|
Olympus E-300
The Olympus E-300 (Olympus Evolt E-300 in North America) is an 8-megapixel digital SLR manufactured by Olympus of Japan and based on the Four Thirds System. Announced at photokina 2004, it became available at the end of 2004. It was the second camera (after the Olympus E-1) to use the Four Thirds System, and the first intended for the consumer mark Features The camera's appearance was unique, as it lacked the ubiquitous SLR pentaprism "hump". Instead, a Porro prism system was used; it fitted sideways within the camera, with a sideways-swinging mirror, and located the viewfinder eyepiece to the left (seen from behind) relative to the lens centerline. The body was largely of ABS plastic over a metal frame; the lens mount was metal, and there was a metal covered area on the left top of the camera. This area also contained the onboard flash, which popped up and forward at the touch of a button. The onboard flash popup mechanism is manual. In low light scenarios the flash will not ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Digital Single-lens Reflex Camera
A digital single-lens reflex camera (digital SLR or DSLR) is a digital camera that combines the optics and the mechanisms of a single-lens reflex camera with a digital imaging sensor. The reflex design scheme is the primary difference between a DSLR and other digital cameras. In the reflex design, light travels through the lens and then to a mirror that alternates to send the image to either a prism, which shows the image in the viewfinder, or the image sensor when the shutter release button is pressed. The viewfinder of a DSLR presents an image that will not differ substantially from what is captured by the camera's sensor as it presents it as a direct optical view through the main camera lens, rather than showing an image through a separate secondary lens. DSLRs largely replaced film-based SLRs during the 2000s. Major camera manufacturers began to transition their product lines away from DSLR cameras to mirrorless interchangeable-lens cameras (MILC) beginning in the 2010 ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pentaprism
A pentaprism is a five-sided reflecting prism used to deviate a beam of light by a constant 90°, even if the entry beam is not at 90° to the prism. The beam reflects inside the prism ''twice'', allowing the transmission of an image through a right angle without inverting it (that is, without changing the image's handedness) as an ordinary right-angle prism or mirror would. The reflections inside the prism are not caused by total internal reflection, since the beams are incident at an angle less than the critical angle (the minimum angle for total internal reflection). Instead, the two faces are coated to provide mirror surfaces. The two opposite transmitting faces are often coated with an antireflection coating to reduce spurious reflections. The fifth face of the prism is not used optically but truncates what would otherwise be an awkward angle joining the two mirrored faces. In cameras A variant of this prism is the roof pentaprism which is commonly used in the viewfin ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Live Preview
Live preview is a feature that allows a digital camera's display screen to be used as a viewfinder. This provides a means of previewing framing and other exposure before taking the photograph. In most such cameras, the preview is generated by means of continuously and directly projecting the image formed by the lens onto the main image sensor. This in turn feeds the electronic screen with the live preview image. The electronic screen can be either a liquid crystal display (LCD) or an electronic viewfinder (EVF). Background The concept for cameras with live preview largely derives from electronic (video) TV cameras. Until 1995 most digital cameras did not have live preview, and it was more than ten years after this that the higher end digital single-lens reflex cameras (DSLR) adopted this feature, as it is fundamentally incompatible with the swinging-mirror single-lens reflex mechanism. The first digital still camera with an LCD for autogain framing live preview was the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Olympus E-330
The Olympus E-330 is a DSLR launched on 30 January 2006, using the Four Thirds System lens mount standard. Its main feature is its live image preview functionality, permitting an image to be previewed on the LCD screen. While live image preview is not new in compact digital cameras, the E-330 is significant because it was the first digital SLR to offer this feature. With the ability to digitally zoom in 10× before taking a picture, it is very well suited for exact manual focussing, for example in macro photography. Unlike many other digital SLRs, the E-330 used a second sensor in the viewfinder chamber which was fed by splitting 20% of the light from the viewfinder. The advantage of this implementation is that the camera's autofocus and exposure systems are fully functional and there is no shutter lag. This mode is known as Live Preview A. The E-330 also offers a liveview mode using the main sensor known as Live Preview B or Macro Live Preview; however on initial release, au ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Dust Reduction System
A dust reduction system, or dust removal system, is used in several makes of digital cameras to remove dust from the image sensor. Every time lenses are changed, dust may enter the camera body and settle on the image sensor. Digital single-lens reflex cameras (DSLR) are particularly vulnerable to this issue, since the interior of the camera is exposed during lens changes unlike other forms of digital cameras, and the image sensor is fixed, unlike a film camera. Even the tiniest (micrometre-size) dust particles or other contaminants that settle on the face of the image sensor (individual pixels of which have dimensions on the order of ~5 micrometres) may cast shadows and thus become visible in the final image as more or less diffuse grey blobs, depending on aperture. Dust may be generated by internal moving parts or may be moved by air currents within the camera. Some systems remove or clean the sensor by vibrating at a very high frequency—between 100 hertz and 50 kilohertz ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Supersonic Wave Filter
Supersonic speed is the speed of an object that exceeds the speed of sound (Mach 1). For objects traveling in dry air of a temperature of 20 °C (68 °F) at sea level, this speed is approximately . Speeds greater than five times the speed of sound (Mach 5) are often referred to as hypersonic. Flights during which only some parts of the air surrounding an object, such as the ends of rotor blades, reach supersonic speeds are called transonic. This occurs typically somewhere between Mach 0.8 and Mach 1.2. Sounds are traveling vibrations in the form of pressure waves in an elastic medium. Objects move at supersonic speed when the objects move faster than the speed at which sound propagates through the medium. In gases, sound travels longitudinally at different speeds, mostly depending on the molecular mass and temperature of the gas, and pressure has little effect. Since air temperature and composition varies significantly with altitude, the speed of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Acrylonitrile Butadiene Styrene
Acrylonitrile butadiene styrene (ABS) ( chemical formula (C8H8)''x''·(C4H6)''y''·(C3H3N)''z'' is a common thermoplastic polymer. Its glass transition temperature is approximately . ABS is amorphous and therefore has no true melting point. ABS is a terpolymer made by polymerizing styrene and acrylonitrile in the presence of polybutadiene. The proportions can vary from 15% to 35% acrylonitrile, 5% to 30% butadiene and 40% to 60% styrene. The result is a long chain of polybutadiene crisscrossed with shorter chains of poly(styrene-co-acrylonitrile). The nitrile groups from neighboring chains, being polar, attract each other and bind the chains together, making ABS stronger than pure polystyrene. The acrylonitrile also contributes chemical resistance, fatigue resistance, hardness, and rigidity, while increasing the heat deflection temperature. The styrene gives the plastic a shiny, impervious surface, as well as hardness, rigidity, and improved processing ease. The polybutadie ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Porro Prism
In optics, a Porro prism, named for its inventor Ignazio Porro, is a type of ''reflection prism'' used in optical instruments to alter the orientation of an image. Description It consists of a block of material shaped like a right geometric prism with right-angled triangular end faces. In operation, light enters the large rectangular face of the prism, undergoes total internal reflection twice from the sloped faces, and exits again through the large rectangular face. When the light enters and therefore exits the glass at normal incidence, the prism is not dispersive. An image travelling through a Porro prism is rotated by 180° and exits in the opposite direction offset from its entry point. While a single Porro prism can be constructed to work as well as a roof prism, it is seldom used as such. Therefore, to reduce the cost of production for a Porro prism, the edge of the roof is usually left out. Sometimes only one small window as an entrance surface and one window as ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Olympus E-1
The Olympus E-1, introduced in 2003, was the first DSLR system camera designed from the ground up for digital photography This contrasts with its contemporaries which offered systems based on reused parts from previous 135 film systems, modified to fit with a sensor size of APS-C. Features The E-1 uses the Four Thirds System lens mount and imaging system. This design choice means that because the CCD is smaller than a 35 mm negative, Four Thirds System lenses and camera bodies can be made smaller and lighter than those of preceding SLRs. Characteristics: *Lighter/more compact than contemporary DSLR bodies *5 megapixel CCD *Good dynamic range and exposure *Magnesium-alloy body *Environmental sealing (splash proof) *"Supersonic Wave Filter" dust reduction system cleans CCD at each camera start-up (dust is shaken off the CCD) * USB 2.0 and FireWire connectivity *Continuous shooting 3 frames per second up to 12 frames *Hybrid white balance sensor (on external surface of camer ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Kodak
The Eastman Kodak Company (referred to simply as Kodak ) is an American public company that produces various products related to its historic basis in analogue photography. The company is headquartered in Rochester, New York, and is incorporated in New Jersey. Kodak provides packaging, functional printing, graphic communications, and professional services for businesses around the world. Its main business segments are Print Systems, Enterprise Inkjet Systems, Micro 3D Printing and Packaging, Software and Solutions, and Consumer and Film. It is best known for photographic film products. Kodak was founded by George Eastman and Henry A. Strong on May 23, 1892. During most of the 20th century, Kodak held a dominant position in photographic film. The company's ubiquity was such that its " Kodak moment" tagline entered the common lexicon to describe a personal event that deserved to be recorded for posterity. Kodak began to struggle financially in the late 1990s, as a result o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Photokina 2004
Photokina (rendered in the promoters' branding as "photokina") is a trade fair held in Europe for the photographic and imaging industries. It is the world's largest such trade fair. The first Photokina was held in Cologne, Germany, in 1950, and since 1966 it has been held biennially in September at the Koelnmesse Trade Fair and Exhibition Centre in Deutz. The final Photokina under the then-current biennial cycle took place in 2018. Initially, the promoters planned to start a new annual cycle in 2019, with future shows to be held in May, but they later decided not to begin the new annual cycle until 2020. The worldwide outbreak of the Coronavirus disease 2019 and its effect on the imaging industry made Koelnmesse decide to cancel both Photokina 2020 and Photokina 2021. Many photographic and imaging companies introduce and showcase state of the art imaging products at Photokina. Similar trade shows The show has two main competitors, both of which are annual shows held in diffe ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
