The Piaggio P.23M was an Italian commercial

transport aircraft Transport aircraft is a broad category of aircraft that includes: * Airliners, aircraft, usually large and most often operated by airlines, intended for carrying multiple passengers or cargo in commercial service * Cargo aircraft or freighters, fix ...

prototype A prototype is an early sample, model, or release of a product built to test a concept or process. It is a term used in a variety of contexts, including semantics, design, electronics, and Software prototyping, software programming. A prototype ...

designed and built by

Piaggio Piaggio Group () is an Italian motor vehicle manufacturer, which produces a range of two-wheeled motor vehicles and compact commercial vehicles under five brands: Piaggio, Vespa, Aprilia, Moto Guzzi and Derbi. Its corporate headquarters are ...

Design and development

Piaggio designed the P.23M specifically for flights across the North

Atlantic Ocean The Atlantic Ocean is the second largest of the world's five borders of the oceans, oceanic divisions, with an area of about . It covers approximately 17% of Earth#Surface, Earth's surface and about 24% of its water surface area. During the ...

, intending it to have potential for development as a commercial

transport Transport (in British English) or transportation (in American English) is the intentional Motion, movement of humans, animals, and cargo, goods from one location to another. Mode of transport, Modes of transport include aviation, air, land tr ...

. It was a four-engine shoulder-

wing A wing is a type of fin that produces both Lift (force), lift and drag while moving through air. Wings are defined by two shape characteristics, an airfoil section and a planform (aeronautics), planform. Wing efficiency is expressed as lift-to-d ...

monoplane A monoplane is a fixed-wing aircraft configuration with a single mainplane, in contrast to a biplane or other types of multiplanes, which have multiple wings. A monoplane has inherently the highest efficiency and lowest drag of any wing con ...

with inverted

gull wing The gull wing, also known as Polish wing or Puławski wing, is an aircraft wing configuration with a prominent bend in the wing inner section towards the wing root. Its name is derived from the seabirds which it resembles and from the Polish a ...

s and twin tail fins and

rudder A rudder is a primary control surface used to steer a ship, boat, submarine, hovercraft, airship, or other vehicle that moves through a fluid medium (usually air or water). On an airplane, the rudder is used primarily to counter adverse yaw ...

s. To allow an easier landing if the aircraft had to ditch at sea, its

fuselage The fuselage (; from the French language, French ''fuselé'' "spindle-shaped") is an aircraft's main body section. It holds Aircrew, crew, passengers, or cargo. In single-engine aircraft, it will usually contain an Aircraft engine, engine as wel ...

was designed like a boat

hull Hull may refer to: Structures * The hull of an armored fighting vehicle, housing the chassis * Fuselage, of an aircraft * Hull (botany), the outer covering of seeds * Hull (watercraft), the body or frame of a sea-going craft * Submarine hull Ma ...

, which Piaggio termed an ''avion marin'' ("marine aviation") design, although the aircraft was not a

flying boat A flying boat is a type of seaplane with a hull, allowing it to land on water. It differs from a floatplane in having a fuselage that is purpose-designed for flotation, while floatplanes rely on fuselage-mounted floats for buoyancy. Though ...

. The main

landing gear Landing gear is the undercarriage of an aircraft or spacecraft that is used for taxiing, takeoff or landing. For aircraft, it is generally needed for all three of these. It was also formerly called ''alighting gear'' by some manufacturers, s ...

was retractable. The P.23Ms four Isotta-Fraschini Asso XI R. V-12 engines were mounted on the wings in two tandem pairs, each engine driving a two-bladed

propeller A propeller (often called a screw if on a ship or an airscrew if on an aircraft) is a device with a rotating hub and radiating blades that are set at a pitch to form a helical spiral which, when rotated, exerts linear thrust upon a working flu ...

; two of the propellers were mounted in a

pusher configuration In aeronautical and naval engineering, pusher configuration is the term used to describe a drivetrain of air- or watercraft with propulsion device(s) after the engine(s). This is in contrast to the more conventional tractor configuration, wh ...

and the other two in a

tractor configuration In aviation, a tractor configuration is a propeller-driven fixed-wing aircraft with its engine mounted with the propeller in front, so that the aircraft is "pulled" through the air. This is the usual configuration; the pusher configuration ...

. Piaggio claimed a top speed of for the P.23M and projected its maximum range at a cruising speed of as .

Operational history

The P.23 first flew in 1935. No attempt to fly the

ever took place, and its predicted maximum range capabilities never were tested. The aircraft soon was disassembled and never flew again.

Variants

No variants of the P.23 were produced. The Piaggio P.23R of 1936, although also a commercial transport prototype and confusingly numbered as if it were a variant of the P.23, was an entirely new design.

Operators

Specifications (P.23M)

References

External links

AR Aircraft Manuals Blueprints Video Publications: Piaggio P.23
{{Portal bar, Italy, Companies, Aviation P.023 1930s Italian airliners 1930s Italian cargo aircraft Four-engined push-pull aircraft Shoulder-wing aircraft Aircraft first flown in 1935