The goat grazing problem is either of two related problems in
recreational mathematics
Recreational mathematics is mathematics carried out for recreation (entertainment) rather than as a strictly research-and-application-based professional activity or as a part of a student's formal education. Although it is not necessarily limited ...
involving a tethered goat grazing a circular area: the interior grazing problem and the exterior grazing problem. The former involves grazing the
interior of a circular area, and the latter, grazing an exterior of a circular area. For the exterior problem, the constraint that the rope can not enter the circular area dictates that the grazing area forms an
involute
In mathematics, an involute (also known as an evolvent) is a particular type of curve that is dependent on another shape or curve. An involute of a curve is the Locus (mathematics), locus of a point on a piece of taut string as the string is eith ...
. If the goat were instead tethered to a post on the edge of a circular path of pavement that did not obstruct the goat (rather than a fence or a silo), the interior and exterior problem would be complements of a simple circular area.
The original problem was the exterior grazing problem and appeared in the 1748 edition of the English annual journal ''
The Ladies' Diary
''The Ladies' Diary: or, Woman's Almanack'' appeared annually in London from 1704 to 1841 after which it was succeeded by '' The Lady's and Gentleman's Diary''. It featured material relating to calendars etc. including sunrise and sunset times ...
: or, the Woman's Almanack'', designated as Question attributed to Upnorensis (an unknown historical figure), stated thus:
Observing a horse tied to feed in a gentlemen's park, with one end of a rope to his fore foot, and the other end to one of the circular iron rails, enclosing a pond, the circumference of which rails being 160 yards, equal to the length of the rope, what quantity of ground at most, could the horse feed?
The related problem involving area in the interior of a circle without reference to barnyard animals first appeared in 1894 in the first edition of the renown journal ''
American Mathematical Monthly
''The American Mathematical Monthly'' is a peer-reviewed scientific journal of mathematics. It was established by Benjamin Finkel in 1894 and is published by Taylor & Francis on behalf of the Mathematical Association of America. It is an exposi ...
''. Attributed to Charles E. Myers, it was stated as:
A circle containing one acre is cut by another whose center is on the circumference of the given circle, and the area common to both is one-half acre. Find the radius of the cutting circle.
The solutions in both cases are non-trivial but yield to straightforward application of trigonometry, analytical geometry or integral calculus. Both problems are intrinsically
transcendental – they do not have closed-form analytical solutions in the Euclidean plane. The numerical answers must be obtained by an iterative approximation procedure. The goat problems do not yield any new mathematical insights; rather they are primarily exercises in how to artfully deconstruct problems in order to facilitate solution.
Three-dimensional analogues and planar boundary/area problems on other shapes, including the obvious rectangular barn and/or field, have been proposed and solved. A generalized solution for any smooth convex curve like an ellipse, and even unclosed curves, has been formulated.
Exterior grazing problem
400px, Goat tethered to silo at ''v'', grazing an area under an involute
The question about the grazable area outside a circle is considered. This concerns a situation where the animal is tethered to a silo. The complication here is that the grazing area overlaps around the silo (i.e., in general, the tether is longer than one half the circumference of the silo): the goat can only eat the grass once, he can't eat it twice. The answer to the problem as proposed was given in the 1749 issue of the magazine by a Mr. Heath, and stated as 76,257.86 sq.yds. which was arrived at partly by "trial and a table of logarithms". The answer is not so accurate as the number of digits of precision would suggest. No analytical solution was provided.
A useful approximation
Let tether length ''R'' = 160 yds. and silo radius ''r'' = ''R''/(2) yds. The involute in the fourth quadrant is a nearly circular arc. One can imagine a circular segment with the same perimeter (arc length) would enclose nearly the same area; the radius and therefore the area of that segment could be readily computed. The arc length of an involute is given by
so the arc length , FG, of the involute in the fourth quadrant is
. Let ''c'' be the length of an arc segment of the involute between the ''y''-axis and a vertical line tangent to the silo at ''θ'' = 3/2; it is the arc subtended by ''Φ''.
(while the arc is minutely longer than ''r'', the difference is negligible). So
. The arc length of a circular arc is
and ''θ'' here is /2 radians of the fourth quadrant, so
, ''r'' the radius of the circular arc is
and the area of the circular segment bounded by it is
. The area of the involute excludes half the area of the silo (1018.61) in the fourth quadrant, so its approximate area is 18146, and the grazable area including the half circle of radius ''R'', (
) totals
. That is 249 sq.yds. greater than the correct area of 76256, an error of just 0.33%. This method of approximating may not be quite so good for angles < 3/2 of the involute.
Solution by integrating with polar coordinates
Find the area between a circle and its involute over an angle of 2 to −2 excluding any overlap. In Cartesian coordinates, the equation of the involute is transcendental; doing a line integral there is hardly feasible. A more felicitous approach is to use polar coordinates (''z'',''θ''). Because the "sweep" of the area under the involute is bounded by a tangent line (see diagram and derivation below) which is not the boundary (
) between overlapping areas, the decomposition of the problem results in four computable areas: a half circle whose radius is the tether length (''A''
1); the area "swept" by the tether over an angle of 2 (''A''
2); the portion of area ''A''
2 from ''θ'' = 0 to the tangent line segment
(''A''
3); and the wedge area ''qFtq'' (''A''
4). So, the desired area ''A'' is ''A''
1 + (''A''
2 − ''A''
3 + ''A''
4) · 2. The area(s) required to be computed are between two quadratic curves, and will necessarily be an integral or difference of integrals.
The primary parameters of the problem are
, the tether length defined to be 160yds, and
, the radius of the silo. There is no necessary relationship between
and
, but here
is the radius of the circle whose circumference is
. If one defines the point of tethering
(see diagram, above) as the origin with the circle representing the circumference of the pond below the ''x''-axis, and
on the ''y''-axis below the circle representing the point of intersection of the tether when wound clockwise and counterclockwise, let
be a point on the circle such that the tangent at
intersects
, and
+
Is the length of the tether. Let
be the point of intersection of the circumference of the pond on the y-axis (opposite to
) below the origin. Then let acute
be
.
The area under the involute is a function of
because it is an integral over a quadratic curve. The area has a fixed boundary defined by the parameter
(i.e. the circumference of the silo). In this case the area is inversely proportional to
, i.e. the larger
, the smaller the area of the integral, and the circumference is a linear function of
(
). So we seek an expression for the area under the involute
.
First, the area ''A''
1 is a half circle of radius
so
Next compute the area between the circumference of the pond and involute. Compute the area in the tapering "tail" of the involute, i.e. the overlapped area (note, on account of the tangent ''tF'', that this area includes the wedge section, area ''A''
4, which will have to be added back in during the final summation). Recall that the area of a circular sector is
if the angle is in radians. Imagine an infinitely thin circular sector from
to
subtended by an infinitely small angle
. Tangent to
, there is a corresponding infinitely thin sector of the involute from
to
subtending the same infinitely small angle
. The area of this sector is
where
is the radius at some angle
, which is
, the arc length of the circle so far "unwrapped" at angle
. The area under the involute is the sum of all the infinitely many infinitely thin sectors
through some angle
. This sum is
:
The bounds of the integral represent the area under the involute in the fourth quadrant between
and
. The angle is measured on the circle, not on the involute, so it is less than
by some angle designated
.
Next, find the angle
. Let
.
is complementary to the opposite angle of the triangle whose right angle is at point t; and also complementary to that angle in the third quadrant of the circle.
is the unrolled arc
, so its arclength is
times the central angle. So
.
is also a leg of the triangle vFtv so
and
. Equating the 2 expressions for
and solving for
, the following equation is obtained:
. That is a transcendental equation that can be solved approximately by iterative substitution of
, polynomial expansion of
, or an approximation method like Newton–Raphson. A constructive way to obtain a quick and very accurate estimate of
is: draw a diagonal from point
on the circumference of the pond to its intersection on the y-axis. The length of the diagonal is 120yds. because it is
of the tether. So the other leg of the triangle, the hypotenuse as drawn, is
yds. So
radians, rounded to three places.