|
Randmeer
The Randmeer is a medium size sailing boat designed by E. G. van de Stadt. In the Netherlands it is often used for One-Design sailing races. Developed in the 1960s it was made especially for sailing on the so-called '' randmeren''; narrow shallow lakes that surround the newly created Flevopolders. This makes the boat perfect for rough but shallow waters. Size The ''Randmeer'' is 6.50 meters long and 2.10 meters wide. The hull weighs 500 kilograms. The draft can vary, depending on whether it has a centreboard, between 0.55 and 1.15 meters. The mainsail has a surface area of 11.4 m2, the jib has a surface area of 7.7 m2. The 'Touring' type has a jib of 5.6 m2. In addition it can be sailed with a spinnaker of 19.5 m2. All boats are produced at the shipyard in Heeg, Friesland, The Netherlands. Types Within the Randmeer class there are three types: the ''Classic''; the ''Advance''; and the ''Touring''. The Classic, as can inferred from the name, is the original design that da ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Centreboard
A centreboard or centerboard (US) is a retractable hull appendage which pivots out of a slot in the hull of a sailboat, known as a ''centreboard trunk'' (UK) or ''centerboard case'' (US). The retractability allows the centreboard to be raised to operate in shallow waters, to move the centre of lateral resistance (offsetting changes to the sailplan that move the centre of effort aft), to reduce drag when the full area of the centreboard is not needed, or when removing the boat from the water, as when trailering. A centreboard which consists of solely a pivoting metal plate is called a centerplate; the term "centreboard" may refer to either a wooden or a metal pivoting retractable foil. A daggerboard is similar but slides vertically rather than pivoting. The analog in a scow is a bilgeboard: these are fitted in pairs and used one at a time. General History Lt. John Schank (c. 1740 – 6 February 1823) was an officer of the British Royal Navy and is credited with the inventio ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hull (watercraft)
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures, such as a funnel, derrick, or Mast (sailing), mast. The line where the hull meets the water surface is called the waterline. General features There is a wide variety of hull types that are chosen for suitability for different usages, the hull shape being dependent upon the needs of the design. Shapes range from a nearly perfect box, in the case of scow barges, to a needle-sharp surface of revolution in the case of a racing multihull sailboat. The shape is chosen to strike a balance between cost, hydrostatic considerations (accommodation, load carrying, and stability), hydrodynamics (speed, power requirements, and motion and behavior in a seaway) and special considerations for the ship's role, such as the rounded bow of an icebreaker or the flat bot ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sailing Boat
A sailboat or sailing boat is a boat propelled partly or entirely by sails and is smaller than a sailing ship. Distinctions in what constitutes a sailing boat and ship vary by region and maritime culture. Types Although sailboat terminology has varied across history, many terms have specific meanings in the context of modern yachting. A great number of sailboat-types may be distinguished by size, hull configuration, keel type, purpose, number and configuration of masts, and sail plan. Popular monohull designs include: Cutter The cutter is similar to a sloop with a single mast and mainsail, but generally carries the mast further aft to allow for two foresails, a jib and staysail, to be attached to the head stay and inner forestay, respectively. Once a common racing configuration, today it gives versatility to cruising boats, especially in allowing a small staysail to be flown from the inner stay in high winds. Catboat A catboat has a single mast mounted far forward a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bordering Lakes
In the Netherlands, the bordering lakes (in Dutch: ''Randmeren'') are a chain of lakes which separate the Flevopolder and Noordoostpolder from the ancient lands of the provinces of Gelderland, Utrecht, Overijssel and Friesland.''Wateralmanak 2009: Vaargegevens'', ANWB, 2009p. 329/ref> Strictly speaking, these 'lakes' are not separated from each other, but are a continuous body of water between the old land and the new ''polder'' lands, consisting of lakes divided by straits, dams, locks, or in some cases just a bridge over narrow water. The purpose of these lakes is to isolate the water management of the polder land from that of the neighbouring old land. When a polder is created, the ground level within it is below that of the surrounding area. If the polder is connected directly to the old land, the groundwater level in the old land falls, which causes the soil to dry out.Tijdshrift van het Koninklijk Nederlandsch Aardrijkskundig Genootschap, 1964p. 24/ref> This was observe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Flevopolder
The Flevopolder is an island polder forming the bulk of Flevoland, a province of the Netherlands. Created by land reclamation, its northeastern part was drained in 1955 and the remainder—the southwest—in 1968. Unlike other major polders, it is surrounded by lakes and below-sea-level channels. By some definitions, it is the world's largest artificial island. Levees, dikes, and pumping were used to drain the land. The polder's name references the ancient Lake Flevo. The Flevopolder, along with the Noordoostpolder, forms the Flevoland province, which is located near Amsterdam in the southwest and Kampen, Overijssel in the northeast. Boundaries Unlike other major polders, such as Noordoostpolder and Wieringermeer, the Flevopolder is surrounded by bordering lakes or below-sea-level channels. These are the IJsselmeer, the Veluwemeer, Ketelmeer, and Gooimeer. By some definitions, it is the largest artificial island in the world. History Reclamation of its land Levees and d ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Draft (hull)
The draft or draught of a ship is a determined depth of the vessel below the waterline, measured vertically to its hull's lowest—its propellers, or keel, or other reference point. Draft varies according to the loaded condition of the ship. A deeper draft means the ship will have greater vertical depth below the waterline. Draft is used in under keel clearance calculations, where the draft is calculated with the available depth of water (from Electronic navigational charts) to ensure the ship can navigate safely, without grounding. Navigators can determine their draught by calculation or by visual observation (of the ship's painted load lines). Related terminology A ship's draft/draught is the "depth of the vessel below the waterline measured vertically to the lowest part of the hull, propellers, or other reference point". That is, the draft or draught is the maximum depth of any part of the vessel, including appendages such as rudders, propellers and drop keels if de ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mainsail
A mainsail is a sail rigged on the main mast (sailing), mast of a sailing vessel. * On a square rigged vessel, it is the lowest and largest sail on the main mast. * On a fore-and-aft rigged vessel, it is the sail rigged aft of the main mast. The sail's foot is normally attached to a Boom (sailing), boom. (In extremely heavy weather, the mainsail may be lowered, and a much smaller trysail hoisted in its place). Historical fore-and-aft rigs used a four-sided gaff rigged mainsail, sometimes setting a gaff topsail above it. Whereas once the mainsail was typically the largest sail, today the mainsail may be smaller than the jib or genoa; G. Prout & Sons, Prout Catamaran#History, catamarans typically have a Mast-aft rig, mainmast stepped further aft than in a standard sloop, so that the mainsail is much smaller than the foresail. Bermuda rig The modern Bermuda rig uses a triangular mainsail aft of the mast, closely coordinated with a jib for sailing upwind. A large overlapping ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Spinnaker
A spinnaker is a sail designed specifically for sailing off the wind on courses between a Point of sail#Reaching, reach (wind at 90° to the course) to Point of sail#Running downwind, downwind (course in the same direction as the wind). Spinnakers are constructed of lightweight fabric, usually nylon, and are often brightly colored. They may be designed to perform best as either a reaching or a running spinnaker, by the shaping of the panels and seams. They are attached at only three points and said to be ''flown''. Etymology Some dictionaries suggest that the origin of the word could be traced to the first boat to commonly fly a spinnaker, a yacht called ''Sphinx'', mispronounced as ''Spinx''. ''Spinnaker'' entry in The Concise Oxford Dictionary of English Etymology (1996). Oxford University PressAccording to encyclopedia.com Both retrieved on 20 July 2008. ''Sphinx'' first set her spinnaker in the Solent in 1865, and the first recorded use of the word was in 1866 in the Augu ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Keel
The keel is the bottom-most longitudinal structural element of a watercraft, important for stability. On some sailboats, it may have a fluid dynamics, hydrodynamic and counterbalancing purpose as well. The keel laying, laying of the keel is often the initial step in constructing a ship. In the British and American shipbuilding traditions, this event marks the beginning date of a ship's construction. Etymology The word "keel" comes from Old English language, Old English , Old Norse , = "ship" or "keel". It has the distinction of being regarded by some scholars as the first word in the English language recorded in writing, having been recorded by Gildas in his 6th century Latin work ''De Excidio et Conquestu Britanniae'', under the spelling ''cyulae'' (he was referring to the three ships that the Saxons first arrived in). is the Latin word for "keel" and is the origin of the term careening, careen (to clean a keel and the hull in general, often by rolling the ship on its side). An ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Cabin (ship)
A cabin or berthing is an enclosed space generally on a ship or an aircraft. A cabin which protrudes above the level of a ship's deck (ship), deck may be referred to as a deckhouse. Sailing ships In sailing ships, the officers and paying passengers would have an individual or shared cabin. The Captain (nautical), captain or commanding officer would occupy the "great cabin" that normally spanned the width of the stern and had large windows. On a warship, it was a privileged area, separate from the rest of the ship, for the exclusive use of the captain. In large warships, the cabin was subdivided into day and night cabins (bedrooms) by movable panels, called ''Bulkhead (partition), bulk-heads'', that could be removed in time of battle to leave the cabin clear for the gunners to use the chase gun, stern chasers several of which were usually stationed in the cabin. On large Three-decker, three decker warships in the age of sail the captain's cabin was sometimes appropriated ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bilge
The bilge of a ship or boat is the part of the hull that would rest on the ground if the vessel were unsupported by water. The "turn of the bilge" is the transition from the bottom of a hull to the sides of a hull. Internally, the bilges (usually used in the plural in this context) is the lowest compartment on a ship or seaplane, on either side of the keel and (in a traditional wooden vessel) between the floors. The first known use of the word is from 1513. Bilge water The word is sometimes also used to describe the water that collects in this area. Water that does not drain off the side of the deck or through a hole in the hull, which it would typically do via a scupper, instead drains down into the ship into the bilge. This water may be from rough seas, rain, leaks in the hull or stuffing box, or other interior spillage. The collected water must be pumped out to prevent the bilge from becoming too full and threatening to sink the ship. Bilge water can be found aboard a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
