Ketene Cycloaddition

Ketene cycloadditions are the reactions of the pi system of ketenes with unsaturated compounds to provide four-membered or larger rings. +2 +2 and +2variants of the reaction are known.

Introduction

Ketenes may react with unsaturated compounds to afford four-membered or larger rings. The first
example of this phenomenon was observed in 1908, and since then, cycloadditions of ketenes have
expanded and gained synthetic utility. Examples exist of +2 +2 and +2cycloaddition,
and conjugated ketenes may act as 4π partners in +2cycloadditions as well. The unique transition state geometry of +2ketene cycloadditions has important stereochemical consequences (see below).
''(1)''

Mechanism and Stereochemistry

Prevailing Mechanism

Ketene cycloadditions proceed by a concerted, +2cycloaddition mechanism.
Ketenes, unlike most alkenes, can align antarafacially with respect to other alkenes. Thus, the suprafacial-
antarafacial geometry required for concerted, thermal +2cycloaddition can be achieved in reactions
of ketenes. This geometry has the interesting consequence that the bulkier substituent on the ketene will tend
to end up on the more sterically hindered face of the cyclobutanone ring. In the transition state for cyclization, the small substituent points toward the alkene. This model also explains the greater reactivity of ''cis'' alkenes relative to ''trans'' alkenes in +2ketene cycloadditions.
''(2)''
The configuration of the olefin is retained in the cycloaddition product. Electron-withdrawing substituents on the ketene and donating substituents on the alkene accelerate the
reaction, but disubstituted ketenes react slowly due to steric hindrance. Orbital coefficients can be used to determine regioselectivity.

Enantioselective Variants

The use of chiral amine catalysts has allowed access to cycloaddition products in high enantiomeric excess.
''(3)''

Scope and Limitations

Ketenes may participate in +2 +2 or +2(as either the 2π or 4π component) cycloadditions. The periselectivity of a particular reaction depends on the structure of both the ketene and the substrate. Although the reaction is predominantly used to form four-membered rings, a limited number of substrates undergo +2or +2reactions with ketenes. Examples of all three modes of cycloaddition are discussed in this section.

Ketenes may dimerize, or two ketenes may react with one another to afford substituted cyclobutanones. There
are typically two possible products depending on the precise double bonds that react. Disubstituted ketenes give
only the 1,3-cyclobutanedione.
''(4)''
Ketenes react with alkenes to provide cyclobutanones. If the product of a cycloaddition of ketene itself is
desired, dichloroketene is typically used, followed by dehalogenation with zinc-copper couple.
''(5)''
Cyclic and acyclic dienes generally give cyclobutanones, rather than Diels-Alder adducts. In reactions of
cyclic dienes, the larger ketene substituent is placed in the ''endo'' position. Fulvenes typically react in the ring, leaving the double bond intact.
''(6)''
Ketenes undergo +2cycloaddition with ketones and aldehydes to give β-lactones. Lewis acid
catalysis is necessary for this process, unless the carbonyl compound possesses strongly electron-
withdrawing substituents.
''(7)''
+2Cycloadditions may take place with 1,3-dipoles. This process appears to be concerted, but
either double bond of ketenes can react.
''(8)''
In contrast to simple dienes, which typically react in a +2fashion or afford complex mixtures of +2products, heterodienes often react in a
+2fashion. β-amino or -alkoxy unsaturated ketones, for instance, react with ketenes in
a +2sense to give synthetically useful yields of lactones.
''(9)''
Examples in which a vinylketene serves as the 4π partner are rare, but ketene-containing
heterodienes such as acyl ketenes react with many heterodienophiles to give heterocyclic products
in good yield.
''(10)''

Experimental Conditions and Procedure

Typical Conditions

Cycloadditions with reactants that are liquids at room temperature are best performed by simply mixing the two reactants without solvent. If one of the reactants is gaseous, it is more convenient to use a solvent. Although polar solvents and catalysts accelerate the cycloaddition, they are not of general utility since they also accelerate dimerization. The progress of the reaction can be estimated by disappearance of the characteristic yellow color of the ketene, by loss of the band at about 2100 cm⁻¹ in the infrared spectrum, or by ¹H NMR spectroscopy. Ketene, monoalkylketenes, and dimethylketene are usually allowed to react at or below room temperature, whereas the higher molecular weight ketenes can be heated to temperatures above 100°. The ketene is usually used in excess when dimerization is a major side reaction. The success of the reaction is often determined by the relative rates of cycloaddition and dimerization of the ketene.

Example ProcedureHassner, A.; Dilon, J. L. ''J. Org. Chem.'' 1983, ''48'', 3382.

''(11)''
In a flame-dried, 100-mL three-necked flask equipped with argon atmosphere, stirrer, reflux condenser, and constant pressure addition funnel was placed 0.40 g (18 mmol) of activated zinc, 0.576 g (6 mmol) of 1-heptyne, and 50 mL of anhydrous ether. To this stirred mixture was added dropwise over 1 hour a solution of 1.79 g (12 mmol) of phosphorus oxychloride (freshly distilled from potassium carbonate), trichloroacetyl chloride (12 mmol), and 10 mL of anhydrous ether. The mixture was then stirred at reflux for 4 hours and the residual zinc removed by filtration on a pad of Celite. The ether solution was washed with water, 5% sodium bicarbonate solution, and brine, and dried over potassium carbonate. After removal of ether under reduced pressure, the product was purified by bulb-to-bulb distillation at 100° bath temperature (0.1 mm), to give 1.08 g (90%) of the title compound as a clear oil. IR ν_max (neat) 1800, 1585 cm⁻¹; ¹H NMR (CDCl₃) δ 6.12 (m, 1H, J = 2 Hz), 2.7 (t, 2H, J = 6 Hz), 2.0–0.7 (m, 9H). Anal. Calcd. for C₉H₁₃Cl₂O: C, 52.19; H, 5.85. Found: C, 52.10; H, 5.79.

References

External links

*{{Commonscatinline

Cycloaddition
Cycloadditions