On a

steam locomotive A steam locomotive is a locomotive that provides the force to move itself and other vehicles by means of the expansion of steam. It is fuelled by burning combustible material (usually coal, Fuel oil, oil or, rarely, Wood fuel, wood) to heat ...

, a driving wheel is a powered wheel which is driven by the locomotive's

piston A piston is a component of reciprocating engines, reciprocating pumps, gas compressors, hydraulic cylinders and pneumatic cylinders, among other similar mechanisms. It is the moving component that is contained by a cylinder (engine), cylinder a ...

s (or

turbine A turbine ( or ) (from the Greek , ''tyrbē'', or Latin ''turbo'', meaning vortex) is a rotary mechanical device that extracts energy from a fluid flow and converts it into useful work. The work produced can be used for generating electrical ...

, in the case of a

steam turbine locomotive A steam turbine locomotive was a steam locomotive which transmitted steam power to the wheels via a steam turbine. Numerous attempts at this type of locomotive were made, mostly without success. In the 1930s this type of locomotive was seen as a ...

). On a conventional, non-articulated locomotive, the driving wheels are all coupled together with side rods (also known as

coupling rod A coupling rod or side rod connects the driving wheels of a locomotive. Steam locomotives in particular usually have them, but some diesel and electric locomotives, especially older ones and shunter locomotives, also have them. The coupling ro ...

s); normally one pair is directly driven by the

main rod A connecting rod, also called a 'con rod', is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaf ...

(or

connecting rod A connecting rod, also called a 'con rod', is the part of a reciprocating engine, piston engine which connects the piston to the crankshaft. Together with the crank (mechanism), crank, the connecting rod converts the reciprocating motion of the p ...

) which is connected to the end of the

piston rod In a piston engine, a piston rod joins a piston to the crosshead and thus to the connecting rod that drives the crankshaft or (for steam locomotives) the driving wheels. Internal combustion engines, and in particular all current automobile engin ...

; power is transmitted to the others through the side rods. On

diesel Diesel may refer to: * Diesel engine, an internal combustion engine where ignition is caused by compression * Diesel fuel, a liquid fuel used in diesel engines * Diesel locomotive, a railway locomotive in which the prime mover is a diesel engine ...

and

electric locomotive An electric locomotive is a locomotive powered by electricity from overhead lines, a third rail or on-board energy storage such as a Battery (electricity), battery or a supercapacitor. Locomotives with on-board fuelled prime mover (locomotive), ...

s, the driving wheels may be directly driven by the

traction motor A traction motor is an electric motor used for propulsion of a vehicle, such as locomotives, electric vehicle, electric or hydrogen vehicles, or electric multiple unit trains. Traction (engineering), Traction motors are used in electrically powe ...

s. Coupling rods are not usually used, and it is quite common for each axle to have its own motor.

Jackshaft A jackshaft, also called a countershaft, is a common mechanical design component used to transfer or synchronize rotational force in a machine. A jackshaft is often just a short stub with supporting bearings on the ends and two pulleys, gears ...

drive and coupling rods were used in the past (e.g. in the Swiss Crocodile locomotive) but their use is now confined to shunter locomotives. On an

articulated locomotive An articulated locomotive is a steam locomotive (rarely, an electric locomotive) with one or more engine units that can move independently of the main frame. Articulation allows the operation of locomotives that would otherwise be too large to ...

or a duplex locomotive, driving wheels are grouped into sets with wheels within each set linked together.

Diameter

Driving wheels are generally larger than

leading In typography, leading ( ) is the space between adjacent lines of type; the exact definition varies. In hand typesetting, leading is the thin strips of lead (or aluminium) that were inserted between lines of type in the composing stick to incre ...

trailing wheel On a steam locomotive, a trailing wheel or trailing axle is generally an unpowered wheel or axle (Wheelset (rail transport), wheelset) located behind the driving wheels. The axle of the trailing wheels is usually located in a trailing Bogie, t ...

s. Since a conventional steam locomotive is directly driven, one of the few ways to '

gear A gear or gearwheel is a rotating machine part typically used to transmit rotational motion and/or torque by means of a series of teeth that engage with compatible teeth of another gear or other part. The teeth can be integral saliences or ...

' a locomotive for a particular performance goal is to size the driving wheels appropriately. Freight locomotives generally had driving wheels between in diameter; dual-purpose locomotives generally between , and passenger locomotives between or so. The driving wheels on express passenger locomotives have come down in diameter over the years, e.g. from on the

GNR Stirling 4-2-2 The Great Northern Railway (Great Britain), Great Northern Railway (GNR) No. 1 class Stirling Single is a class of steam locomotive designed for Express train, express passenger work. Designed by Patrick Stirling (railway engineer), Patrick St ...

of 1870 to on the SR Merchant Navy Class of 1941. This is because improvements in valve design allowed for higher piston speeds.

Flangeless wheels

Some long-wheelbase locomotives (four or more coupled axles) were equipped with blind drivers. These were driving wheels without the usual

flange A flange is a protruded ridge, lip or rim (wheel), rim, either external or internal, that serves to increase shear strength, strength (as the flange of a steel beam (structure), beam such as an I-beam or a T-beam); for easy attachment/transfer o ...

s, which allowed them to negotiate tighter curves without binding. Some three-driving-axle locomotives also had flangeless wheels on the middle axle, such as

Everett Railroad 11 Everett Railroad No. 11 is a 2-6-0 "Mogul" type steam locomotive. It was built in 1920 by the American Locomotive Company's Cooke Works for export to Cuba, but it remained in the United States and was sold to the Narragansett Pier Railroad in 1 ...

, and the

NZR WH class The NZR WH class was a class of three steam locomotives built by Manning Wardle in 1884 for service on New Zealand's private Wellington and Manawatu Railway Company (WMR). They did not acquire their WH classification until 1908 when WMR was nati ...

Balancing

On locomotives with

side rod A coupling rod or side rod connects the driving wheels of a locomotive. Steam locomotives in particular usually have them, but some Diesel locomotive, diesel and Electric locomotive, electric locomotives, especially older ones and switcher locom ...

s, including most

steam Steam is water vapor, often mixed with air or an aerosol of liquid water droplets. This may occur due to evaporation or due to boiling, where heat is applied until water reaches the enthalpy of vaporization. Saturated or superheated steam is inv ...

and

jackshaft A jackshaft, also called a countershaft, is a common mechanical design component used to transfer or synchronize rotational force in a machine. A jackshaft is often just a short stub with supporting bearings on the ends and two pulleys, gears ...

locomotives, the driving wheels have weights to balance the weight of the coupling and connecting rods. The crescent-shaped balance weight is clearly visible in the illustrative image.

Whyte notation

In the

Whyte notation The Whyte notation is a classification method for steam locomotives, and some internal combustion locomotives and electric locomotives, by wheel arrangement. It was devised by Frederick Methvan Whyte, and came into use in the early twenti ...

, driving wheels are designated by the middle number or numbers in the set. The

UIC classification The UIC classification of locomotive axle arrangements, sometimes known as the German classification''The Railway Data File''. Leicester: Silverdale, 2000. p. 52. . or German system,Kalla-Bishop P.M. & Greggio, Luciano, ''Steam Locomotives'', Cr ...

system counts the number of axles rather than the number of wheels and driving wheels are designated by letters rather than numbers. The suffix 'o' is used to indicate independently-powered axles. The number of driving wheels on locomotives varied quite a bit. Some early locomotives had as few as two driving wheels (one axle). The largest number of total driving wheels was 24 (twelve axles) on the

2-8-8-8-2 A triplex locomotive was a steam locomotive that divided the driving force on its wheels by using three pairs of cylinders to drive three sets of driving wheels. Any such locomotive will inevitably be articulated. All triplex locomotives built w ...

and 2-8-8-8-4 locomotives. The largest number of coupled driving wheels was 14 (seven axles) on the ill-fated AA20

4-14-4 The SZD Class AA20 was a one-off experimental 4-14-4 steam locomotive constructed in the Soviet Union by Krupp and the Voroshilovgrad Locomotive Factory in 1934 for the Sovetskie Zheleznye Dorogi (SŽD). Two locomotives were set to be built, b ...

locomotive.

Other uses of the term ''driving wheel''

The term ''driving wheel'' is sometimes used to denote the '' drive sprocket'' which moves the track on tracked vehicles such as

tank A tank is an armoured fighting vehicle intended as a primary offensive weapon in front-line ground combat. Tank designs are a balance of heavy firepower, strong armour, and battlefield mobility provided by tracks and a powerful engine; ...

s and

bulldozer A bulldozer or dozer (also called a crawler) is a large tractor equipped with a metal #Blade, blade at the front for pushing material (soil, sand, snow, rubble, or rock) during construction work. It travels most commonly on continuous tracks, ...

In popular culture

Many American roots artists, such as

The Byrds The Byrds () were an American Rock music, rock band formed in Los Angeles, California, in 1964. The band underwent multiple lineup changes throughout its existence, with frontman Roger McGuinn (known as Jim McGuinn until mid-1967) being the so ...

Tom Rush Tom Rush (born February 8, 1941) is an American folk and blues singer, guitarist, and songwriter whose success helped launch the careers of other singer-songwriters in the 1960s and who has continued his own singing career for 60 years. Life ...

The Black Crowes The Black Crowes are an American rock band formed in Atlanta, Georgia, in 1984. Their discography includes ten studio albums, four live albums and several charting singles. The band was signed to Def American Recordings in 1989 by producer Geo ...

and the Canadian band

Cowboy Junkies Cowboy Junkies are an alternative country and folk rock band formed in Toronto, Ontario, Canada in 1985 by Alan Anton (bassist), Michael Timmins (songwriter, guitarist), Peter Timmins (drummer) and Margo Timmins (vocalist). The three Timminses ...

have performed a song written by

David Wiffen David Wiffen (born 11 March 1942) is an English-Canadian folk singer-songwriter. Two of his songs, "Driving Wheel" and "More Often Than Not", have become cover standards. Early life Wiffen was born in Redhill, Surrey, England.

called "Driving Wheel", with the lyrics "I feel like some old engine/ That's lost my driving wheel." These lyrics are a reference to the traditional blues song "Broke Down Engine Blues" by

Blind Willie McTell Blind Willie McTell (born William Samuel McTier; May 5, 1898 – August 19, 1959) was an American Piedmont blues and ragtime singer, songwriter and guitarist. He played in a fluid, syncopated finger picking guitar style common among many Eas ...

, 1931. It was later directly covered by

Bob Dylan Bob Dylan (legally Robert Dylan; born Robert Allen Zimmerman, May 24, 1941) is an American singer-songwriter. Described as one of the greatest songwriters of all time, Dylan has been a major figure in popular culture over his nearly 70-year ...

and

Johnny Winter John Dawson Winter III (February 23, 1944 – July 16, 2014) was an American singer, guitarist, songwriter, and record producer. Winter was known for his high-energy blues rock albums, live performances, and slide guitar playing from the late 1 ...

. Many versions of the American folk song "

In the Pines "In the Pines" (Roud 3421) is a traditional American folk song originating from two songs, "In the Pines" and "The Longest Train", both of whose authorship is unknown and date back to at least the 1870s. The songs originated in the Southern Appal ...

" performed by artists such as Leadbelly,

Mark Lanegan Mark William Lanegan (November 25, 1964 – February 22, 2022) was an American singer and songwriter. First becoming prominent as the lead singer for the early grunge band Screaming Trees, he was also known as a member of Queens of the Stone Age ...

(on ''

The Winding Sheet ''The Winding Sheet'' is the debut studio album by alternative rock artist Mark Lanegan. It was released in 1990 on Sub Pop. The album was Lanegan's first solo work, and is notable in its departure from the characteristic sound of Screaming Trees, ...

''), and

Nirvana Nirvana, in the Indian religions (Jainism, Hinduism, Buddhism, and Sikhism), is the concept of an individual's passions being extinguished as the ultimate state of salvation, release, or liberation from suffering ('' duḥkha'') and from the ...

(On ''

MTV Unplugged In New York ''MTV Unplugged in New York'' is the first live album by the American rock band Nirvana, released by DGC Records on November 1, 1994, nearly seven months after the suicide of Kurt Cobain. It was part of the cable television series ''MTV Unplug ...

'') reference a decapitated man's head found in a driving wheel. In addition, it is likely that Chuck Berry references the locomotive driving wheel in "Johnny B. Goode" when he sings, "the engineers would see him sitting in the shade / Strumming with the rhythm that the drivers made."

References

* {{Locomotive running gear Steam locomotive technologies Train wheels