The military standard referred to as MIL-E-7016F, Electric Load and Power Source Capacity, Aircraft, Analysis of" addresses the methods and analysis of electric loads and source capacity on military aircraft. The use of the document is approved for use by all departments and agencies of the

United States Department of Defense The United States Department of Defense (DoD, USDOD, or DOD) is an United States federal executive departments, executive department of the federal government of the United States, U.S. federal government charged with coordinating and superv ...

(DoD). Although prepared specifically for DoD applications, the standard may be tailored for commercial applications as well.

Scope of the Specification

The MIL-E-7016F specification covers the methods and requirements for preparing alternating current (AC) and direct current (DC) electric load and power source capacity analyses for aircraft.

Lead Standardization Agency

The MIL-E-7016F specification is maintained by the

United States Air Force The United States Air Force (USAF) is the Air force, air service branch of the United States Department of Defense. It is one of the six United States Armed Forces and one of the eight uniformed services of the United States. Tracing its ori ...

's Oklahoma City Air Logistics Center who is chartered under the Defense Standardization Program (DSP) with maintaining the functional expertise and serving as the DoD-wide technical focal point for the specification. The current document revision (2009) is Revision F (i.e. MIL-E-7016F) which was issued on July 20, 1976. It was subsequently amended (Amendment 1) on March 18, 1981, and was last validated on April 15, 1988.

Related Documents

*The document ''MIL-W-5088L, MILITARY SPECIFICATION: WIRING, AEROSPACE VEHICLE'' covers all aspects from the selection through installation of wiring and wiring devices used in aerospace vehicles (i.e., airplanes, helicopters, lighter-than-air vehicles, and missiles). *The document '' MIL-STD-704, DEPARTMENT OF DEFENSE INTERFACE STANDARD: AIRCRAFT ELECTRIC POWER CHARACTERISTICS'' establishes the requirements and characteristics of aircraft electric power provided at the input terminals of electric utilization equipment. MIL-HDBK-704-1 through-8 defines test methods and procedures for determining airborne utilization equipment compliance with the electric power characteristics requirements defined herein. Electromagnetic interference and voltage spikes are not covered by this standard.

References and external links

* * * {{DEFAULTSORT:Mil-E-7016f Military of the United States standards