Rate-adaptive digital subscriber line (RADSL) is a pre-standard

asymmetric digital subscriber line Asymmetric digital subscriber line (ADSL) is a type of digital subscriber line (DSL) technology, a data communications technology that enables faster data transmission over copper telephone lines than a conventional voiceband modem can provide ...

(ADSL) solution. RADSL was introduced as proprietary technology by AT&T Paradyne, later GlobeSpan Technologies Inc., in June 1996. In September 1999, RADSL technology was formally described by

ANSI The American National Standards Institute (ANSI ) is a private non-profit organization that oversees the development of voluntary consensus standards for products, services, processes, systems, and personnel in the United States. The organ ...

in T1.TR.59-1999. RADSL supports downstream data rates of up to approximately 8 Mbit/s,

upstream Upstream may refer to: * Upstream (bioprocess) * ''Upstream'' (film), a 1927 film by John Ford * Upstream (networking) * ''Upstream'' (newspaper), a newspaper covering the oil and gas industry * Upstream (petroleum industry) * Upstream (software ...

data rates up to approximately 1 Mbit/s, and can coexist with

POTS Pot may refer to: Containers * Flowerpot, a container in which plants are cultivated * Pottery, ceramic ware made by potters * A type of cookware Places * Ken Jones Aerodrome, IATA airport code POT * Palestinian Occupied Territories, the We ...

voice on the same line. RADSL allows rate-adaptation while the connection is in operation — rate-adaptation during connection setup is possible in many other DSL variants, including G.dmt and its successors. Rate-adaptation while the connection is in operation is specified as an option in

ADSL2 ITU G.992.3 is an ITU (International Telecommunication Union) standard, also referred to as ADSL2 or G.dmt.bis. It optionally extends the capability of basic ADSL in data rates to 12 Mbit/s downstream and, depending on Annex version, up to 3 ...

ADSL2+ G.992.5 (also referred to as ADSL2+, G.dmt.bis+, and G.adslplus) is an ITU-T standard for asymmetric digital subscriber line (ADSL) broadband Internet access. The standard has a maximum theoretical downstream sync speed of 24 megabits per secon ...

, and

VDSL2 Very high-speed digital subscriber line (VDSL) and very high-speed digital subscriber line 2 (VDSL2) are digital subscriber line (DSL) technologies providing data transmission faster than the earlier standards of asymmetric digital subscriber li ...

, under the name ''seamless rate adaptation'' (SRA).

Technology

RADSL specifies two alternative modulation schemes,

quadrature amplitude modulation Quadrature amplitude modulation (QAM) is the name of a family of digital modulation methods and a related family of analog modulation methods widely used in modern telecommunications to transmit information. It conveys two analog message sig ...

(QAM) and

carrierless amplitude phase modulation Carrierless amplitude phase modulation (CAP) is a variant of quadrature amplitude modulation (QAM). Instead of modulating the amplitude of two carrier waves, CAP generates a QAM signal by combining two PAM signals filtered through two filters desi ...

(CAP). RADSL is not interoperable with

discrete multi-tone Discrete may refer to: *Discrete particle or quantum in physics, for example in quantum theory *Discrete device, an electronic component with just one circuit element, either passive or active, other than an integrated circuit *Discrete group, a ...

(DMT) modulation variants of ADSL, standardized in ANSI T1.413 Issue 2 and G.dmt (G.992.1). Upstream and downstream are

frequency-division duplex A duplex communication system is a point-to-point system composed of two or more connected parties or devices that can communicate with one another in both directions. Duplex systems are employed in many communications networks, either to allow ...

ed, the upstream and downstream transmit PSD masks are identical to those in ANSI T1.413. In RADSL, the

baud rate In telecommunication and electronics, baud (; symbol: Bd) is a common unit of measurement of symbol rate, which is one of the components that determine the speed of communication over a data channel. It is the unit for symbol rate or modulatio ...

, center frequency, and constellation size of the downstream and upstream channels can be adjusted while the connection is in operation. Using this technique the line is more tolerant of errors caused by

noise Noise is unwanted sound considered unpleasant, loud or disruptive to hearing. From a physics standpoint, there is no distinction between noise and desired sound, as both are vibrations through a medium, such as air or water. The difference aris ...

and signal loss. As the parameters are adjusted, the bandwidth may be markedly decreased if there is a large amount of line noise or signal degradation.

References

{{DSL technologies Digital subscriber line

Technology

See also

References