Berkelium Compounds

Berkelium forms a number of chemical compounds, where it normally exists in an oxidation state of +3 or +4, and behaves similarly to its lanthanide analogue, terbium. Like all actinides, berkelium easily dissolves in various aqueous inorganic acids, liberating gaseous hydrogen and converting into the trivalent oxidation state. This trivalent state is the most stable, especially in aqueous solutions, but tetravalent berkelium compounds are also known. The existence of divalent berkelium salts is uncertain and has only been reported in mixed lanthanum chloride-strontium chloride melts. Aqueous solutions of Bk³⁺ ions are green in most acids. The color of the Bk⁴⁺ ions is yellow in hydrochloric acid and orange-yellow in sulfuric acid.Peterson, p. 55Holleman, p. 1956 Berkelium does not react rapidly with oxygen at room temperature, possibly due to the formation of a protective oxide surface layer; however, it reacts with molten metals, hydrogen, halogens, chalcogens and pnictogens to form various binary compounds.Peterson, p. 45 Berkelium can also form several organometallic compounds.

Oxides

Two oxides of berkelium are known, with berkelium in the +3 (Bk₂O₃) and +4 (BkO₂) oxidation states. Berkelium(IV) oxide is a brown solid that crystallizes in a cubic (fluorite) crystal structure with the space group ''Fmm'' and the coordination numbers of Bk and O The lattice parameter is 533.4 ± 0.5 pm.

Berkelium(III) oxide, a yellow-green solid, is formed from BkO₂ by reduction with hydrogen:

:$\mathrm$

The compound has a melting point of 1920 °C,Holleman, p. 1972 body-centered cubic crystal lattice and a lattice constant ''a'' = 1088.0 ± 0.5 pm. Upon heating to 1200 °C, the cubic Bk₂O₃ transforms to a monoclinic structure, which further converts to a hexagonal phase at 1750 °C; the latter transition is reversible. Such three-phase behavior is typical for the actinide sesquioxides.Peterson, p. 51

A divalent oxide BkO has been reported as a brittle gray solid with a face centered cubic (''fcc'') structure and a lattice constant ''a'' = 496.4 pm, but its exact chemical composition is uncertain.

Halides

In halides, berkelium assumes the oxidation states +3 and +4.Holleman, p. 1969 The +3 state is most stable, especially in solutions, and the tetravalent halides BkF₄ and Cs₂BkCl₆ are only known in the solid phase.Peterson, p. 47 The coordination of the berkelium atom in its trivalent fluoride and chloride is tricapped trigonal prismatic, with a coordination number of 9. In the trivalent bromide, it is bicapped trigonal prismatic (coordination 8) or octahedral (coordination 6), and in the iodide it is octahedral.

Fluorides

Berkelium(IV) fluoride (BkF₄) is a yellow-green ionic solid which crystallizes in the monoclinic crystal system (Pearson symbol mS60, space group C2/c No. 15, lattice constants ''a'' = 1247 pm, ''b'' = 1058 pm, ''c'' = 817 pm) and is isotypic with uranium tetrafluoride or zirconium(IV) fluoride.Peterson, p. 48

Berkelium(III) fluoride (BkF₃) is also a yellow-green solid, but it has two crystalline structures. The most stable phase at low temperatures has an orthorhombic symmetry, isotypic with yttrium(III) fluoride (Pearson symbol oP16, space group Pnma, No. 62, ''a'' = 670 pm, ''b'' = 709 pm, ''c'' = 441 pm). Upon heating to 350 to 600 °C, it transforms to a trigonal structure found in lanthanum(III) fluoride (Pearson symbol hP24, space group Pc1, No. 165, ''a'' = 697 pm, ''c'' = 714 pm).

Chlorides

Visible amounts of berkelium(III) chloride (BkCl₃) were first isolated and characterized in 1962, and weighed only 3 billionths of a gram. It can be prepared by introducing hydrogen chloride vapors into an evacuated quartz tube containing berkelium oxide at a temperature of about 500 °C. This green solid has a melting point of 603 °C and crystallizes in the hexagonal crystal system isotypic with uranium(III) chloride (Pearson symbol hP8, space group P6₃/m, No. 176). Upon heating to just below its melting point, BkCl₃ converts into an orthorhombic phase.Peterson, p. 52 The hexahydrate BkCl₃·6H₂O ( berkelium trichloride hexahydrate) has a monoclinic structure with the lattice constants ''a'' = 966 pm, ''b'' = 654 pm and ''c'' = 797 pm. Another berkelium(III) chloride, Cs₂NaBkCl₆ can be crystallized from a chilled aqueous solution containing berkelium(III) hydroxide, hydrochloric acid and caesium chloride. It has a face-centered cubic structure where Bk(III) ions are surrounded by chloride ions in an octahedral configuration.

The ternary berkelium(IV) chloride Cs₂BkCl₆ is obtained by dissolving berkelium(IV) hydroxide in a chilled solution of caesium chloride in concentrated hydrochloric acid. It forms orange hexagonal crystals with the lattice constants ''a'' = 745.1 pm and ''c'' = 1209.7 pm. The average radius of the BkCl₆²⁻ ion in this compound is estimated as 270 pm.

Bromides and iodides

Two forms of berkelium(III) bromide are known, a monoclinic with berkelium coordination 6 and orthorhombic with coordination 8;Peterson, p. 38 the latter is less stable and transforms to the former phase upon heating to about 350 °C. An important phenomenon for radioactive solids has been studied for these two crystal forms: the structures of fresh and aged ²⁴⁹BkBr₃ samples were studied using X-ray diffraction over a period longer than 3 years, so that various fractions of ²⁴⁹Bk had beta decayed to ²⁴⁹ Cf. No change in structure was observed upon the ²⁴⁹BkBr₃—²⁴⁹CfBr₃ transformation, even though the orthorhombic bromide was previously unknown for californium. However, other differences were noted for ²⁴⁹BkBr₃ and ²⁴⁹CfBr₃. For example, the latter could be reduced with hydrogen to²⁴⁹CfBr₂, but the former could be not – this result was reproduced on individual ²⁴⁹BkBr₃ and ²⁴⁹CfBr₃ samples, as well on the samples containing both bromides. The intergrowth of californium in berkelium occurs at a rate of 0.22% per day and is an intrinsic obstacle in studying berkelium properties. Besides a chemical contamination, ²⁴⁹Cf, as an alpha emitter brings undesirable self-damage of the crystal lattice due to the resulting self-heating. This can be avoided by performing measurements as a function of time and extrapolating the obtained results.

Berkelium(III) iodide forms hexagonal crystals with the lattice constants ''a'' = 758.4 pm and ''c'' = 2087 pm. The known oxyhalides of berkelium include BkOCl, BkOBr and BkOI; they all crystallize in a tetragonal lattice.

Other inorganic compounds

Pnictides

The monopnictides of berkelium-249 are known for the elements nitrogen, phosphorus, arsenic and antimony. They are prepared by the reaction of either berkelium(III) hydride (BkH₃) or metallic berkelium with these elements at elevated temperatures (about 600 °C) under high vacuum in quartz ampoules. They crystallize in the cubic crystal system with the lattice constant of 495.1 pm for BkN, 566.9 pm for BkP, 582.9 for BkAs and 619.1 pm for BkSb. These lattice constant values are smaller than those in curium pnictides, but are comparable to those of terbium pnictides.

Chalcogenides

Berkelium(III) sulfide, Bk₂S₃, has been prepared by either treating berkelium oxide with a mixture of hydrogen sulfide and carbon disulfidevapors at 1130 °C, or by directly reacting metallic berkelium with sulfur. These procedures yield brownish-black crystals with a cubic symmetry and lattice constant ''a'' = 844 pm.

Other compounds

Berkelium(III) and berkelium(IV) hydroxides are both stable in 1 M sodium hydroxide solutions. Berkelium(III) phosphate (BkPO₄) has been prepared as a solid, which shows strong fluorescence under argon laser (514.5 nm line) excitation. Berkelium hydrides are produced by reacting metal with hydrogen gas at temperatures about 250 °C. They are non-stoichiometric with the nominal formula BkH_2+x (0 < x < 1). Whereas the trihydride has a hexagonal symmetry, the dihydride crystallizes in an ''fcc'' structure with the lattice constant ''a'' = 523 pm.Peterson, p. 53 Several other salts of berkelium are known, including Bk₂O₂S, Bk(NO₃)₃·4H₂O, BkCl₃·6H₂O, Bk₂(SO₄)₃·12H₂O and Bk₂(C₂O₄)₃·4H₂O. Thermal decomposition at about 600 °C in an argon atmosphere (to avoid oxidation to BkO₂) of Bk₂(SO₄)₃·12H₂O yields the body-centered orthorhombic crystals of berkelium(IV) oxysulfate (Bk₂O₂SO₄). This compound is thermally stable to at least 1000 °C in an inert atmosphere.Peterson, p. 54

Organoberkelium compounds

Berkelium forms a trigonal (η⁵–C₅H₅)₃Bk complex with three cyclopentadienyl rings, which can be synthesized by reacting berkelium(III) chloride with the molten beryllocene Be(C₅H₅)₂ at about 70 °C. It has an amber color and orthorhombic symmetry, with the lattice constants of ''a'' = 1411 pm, ''b'' = 1755 pm and ''c'' = 963 pm and the calculated density of 2.47 g/cm³. The complex is stable to heating to at least 250 °C, and sublimates without melting at about 350 °C. The high radioactivity of berkelium gradually destroys the compound within a period of weeks. One C₅H₅ ring in (η⁵–C₅H₅)₃Bk can be substituted by chlorine to yield k(C₅H₅)₂Clsub>2. The optical absorption spectra of this compound are very similar to those of (η⁵–C₅H₅)₃Bk.Peterson, p. 41

Berkelium(III) polyborate(Bk ₆O₈(OH)₅, produced by the reaction of berkelium(III) chloride and boric acid, is a yellow solid which is unusual in the fact that the berkelium is covalently pound to the borate, similar to californium(III) polyborate.

See also

*Terbium compounds
*Californium compounds

References

Bibliography

*
* Holleman, Arnold F. and Wiberg, Nils ''Textbook of Inorganic Chemistry'', 102 Edition, de Gruyter, Berlin 2007, .
* Peterson J. R. and Hobart D. E
"The Chemistry of Berkelium"
in Harry Julius Emeléus (Ed.) ''Advances in inorganic chemistry and radiochemistry'', Volume 28, Academic Press, 1984 , pp. 29–64,

{{Chemical compounds by element

B