Alvin R

''Alvin'' (DSV-2) is a crewed deep-ocean research submersible owned by the United States Navy and operated by the Woods Hole Oceanographic Institution (WHOI) of Woods Hole, Massachusetts. The original vehicle was built by General Mills' Electronics Group in Minneapolis, Minnesota. Named to honor the prime mover and creative inspiration for the vehicle, Allyn Vine, ''Alvin'' was commissioned on June 5, 1964.

The submersible is launched from the deep submergence support vessel , which is also owned by the U.S. Navy and operated by WHOI. The submersible has made more than 5,200 dives, carrying two scientists and a pilot, observing the lifeforms that must cope with super-pressures and move about in total darkness, as well as exploring the wreck of ''Titanic''. Research conducted by ''Alvin'' has been featured in nearly 2,000 scientific papers.

Design

''Alvin'' was designed as a replacement for bathyscaphes and other less maneuverable oceanographic vehicles. Its more nimble design was made possible in part by the development of syntactic foam, which is buoyant and yet strong enough to serve as a structural material at great depths.

The vessel weighs 17 tons. It allows for two scientists and one pilot to dive for up to nine hours at . The submersible features two robotic arms and can be fitted with mission-specific sampling and experimental gear. The plug hatch of the vessel is in diameter and somewhat thicker than the thick titanium sphere pressure hull; it is held in place by the pressure of the water above it.

In an emergency, if previous versions of ''Alvin'' were stuck underwater with occupants inside, an upper part of the submersible including the titanium sphere could be released using controls inside the hull. This would then rise to the surface uncontrolled. The current version of the vehicle uses releasable weights and emergency releases on jettisonable equipment.

Harold E. Froehlich was one of the principal designers of ''Alvin''.

History

Early career

''Alvin'', first of its ship class of deep submergence vehicle (DSV), was built to dive to . Each of the ''Alvin-class'' DSVs have different depth capabilities. However, ''Alvin'' is the only one seconded to the National Oceanic and Atmospheric Administration (NOAA), with the others staying with the United States Navy.

''Alvin''s first deep sea tests took place off Andros Island, the Bahamas, where it made a successful 12-hour, uncrewed tethered test dive. On July 20, 1965 ''Alvin'' made its first crewed dive for the Navy to obtain certification. On March 17, 1966, ''Alvin'' was used to locate a submerged 1.45-megaton hydrogen bomb lost in a United States Air Force midair accident over Palomares, Spain. The bomb, found resting on a steep slope nearly deep, was located by ''Alvin'' but the submersible had difficulty raising it up, initially causing it to fall deeper to . The bomb was eventually raised intact on April 7 by a Navy CURV-I and the experience gained by the ''Alvin'' crew's 34 dives with over 220 hours logged led to new improvements to the vehicle's navigations systems.
On July 6, 1967, the ''Alvin'' was attacked by a swordfish during dive 202. The swordfish became trapped in the ''Alvin''s skin. The attack took place at below the surface. The fish was recovered at the surface and cooked for dinner. During Dive 209, on September 24, 1968 ''Alvin'' found an F6F Hellcat, #42782, 125 miles southeast of Nantucket. The aircraft had ditched September 30, 1944 during carrier qualifications, with the pilot surviving.

Sinking

''Alvin'', aboard the Navy tender ship ''Lulu'', was lost as it was being transported on October 26, 1968. ''Lulu'', a vessel created from a pair of decommissioned U.S. Navy pontoon boats with a support structure added on, was lowering ''Alvin'' over the side when two steel cables snapped. There were three crew members aboard ''Alvin'' at the time, and the hatch was open. Situated between the pontoons with no deck underneath, ''Alvin'' entered the water and rapidly began to sink. The three crew members managed to escape, but ''Alvin'' flooded and sank in of water in the Atlantic Ocean at approximately , about south of Nantucket Island.''SALVOPS 69'', Washington, D.C.:Department of the Navy Naval Ship Systems Command, 1969, pp. 1–18.

Severe weather prevented the recovery of ''Alvin'' throughout late 1968, but it was photographed at the bottom of the Atlantic Ocean in June 1969 by a sled towed by USS ''Mizar''. ''Alvin'' was found to be upright and appeared intact except for damage to the stern. It was decided to attempt recovery; although no object of ''Alvin''s size had ever been recovered from a depth of , recovery was "deemed to be within the state of the art". In August 1969, the '' Aluminaut'', a DSV built by Reynolds Metals Company, descended to ''Alvin'' but had trouble attaching the required lines, and side effects from Hurricane Camille were producing worsening weather, causing the team to return to Woods Hole to regroup. The second attempt started on August 27, and ''Aluminaut'' was able to secure a line and safety slings to ''Alvin'' and wrap a nylon net around its hull, allowing it to be hauled up by ''Mizar''. ''Alvin'' was towed, submerged at , at a speed of , back to Woods Hole.

Post-sinking refit

In 1973, ''Alvin''s pressure hull was replaced by a newer titanium pressure hull. The new hull extended the submersible's depth rating.

Mid-Atlantic Ridge

With a new, stronger pressure hull ''Alvin'' could now reach the floor of the rift valley of this seafloor spreading center. In the summer of 1974 American and French scientists joined in Project FAMOUS to explore the creation of new sea floor at this spreading center. The French provided submersibles '' Archimède'' and ''CYANA''. A total of forty-four dives were completed that succeeded in defining the crustal accretion zone in the floor of the rift valley.

Hydrothermal vents

Marine geologists using ''Alvin'' in the Pacific Ocean discovered deep-sea hydrothermal vents and associated biologic communities during two expeditions to ocean spreading centers. In 1977 scientists in ''Alvin'' discovered low temperature (~20 °C) vents on the Galapagos spreading center east of those same islands. During the RISE expedition in 1979 scientists using ''Alvin'' discovered high temperature vents (380 °C) popularly known as ‘ black smokers’ on the crest of the East Pacific Rise at 21° N. These discoveries revealed deep-sea ecosystems that exist without sunlight and are based on chemosynthesis.

Exploration of RMS ''Titanic''

''Alvin'' was involved in the exploration of the wreckage of in 1986. Launched from her support ship , she carried Dr. Robert Ballard and two companions to the wreckage of the White Star Liner ''Titanic,'' which sank in 1912 after striking an iceberg while crossing the North Atlantic Ocean on her maiden voyage.

''Alvin'', accompanied by a small remotely operated vehicle (ROV) named '' Jason Jr.'', was able to conduct detailed photographic surveys and inspections of ''Titanic''s wreckage. Many of the photographs of the expedition have been published in the magazine of the National Geographic Society, which was a major sponsor of the expedition.

The Woods Hole Oceanographic Institution team involved in the ''Titanic'' expedition also explored the wreck of the , a armed with nuclear torpedoes, which sank off the coast of the Azores in 1968 in uncertain circumstances. ''Alvin'' obtained photographic and other environmental monitoring data from the remains of ''Scorpion''.

Recent overhauls

Over the years, ''Alvin'' has undergone many overhauls to improve its equipment and extend its lifetime. In 2001, among other equipment, motor controllers and computer systems were added. The current ''Alvin'' is the same as the original vessel in name and general design only. All components of the vessel, including the frame and personnel sphere, have been replaced at least once. ''Alvin'' is completely disassembled every three to five years for a complete inspection. A new robotic arm was added in 2006.

2008 upgrade

In June 2008 construction started on a stronger, slightly larger personnel sphere which was used to upgrade ''Alvin'', before being used in an entirely new vehicle. The new sphere was designed, and then forged from solid titanium ingots in two equal halves at Ladish Forge, Cudahy, Wisconsin. Then the 15.5 tonnes of titanium was machined and assembled, utilizing five view ports (instead of the previous three) and is designed for depths of over , where ''Alvin''s original depth limit was . This, along with a general upgrade of support systems, instruments and materials. These upgrades allow ''Alvin'' to reach 98% of the ocean floor.

2011 to 2014 rebuild

After one last dive to assess damage to the Gulf of Mexico's seafloor after the ''Deepwater Horizon'' disaster, ''Alvin'' was refitted further, starting January 2011. Alvin began an extensive rebuild, which featured new cameras, lighting, and an enlarged titanium personnel sphere. This three-and-a-half-year effort to upgrade the vessel implemented the core infrastructure to eventually increase its depth capability from to . In 2014, an extensively refitted ''Alvin'' conducted verification testing in the Gulf of Mexico, and was certified to return to service. In March and April 2014, ''Alvin'' was used to explore the site of the 2010 Deepwater Horizon oil spill.

2020 to 2022 upgrade

Starting in 2020, the second phase to upgrade Alvin for operation began; the 2014 rebuild with new, larger titanium, personnel hull and rebuilt structural frame being the first phase. In this phase, Alvin received new titanium ballast spheres, a second Schilling manipulator arm, a 4K imaging system, several new syntactic foam modules, an upgrade to the hydraulic system, and new thrusters. During 2022, Alvin successfully completed sea trials and was certified for operating down to 6500 meters.

Current status

As of 2024, ''Alvin'' is in active service, operated by the Woods Hole Oceanographic Institution. The research ship RV ''Atlantis'' serves as its support ship.

Operation

Like most deep submergence vehicles, ''Alvin'' is normally transported on board its support vessel. It is launched shortly before a dive, and recovered after the dive, using a suitable (LARS) mounted on the support vessel. The support vessel is usually the R/V ''Atlantis'', but several others have been used.

''Alvin'' uses four steel weights (~1.7 cubic feet of steel) to provide negative buoyancy for the trip to the ocean floor. ''Alvin'' contains a ballast and trim system, but the steel weights allow deep dives to be achieved more rapidly. These weights are jettisoned on each dive and left at the bottom.

See also

*
*
*
*
*
*
*
*
*

''Alvin''-class DSV

*
*
*

Other deep submergence vehicles

*
*
* (DSV-1)
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*

References

Further reading

*
*

External links

*

{{DEFAULTSORT:Alvin
1964 ships
Alvin-class deep-submergence vehicles
Maritime incidents in 1968
Ships built in Minnesota
United States submarine accidents
Woods Hole Oceanographic Institution
Research submarines of the United States