Willys M38

The Willys MC, formally the -Ton, 4 x 4, Utility Truck M38, or the G740 by its U.S. Army Standard Nomenclature supply catalog designation, is a quarter-ton four-wheel drive military light utility vehicle made by Willys between 1949 and 1952. It replaced (in production), and succeeded the World War II Willys MB and Ford GPW models, with a total production of some 50,000 units — less than one tenth the number of WWII models built.

The M38 was a military version of the then-current civilian Jeep CJ-3A. It differed from the CJ-3A in numerous ways, including a reinforced frame and suspension, waterproof 24-volt electrical system, sealed vent system for the engine, transmission, transfer case, fuel system and brake system.

Some M38 jeeps served in the Korean theatre of operations, but the majority of units used there were remanufactured World War II jeeps. Approximately 2,300 M38 Jeeps were manufactured by Ford of Canada for Canadian Armed Forces in 1952, designated as the M38-CDN jeep. The M38 Willys MC was succeeded by the M38A1 Willys MD in 1952.

The M38 windshield could be folded flat for firing and the body was equipped with a pintle hook for towing and lifting shackles front and rear. The headlights were no longer recessed as on previous models, but protruded with a guard wire in front. The "pioneer" tools (axe and shovel) which were carried on the MB's driver side were transferred to the passenger side of this vehicle.

Specifications

*Wheelbase:
*Length overall: TM-9-804– 4x4 Utility truck M38, p.3
*Width, minimum:
*Height overall: maximum with top up; reducible to
*Ground clearance: at the rear axle
*Empty weight:
*Gross vehicle weight: on road TM-9-804– 4x4 Utility truck M38, p.6
*Payload: on road / off-road.

Engine

*Displacement:
*Bore/Stroke:
*Compression Ratio: 6.48:1
*Power: at 4000 rpm
*Torque: at 2000 rpm
*Main Bearings: 3
*Carburetor: Carter YS 637S, downdraft TM-9-804– 4x4 Utility truck M38, p.109

Powertrain

The entire engine air intake and the axle system was fully vented to allow for operation while submerged under water. Its full-floating front axle ( Dana 25) was supported by the wheel hub, rather than the axle itself, and provided greater load capacity. The rear axle (Dana 44) was semi-floating. Its drivetrain was the L-head with a T-90 transmission and the Dana 18 transfer case.

A few M38 Jeeps were fitted with a transmission power take-off (PTO) driven winch. This feature was not used in regular production models due to increased weight on the front of the vehicle, as well as additional maintenance requirements.

Electrical system

The electrical system was upgraded to a 24 volt system which required dual 12 volt batteries connected in series. Its ignition and electrical systems were waterproof; a valuable feature in rainy environments and where deep river fording was necessary.

Operators

Former operators

*
*
* , used by the South Korean police as patrol vehicles during the 1950s.
*
*
*

See also

* List of U.S. military vehicles by supply catalog designation
* List of U.S. military vehicles by model number
* Jeep trailer (M100)

Notes

Footnotes

Citations

References

General

*

Technical manuals

*
*
*
*
*

External links

Willy's Military Jeeps

G503 - Everything you always wanted to know about military vehicles, the WWII military jeep and green things in general...
*

{{DEFAULTSORT:Willys M38
Jeep vehicles
Motor vehicles manufactured in the United States
Military light utility vehicles
M38
Military vehicles introduced from 1945 to 1949
Military trucks of Canada