|
Pipe Rack
Structural steel pipe racks typically support pipes, power cables and instrument cable trays in petrochemical, chemical and power plants. Occasionally, pipe racks may also support mechanical equipment, vessels and valve access platforms. Main pipe racks generally transfer material between equipment and storage or utility areas. Storage racks found in warehouses are not pipe racks, even if they store lengths of pipe.Drake, Richard M., P.E., S.E., SECB and Walter, Robert J., P.E., S.E. A pipe rack is the main artery of a process unit. Pipe racks carry process and utility piping and may also include instrument and cable trays as well as equipment mounted over all of these. Pipe racks consist of a series of transverse beams that run along the length of the pipe system, spaced at uniform intervals typically around 20 ft. To allow maintenance access under the pipe rack, the transverse beams are typically moment frames. Transverse beams are typically connected with longitudinal ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Oilfield Terminology
Oilfield terminology refers to the jargon used by those working in fields within and related to the upstream segment of the petroleum industry. It includes words and phrases describing professions, equipment, and procedures specific to the industry. It may also include slang terms used by oilfield workers to describe the same. Examples *Bell nipple: An enlarged pipe at the top of a casing string that serves as a funnel to guide drilling tools into the top of the well. *Big bear: A big bear is a hitch (see hitch) that lasts a minimum of 50 straight days. *Black Leg : Joints of pipe racked back in the derrick. *Blowout: A sudden, uncontrolled release of underground pressure from the well. *BOP (Blowout preventer): Pronounced "B-O-P", not "bop", is a mechanical device connected to the wellhead to control and prevent blowouts. *Catwalk: Elevated platform used for sliding pipe up to the rig floor. *Chainhand (also motorman): An experienced laborer capable of maintaining most part ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Drilling Technology
Drilling is a cutting process where a drill bit is spun to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute. This forces the cutting edge against the work-piece, cutting off chips (swarf) from the hole as it is drilled. In rock drilling, the hole is usually not made through a circular cutting motion, though the bit is usually rotated. Instead, the hole is usually made by hammering a drill bit into the hole with quickly repeated short movements. The hammering action can be performed from outside the hole ( top-hammer drill) or within the hole ( down-the-hole drill, DTH). Drills used for horizontal drilling are called drifter drills. In rare cases, specially-shaped bits are used to cut holes of non-circular cross-section; a square cross-section is possible. Process Drilled holes are ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
