connector. Screws may also be employed to secure connections. This connector type is also known as ''telco'', ''25-pair'', ''miniature delta ribbon'', ''mini D ribbon'', ''delta ribbon'', ''MDR'', ''Amphenol'', or ''CHAMP'' m ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hot Swapping
Hot swapping is the replacement or addition of components to a computer system without stopping, shutting down, or rebooting the system; hot plugging describes the addition of components only. Components which have such functionality are said to be ''hot-swappable'' or ''hot-pluggable''; likewise, components which do not are ''cold-swappable'' or ''cold-pluggable''. Most desktop computer hardware, such as CPUs and memory, are only cold-pluggable. However, it is common for mid to high-end servers and mainframes to feature hot-swappable capability for hardware components, such as CPU, memory, PCIe, SATA and SAS drives. An example of hot swapping is the express ability to pull a Universal Serial Bus (USB) peripheral device, such as a thumb drive, external hard disk drive (HDD), mouse, keyboard, or printer out of a computer's USB slot or peripheral hub without ejecting it first. Most smartphones and tablets with tray-loading holders can interchange SIM cards without powerin ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single Connector Attachment
A SCSI connector ( ) is used to connect computer parts that use a system called SCSI to communicate with each other. Generally, two connectors, designated male and female, plug together to form a connection which allows two components, such as a computer and a disk drive, to communicate with each other. SCSI connectors can be electrical connectors or optical connectors. There have been a large variety of SCSI connectors in use at one time or another in the computer industry. Twenty-five years of evolution and three major revisions of the standards resulted in requirements for Parallel SCSI connectors that could handle an 8, 16 or 32 bit wide bus running at 5, 10 or 20 megatransfer/s, with conventional or differential signaling. Serial SCSI added another three transport types, each with one or more connector types. Manufacturers have frequently chosen connectors based on factors of size, cost, or convenience at the expense of compatibility. SCSI makes use of cables to connect ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Backplane
A backplane (or "backplane system") is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus. It is used as a backbone to connect several printed circuit boards together to make up a complete computer system. Backplanes commonly use a printed circuit board, but wire-wrapped backplanes have also been used in minicomputers and high-reliability applications. A backplane is generally differentiated from a motherboard by the lack of on-board processing and storage elements. A backplane uses plug-in cards for storage and processing. Usage Early microcomputer systems like the Altair 8800 used a backplane for the processor and expansion cards. Backplanes are normally used in preference to cables because of their greater reliability. In a cabled system, the cables need to be flexed every time that a card is added or removed from the system; this flexing ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
VMEbus
VMEbus (Versa Module Europa or Versa Module Eurocard bus) is a computer bus standard, originally developed for the Motorola 68000 line of CPUs, but later widely used for many applications and standardized by the IEC as ANSI/IEEE 1014-1987. It is physically based on Eurocard sizes, mechanicals and connectors (DIN 41612), but uses its own signalling system, which Eurocard does not define. It was first developed in 1981 and continues to see widespread use today. History In 1979, during development of the Motorola 68000 CPU, one of their engineers, Jack Kister, decided to set about creating a standardized bus system for 68000-based systems. The Motorola team brainstormed for days to select the name VERSAbus. VERSAbus cards were large, , and used edge connectors. Only a few products adopted it, including the IBM System 9000 instrument controller and the Automatix robot and machine vision systems. Kister was later joined by John Black, who refined the specifications and crea ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sun 4
Sun-4 is a series of Unix workstations and servers produced by Sun Microsystems, launched in 1987. The original Sun-4 series were VMEbus-based systems similar to the earlier Sun-3 series, but employing microprocessors based on Sun's own SPARC V7 RISC architecture in place of the 68k family processors of previous Sun models. Sun 4/280 was known as base system that was used for building of first RAID prototype. Models Models are listed in approximately chronological order. : In 1989, Sun dropped the "Sun-4" name for marketing purposes in favor of the SPARCstation and SPARCserver brands for new models, although early SPARCstation/server models were also assigned Sun-4-series model numbers. For example, the SPARCstation 1 was also known as the Sun 4/60. This practice was phased out with the introduction of the SPARCserver 600MP series in 1991. The term ''Sun-4'' continued to be used in an engineering context to identify the basic hardware architecture of all SPARC-based Sun systems ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sun 3
Sun-3 is a series of UNIX computer workstations and servers produced by Sun Microsystems, launched on September 9, 1985. The Sun-3 series are VMEbus-based systems similar to some of the earlier Sun-2 series, but using the Motorola 68020 microprocessor, in combination with the Motorola 68881 floating-point co-processor (optional on the Sun 3/50) and a proprietary Sun MMU. Sun-3 systems were supported in SunOS versions 3.0 to 4.1.1_U1 and also have current support in NetBSD and Linux. Sun-3 models Models are listed in approximately chronological order. : (Max. RAM sizes may be greater when third-party memory boards are used.) Image:Sun3_CPU.jpg, Original Sun-3 CPU board Image:Sun3_4MbMemory_Sun3_Scsi.jpg, Original Sun-3 4 MB memory board with Sun-3 SCSI daughter board Image:Sun3_50CPUwHelios4Mb.jpg, Sun 3/50 CPU board with Helios 4 MB memory expansion Keyboard The Sun Type 3 keyboard is split into three blocks: * special keys * main block * numeric pad It shipped with ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Host Adapter
In computer hardware, a host controller, host adapter, or host bus adapter (HBA), connects a computer system bus, which acts as the host system, to other network and storage devices. The terms are primarily used to refer to devices for connecting SCSI, Fibre Channel and SATA devices. Devices for connecting to IDE, Ethernet, FireWire, USB and other systems may also be called host adapters. Host adapters can be integrated in the motherboard or be on a separate expansion card. The term network interface controller (NIC) is more often used for devices connecting to computer networks, while the term converged network adapter can be applied when protocols such as iSCSI or Fibre Channel over Ethernet allow storage and network functionality over the same physical connection. SCSI A SCSI host adapter connects a host system and a peripheral SCSI device or storage system. These adapters manage service and task communication between the host and target. Typically a device dri ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sun Microsystems
Sun Microsystems, Inc. (Sun for short) was an American technology company that sold computers, computer components, software, and information technology services and created the Java programming language, the Solaris operating system, ZFS, the Network File System (NFS), and SPARC microprocessors. Sun contributed significantly to the evolution of several key computing technologies, among them Unix, RISC processors, thin client computing, and virtualized computing. Notable Sun acquisitions include Cray Business Systems Division, Storagetek, and ''Innotek GmbH'', creators of VirtualBox. Sun was founded on February 24, 1982. At its height, the Sun headquarters were in Santa Clara, California (part of Silicon Valley), on the former west campus of the Agnews Developmental Center. Sun products included computer servers and workstations built on its own RISC-based SPARC processor architecture, as well as on x86-based AMD Opteron and Intel Xeon processors. Sun also develope ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
_MSX_printer_port.jpg "Click for more on -> Micro Ribbon")
.jpg "Click for more on -> Single Connector Attachment")
