Sorosilicate

Silicate minerals are rock-forming minerals made up of silicate groups. They are the largest and most important class of minerals and make up approximately 90 percent of Earth's crust.

In mineralogy, the crystalline forms of silica (silicon dioxide, ) are usually considered to be tectosilicates, and they are classified as such in the Dana system (75.1). However, the Nickel-Strunz system classifies them as oxide minerals (4.DA). Silica is found in nature as the mineral quartz, and its polymorphs.

On Earth, a wide variety of silicate minerals occur in an even wider range of combinations as a result of the processes that have been forming and re-working the crust for billions of years. These processes include partial melting, crystallization, fractionation, metamorphism, weathering, and diagenesis.

Living organisms also contribute to this geologic cycle. For example, a type of plankton known as diatoms construct their exoskeletons ("frustules") from silica extracted from seawater. The frustules of dead diatoms are a major constituent of deep ocean sediment, and of diatomaceous earth.

General structure

A silicate mineral is generally an inorganic compound consisting of subunits with the formula iO_2+''n''sup>2''n''−. Although depicted as such, the description of silicates as anions is a simplification. Balancing the charges of the silicate anions are metal cations, M^''x''+. Typical cations are Mg²⁺, Fe²⁺, and Na⁺. The Si-O-M linkage between the silicates and the metals are strong, polar-covalent bonds. Silicate anions ( iO_2+''n''sup>2''n''−) are invariably colorless, or when crushed to a fine powder, white. The colors of silicate minerals arise from the metal component, commonly iron.

In most silicate minerals, silicon is tetrahedral, being surrounded by four oxides. The coordination number of the oxides is variable except when it bridges two silicon centers, in which case the oxide has a coordination number of two.

Some silicon centers may be replaced by atoms of other elements, still bound to the four corner oxygen corners. If the substituted atom is not normally tetravalent, it usually contributes extra charge to the anion, which then requires extra cations. For example, in the mineral orthoclase , the anion is a tridimensional network of tetrahedra in which all oxygen corners are shared. If all tetrahedra had silicon centers, the anion would be just neutral silica . Replacement of one in every four silicon atoms by an aluminum atom results in the anion , whose charge is neutralized by the potassium cations .

Main groups

In mineralogy, silicate minerals are classified into seven major groups according to the structure of their silicate anion:

Tectosilicates can only have additional cations if some of the silicon is replaced by an atom of lower valence such as aluminum. Al for Si substitution is common.

Nesosilicates or orthosilicates

Nesosilicates (from Greek 'island'), or orthosilicates, have the orthosilicate ion, present as isolated (insular) tetrahedra connected only by interstitial cations. The Nickel–Strunz classification is 09.A –examples include:

*Phenakite group
** Phenakite –
** Willemite –
*Olivine group
**Forsterite –
**Fayalite –
** Tephroite –
*Garnet group
** Pyrope –
**Almandine –
** Spessartine –
**Grossular –
**Andradite –
** Uvarovite –
** Hydrogrossular –
*Zircon group
**Zircon –
** Thorite –
** Hafnon –

* group
** Andalusite –
**Kyanite –
**Sillimanite –
** Dumortierite –
**Topaz –
** Staurolite –
* Humite group –
**Norbergite –
** Chondrodite –
** Humite –
** Clinohumite –
* Datolite –
* Titanite –
* Chloritoid –
*Mullite (aka Porcelainite) –

Sorosilicates

Sorosilicates (from Greek 'heap, mound') have isolated pyrosilicate anions , consisting of double tetrahedra with a shared oxygen vertex—a silicon:oxygen ratio of 2:7. The Nickel–Strunz classification is 09.B. Examples include:

* Thortveitite –
*Hemimorphite (calamine) –
* Lawsonite –
* Axinite –
* Ilvaite –
*Epidote group (has both and groups}
**Epidote –
** Zoisite –
*** Tanzanite –
** Clinozoisite –
** Allanite –
** Dollaseite-(Ce) –
*Vesuvianite ( idocrase) –

Cyclosilicates

Cyclosilicates (from Greek 'circle'), or ring silicates, have three or more tetrahedra linked in a ring. The general formula is (Si_''x''O_3''x'')^2''x''−, where one or more silicon atoms can be replaced by other 4-coordinated atom(s). The silicon:oxygen ratio is 1:3. Double rings have the formula (Si_2''x''O_5''x'')^2''x''− or a 2:5 ratio. The Nickel–Strunz classification is 09.C. Possible ring sizes include:

File:Beryll.ring.combined.png, 6 units , beryl (red: Si, blue: O)
File:Benitoid.2200.png, 3 units , benitoite
File:Papagoite.2200.png, 4 units , papagoite
File:Eudialyte.2200.png, 9 units , eudialyte
File:Milarite.png, 12 units, double ring , milarite

Some example minerals are:
* 3-member single ring
** Benitoite –
* 4-member single ring
** Papagoite – .
* 6-member single ring
**Beryl –
** Bazzite –
** Sugilite –
**Tourmaline –
** Pezzottaite –
** Osumilite –
**Cordierite –
** Sekaninaite –
* 9-member single ring
** Eudialyte –
* 6-member double ring
** Milarite –

The ring in axinite contains two B and four Si tetrahedra and is highly distorted compared to the other 6-member ring cyclosilicates.

Inosilicates

Inosilicates (from Greek enitive: 'fibre'), or chain silicates, have interlocking chains of silicate tetrahedra with either , 1:3 ratio, for single chains or , 4:11 ratio, for double chains. The Nickel–Strunz classification is 09.D – examples include:

Single chain inosilicates

*Pyroxene group
**Enstatite – orthoferrosilite series
*** Enstatite –
*** Ferrosilite –
** Pigeonite –
**Diopside – hedenbergite series
*** Diopside –
*** Hedenbergite –
***Augite –
**Sodium pyroxene series
***Jadeite –
*** Aegirine (or acmite) –
** Spodumene –
** Pyroxferroite -
*Pyroxenoid group
**Wollastonite –
** Rhodonite –
** Pectolite –

Double chain inosilicates

*Amphibole group
** Anthophyllite –
**Cummingtonite series
*** Cummingtonite –
*** Grunerite –
**Tremolite series
***Tremolite –
*** Actinolite –
**Hornblende –
**Sodium amphibole group
*** Glaucophane –
***Riebeckite (asbestos) –
***Arfvedsonite –

File:Pyroxen-chain.png, Inosilicate, pyroxene family, with 2-periodic single chain , diopside
File:Tremolite-chain.png, Inosilicate, clinoamphibole, with 2-periodic double chains , tremolite
File:Wollastonite-chain.png, Inosilicate, unbranched 3-periodic single chain of wollastonite
File:Rhodonite-chain.png, Inosilicate with 5-periodic single chain, rhodonite
File:Pellyite-chain.png, Inosilicate with cyclic branched 8-periodic chain, pellyite

Phyllosilicates

Phyllosilicates (from Greek 'leaf'), or sheet silicates, form parallel sheets of silicate tetrahedra with or a 2:5 ratio. The Nickel–Strunz classification is 09.E. All phyllosilicate minerals are hydrated, with either water or hydroxyl groups attached.

Examples include:
* Serpentine subgroup
** Antigorite –
**Chrysotile –
** Lizardite –
*Clay minerals group
**1:1 clay minerals (TO)
***Halloysite –
***Kaolinite –
**2:1 clay minerals (TOT)
*** Pyrophyllite –
***Talc –
***Illite –
***Montmorillonite (smectite) –
***Chlorite –
***Vermiculite –
**Other clay minerals
***Sepiolite –
*** Palygorskite (or attapulgite) –
*Mica group
**Brittle mica group
*** Anandite –
*** Bityite –
*** Clintonite –
*** Margarite –
**Dioctahedral mica group
***Celadonite subgroup
**** Celadonite –
**** Aluminoceladonite –
***Glauconite –
***Muscovite –
****Fuchsite – (Cr replaces Al in muscovite)
****Illite – (K-deficient muscovite)
**** Mariposite – (Cr-bearing muscovite)
**** Phengite – (Fe/Mg-bearing muscovite)
*** Paragonite –
***Roscoelite –
**Trioctahedral mica group
*** Aspidolite –
***Biotite subgroup –
**** Annite –
****Phlogopite –
***Hendricksite –
*** Lepidolite (polylithionite-trilithionite series) –
*** Zinnwaldite series –

File:Muskovite.sheet.png, Phyllosilicate, mica group, muscovite (red: Si, blue: O)
File:Apophyllite.sheet.png, Phyllosilicate, single net of tetrahedra with 4-membered rings, apophyllite-(KF)-apophyllite-(KOH) series
File:Pyrosmalite.sheet.png, Phyllosilicate, single tetrahedral nets of 6-membered rings, pyrosmalite-(Fe)-pyrosmalite-(Mn) series
File:Zeophyllite.sheet.png, Phyllosilicate, single tetrahedral nets of 6-membered rings, zeophyllite
File:Carletonite.sheet.png, Phyllosilicate, double nets with 4- and 6-membered rings, carletonite

Tectosilicates

Tectosilicates, or "framework silicates," have a three-dimensional framework of silicate tetrahedra with in a 1:2 ratio. This group comprises nearly 75% of the crust of the Earth. Tectosilicates, with the exception of the quartz group, are aluminosilicates. The Nickel–Strunz classifications are 9.F (tectosilicates without zeolitic ), 9.G (tectosilicates with zeolitic ), and 4.DA (quartz/silica group). Below is a list of tectosilicate minerals and their chemical formulas, organized by groups and series:
*Quartz group (silica)
**Quartz –
**Tridymite –
**Cristobalite –
**Coesite –
**Stishovite –
**Moganite –
**Chalcedony –
*Feldspar group
**Alkali feldspar series (potassium feldspars or K-spar)
***Microcline –
****Amazonite – green variety of microcline
***Orthoclase –
**** Moonstone – opalescent variety of orthoclase
*** Anorthoclase –
***Sanidine –
**Plagioclase feldspar series
***Albite (sodium endmember) –
***Oligoclase – (Na:Ca 90:10 to 70:30)
*** Andesine – (Na:Ca 50:50 to 70:30)
*** Labradorite – (Na:Ca 30:70 to 50:50)
*** Bytownite – (Na:Ca 10:90 to 30:70)
***Anorthite