IEEE 802.3az
   HOME

TheInfoList



OR:

In
computer network A computer network is a collection of communicating computers and other devices, such as printers and smart phones. In order to communicate, the computers and devices must be connected by wired media like copper cables, optical fibers, or b ...
ing, Energy-Efficient Ethernet (EEE) is a set of enhancements to
twisted-pair Twisted pair cabling is a type of communications cable in which two conductors of a single circuit are twisted together for the purposes of improving electromagnetic compatibility. Compared to a single conductor or an untwisted balanced ...
,
twinaxial Twinaxial cabling, or twinax, is a type of cable similar to coaxial cable, but with two inner conductors in a twisted pair instead of one. Due to cost efficiency it is becoming common in modern (2013) very-short-range high-speed differential sig ...
,
backplane A backplane or backplane system is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus. It is used to connect s ...
, and
optical fiber An optical fiber, or optical fibre, is a flexible glass or plastic fiber that can transmit light from one end to the other. Such fibers find wide usage in fiber-optic communications, where they permit transmission over longer distances and at ...
Ethernet physical-layer variants that reduce power consumption during periods of low data activity. The intention is to reduce power consumption by at least half, while retaining full compatibility with existing equipment. The
Institute of Electrical and Electronics Engineers The Institute of Electrical and Electronics Engineers (IEEE) is an American 501(c)(3) public charity professional organization for electrical engineering, electronics engineering, and other related disciplines. The IEEE has a corporate office ...
(IEEE), through the IEEE 802.3az task force, developed the standard. The first study group had its call for interest in November 2006, and the official standards task force was authorized in May 2007. The IEEE ratified the final standard in September 2010. Some companies introduced technology to reduce the power required for Ethernet before the standard was ratified, using the name Green Ethernet. Some energy-efficient switch
integrated circuits An integrated circuit (IC), also known as a microchip or simply chip, is a set of electronic circuits, consisting of various electronic components (such as transistors, resistors, and capacitors) and their interconnections. These components a ...
were developed before the IEEE 802.3az Energy-Efficient Ethernet standard was finalized.


Potential savings

In 2005, all the
network interface controller A network interface controller (NIC, also known as a network interface card, network adapter, LAN adapter and physical network interface) is a computer hardware component that connects a computer to a computer network. Early network interface ...
s in the United States (in computers, switches, and routers) used an estimated 5.3 terawatt-hours of electricity. According to a researcher at the
Lawrence Berkeley Laboratory Lawrence Berkeley National Laboratory (LBNL, Berkeley Lab) is a federally funded research and development center in the hills of Berkeley, California, United States. Established in 1931 by the University of California (UC), the laboratory is spo ...
, Energy-Efficient Ethernet can potentially save an estimated  million a year in energy costs in the US. Most of the savings would come from homes ( million) and offices ( million), and the remaining  million from data centers.


Concepts

The power reduction is accomplished in a few ways. In
Fast Ethernet In computer networking, Fast Ethernet Ethernet physical layer, physical layers carry traffic at the nominal rate of . The Classic Ethernet, prior Ethernet speed was . Of the Fast Ethernet physical layers, 100BASE-TX is by far the most common. ...
and faster links, constant and significant energy is used by the
physical layer In the seven-layer OSI model of computer networking, the physical layer or layer 1 is the first and lowest layer: the layer most closely associated with the physical connection between devices. The physical layer provides an electrical, mechani ...
as transmitters are active regardless of whether data is being sent. If they could be put into sleep mode when no data is being sent, that energy could be saved. When the controlling software or firmware decides that no data needs to be sent, it can issue a low-power idle (LPI) request to the Ethernet controller physical layer
PHY In the seven-layer OSI model of computer networking, the physical layer or layer 1 is the first and lowest layer: the layer most closely associated with the physical connection between devices. The physical layer provides an electrical, mechani ...
. The PHY will then send LPI symbols for a specified time onto the link, and then disable its transmitter. Refresh signals are sent periodically to maintain link signaling integrity. When there is data to transmit, a normal IDLE signal is sent for a predetermined period of time. The data link is considered to be always operational, as the receive signal circuit remains active even when the transmit path is in sleep mode.


Green Ethernet

Green Ethernet technology was a superset of the 802.3az standard. In addition to the link load power savings of Energy-Efficient Ethernet, Green Ethernet works in one of two ways. First, it detects link status, allowing each port on the switch to power down into a standby mode when a connected device, such as a computer, is not active. Second, it detects cable length and adjusts the power used for transmission accordingly. Standard switches provide enough power to send a signal up to . However, this is often unnecessary in the SOHO environment, where of cabling are typical between rooms. Moreover, small data centers can also benefit from this approach since the majority of cabling is confined to a single room with a few meters of cabling among servers and switches. In addition to the pure power-saving benefits of Green Ethernet, backing off the transmit power on shorter cable runs reduces alien crosstalk and improves the overall performance of the cabling system. Green Ethernet also encompasses the use of more efficient circuitry in Ethernet chips, and the use of offload engines on Ethernet interface cards intended for network servers. In April 2008, the term was used for switches, and, in July 2008, used with wireless routers that featured user-selectable off periods for
Wi-Fi Wi-Fi () is a family of wireless network protocols based on the IEEE 802.11 family of standards, which are commonly used for Wireless LAN, local area networking of devices and Internet access, allowing nearby digital devices to exchange data by ...
to further reduce energy consumption. Projected power savings of up to 80 percent were predicted using Green Ethernet switches, translating into a longer product life due to reduced heat.


See also

*
Autonomous peripheral operation In computing, autonomous peripheral operation is a hardware feature found in some microcontroller architectures to off-load certain tasks into embedded autonomous peripherals in order to minimize latencies and improve throughput in hard real-ti ...
*
Green computing Green computing, green IT (Information Technology), or Information and Communication Technology Sustainability, is the study and practice of environmentally sustainable computing or IT. The goals of green computing include optimising energy ef ...
*
One Watt Initiative 1 (one, unit, unity) is a number, numeral, and glyph. It is the first and smallest positive integer of the infinite sequence of natural numbers. This fundamental property has led to its unique uses in other fields, ranging from science to s ...
*
Power over Ethernet Power over Ethernet (PoE) describes any of several technical standard, standards or ad hoc systems that pass electric power along with data on twisted-pair Ethernet cabling. This allows a single cable to provide both a data connection and en ...
(PoE)


References


External links


IEEE P802.3az Energy Efficient Ethernet Task Force
* Blog for Energy-Efficient Ethernet techniques and news analyses, circa 2009. {{Ethernet IEEE 802 Ethernet Energy conservation Computers and the environment