|
J3E
The International Telecommunication Union uses an internationally agreed system for classifying radio frequency signals. Each type of radio emission is classified according to its bandwidth, method of modulation, nature of the modulating signal, and type of information transmitted on the carrier signal. It is based on characteristics of the ''signal'', not on the transmitter used. An emission designation is of the form ''BBBB 123 45'', where ''BBBB'' is the bandwidth of the signal, ''1'' is a letter indicating the type of modulation used of the main carrier (not including any subcarriers which is why FM stereo is F8E and not D8E), ''2'' is a digit representing the type of modulating signal again of the main carrier, ''3'' is a letter corresponding to the type of information transmitted, ''4'' is a letter indicating the practical details of the transmitted information, and ''5'' is a letter that represents the method of multiplexing. The ''4'' and ''5'' fields are optional. This ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single-sideband Modulation
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of signal modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently. Amplitude modulation produces an output signal the bandwidth of which is twice the maximum frequency of the original baseband signal. Single-sideband modulation avoids this bandwidth increase, and the power wasted on a carrier, at the cost of increased device complexity and more difficult tuning at the receiver. Basic concept Radio transmitters work by mixing a radio frequency (RF) signal of a specific frequency, the carrier wave, with the audio signal to be broadcast. In AM transmitters this mixing usually takes place in the final RF amplifier (high level modulation). It is less common and much less efficient to do the mixing at low power and then amplify it in a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single-sideband Suppressed Carrier Transmission
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of signal modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently. Amplitude modulation produces an output signal the bandwidth of which is twice the maximum frequency of the original baseband signal. Single-sideband modulation avoids this bandwidth increase, and the power wasted on a carrier, at the cost of increased device complexity and more difficult tuning at the receiver. Basic concept Radio transmitters work by mixing a radio frequency (RF) signal of a specific frequency, the carrier wave, with the audio signal to be broadcast. In AM transmitters this mixing usually takes place in the final RF amplifier (high level modulation). It is less common and much less efficient to do the mixing at low power and then amplify it in a li ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Amplitude Modulation
Amplitude modulation (AM) is a signal modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave. In amplitude modulation, the instantaneous amplitude of the wave is varied in proportion to that of the message signal, such as an audio signal. This technique contrasts with angle modulation, in which either the frequency of the carrier wave is varied, as in frequency modulation, or its Phase (waves), phase, as in phase modulation. AM was the earliest modulation method used for transmitting audio in radio broadcasting. It was developed during the first quarter of the 20th century beginning with Roberto Landell de Moura and Reginald Fessenden's radiotelephone experiments in 1900. This original form of AM is sometimes called double-sideband amplitude modulation (DSBAM), because the standard method produces sidebands on either side of the carrier frequency. Single-sideband modulation uses bandpass filters to eliminate one of the ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
International Telecommunication Union
The International Telecommunication Union (ITU)In the other common languages of the ITU: * * is a list of specialized agencies of the United Nations, specialized agency of the United Nations responsible for many matters related to information and communications technology, information and communication technologies. It was established on 17 May 1865 as the International Telegraph Union, the first formal and permanent international organization. The organization significantly predates the UN, making it the oldest UN agency. Doreen Bogdan-Martin is the Secretary-General of ITU, the first woman to serve as its head. The ITU was initially aimed at helping connect Telegraphy, telegraphic networks between countries, with its mandate consistently broadening with the advent of new communications technologies; it adopted its current name in 1932 to reflect its expanded responsibilities over radio and the telephone. On 15 November 1947, the ITU entered into an agreement with the newly cr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Phase Modulation
Phase modulation (PM) is a signal modulation method for conditioning communication signals for transmission. It encodes a message signal as variations in the instantaneous phase of a carrier wave. Phase modulation is one of the two principal forms of angle modulation, together with frequency modulation. In phase modulation, the instantaneous amplitude of the baseband signal modifies the phase of the carrier signal keeping its amplitude and frequency constant. The phase of a carrier signal is modulated to follow the changing signal level (amplitude) of the message signal. The peak amplitude and the frequency of the carrier signal are maintained constant, but as the amplitude of the message signal changes, the phase of the carrier changes correspondingly. Phase modulation is an integral part of many digital transmission coding schemes that underlie a wide range of technologies like Wi-Fi, GSM and satellite television. However it is not widely used for transmitting analog audio ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Radioteletype
Radioteletype (RTTY) is a telecommunications system consisting originally of two or more electromechanical teleprinters in different locations connected by radio rather than a wired link. Radioteletype evolved from earlier landline teleprinter operations that began in the mid-1800s. The US Navy Department successfully tested printing telegraphy between an airplane and ground radio station in 1922. Later that year, the Radio Corporation of America ( RCA) successfully tested printing telegraphy via their Chatham, Massachusetts, radio station to the RMS ''Majestic''. Commercial RTTY systems were in active service between San Francisco and Honolulu as early as April 1932 and between San Francisco and New York City by 1934. The US military used radioteletype in the 1930s and expanded this usage during World War II. From the 1980s, teleprinters were replaced by personal computers (PCs) running software to emulate teleprinters. The term radioteletype is used to describe both the or ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Morse Code
Morse code is a telecommunications method which Character encoding, encodes Written language, text characters as standardized sequences of two different signal durations, called ''dots'' and ''dashes'', or ''dits'' and ''dahs''. Morse code is named after Samuel Morse, one of the early developers of the system adopted for electrical telegraphy. International Morse code encodes the 26 ISO basic Latin alphabet, basic Latin letters to , one Diacritic, accented Latin letter (), the Arabic numerals, and a small set of punctuation and procedural signals (Prosigns for Morse code, prosigns). There is no distinction between upper and lower case letters. Each Morse code symbol is formed by a sequence of ''dits'' and ''dahs''. The ''dit'' duration can vary for signal clarity and operator skill, but for any one message, once the rhythm is established, a beat (music), half-beat is the basic unit of time measurement in Morse code. The duration of a ''dah'' is three times the duration ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Reduced-carrier Transmission
Reduced-carrier transmission is an amplitude modulation (AM) transmission in which the carrier signal level is reduced to reduce wasted electrical power. Suppressed-carrier transmission is a special case in which the carrier level is reduced below that required for demodulation by a normal receiver. Reduction of the carrier level permits higher power levels in the sidebands than would be possible with conventional AM transmission. Carrier power must be restored by the receiving station to permit demodulation, usually by means of a beat frequency oscillator (BFO). Failure of the BFO to match the original carrier frequency when receiving such a signal will cause a heterodyne. Suppressed carriers are often used for single sideband (SSB) transmissions, such as for amateur radio on shortwave. That system is referred to in full as SSB suppressed carrier ( SSBSC) or (SSB-SC). International broadcasters agreed in 1985 to also use SSBSC entirely by 2015, though IBOC and IBAC ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-position Modulation
Pulse-position modulation (PPM) is a form of signal modulation in which ''M'' message bits are encoded by transmitting a single pulse in one of 2^M possible required time shifts. This is repeated every ''T'' seconds, such that the transmitted bit rate is M/T bits per second. It is primarily useful for optical communications systems, which tend to have little or no multipath interference. History An ancient use of pulse-position modulation was the Greek hydraulic semaphore system invented by Aeneas Stymphalus around 350 B.C. that used the water clock principle to time signals. In this system, the draining of water acts as the timing device, and torches are used to signal the pulses. The system used identical water-filled containers whose drain could be turned on and off, and a float with a rod marked with various predetermined codes that represented military messages. The operators would place the containers on hills so they could be seen from each other at a distance. To send ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
WWVB
WWVB is a longwave time signal radio station near Fort Collins, Colorado, and is operated by the National Institute of Standards and Technology (NIST). Most radio clock, radio-controlled clocks in North America use WWVB's transmissions to set the correct time. The normal signal transmitted from WWVB is 70 kW Effective radiated power, ERP and uses a 60 Hertz, kHz carrier wave yielding a frequency uncertainty of less than 1 part in 10. The time code signal is derived from a set of atomic clocks located at the site, and transmitted using the IRIG timecode, IRIG "H" format and modulated onto the carrier wave using pulse-width modulation and amplitude-shift keying at one bit per second. A single complete frame of time code begins at the start of each minute, lasts one minute, and conveys the year, day of year, hour, minute, and other information . WWVB is co-located with WWV (radio station), WWV, a time signal station that broadcasts in both voice and time code on multiple ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
