The Albatros W.3, company designation VT, was a

biplane A biplane is a fixed-wing aircraft with two main wings stacked one above the other. The first powered, controlled aeroplane to fly, the Wright Flyer, used a biplane wing arrangement, as did many aircraft in the early years of aviation. While ...

torpedo bomber A torpedo bomber is a military aircraft designed primarily to attack ships with aerial torpedoes. Torpedo bombers came into existence just before the World War I, First World War almost as soon as aircraft were built that were capable of carryin ...

floatplane A floatplane is a type of seaplane with one or more slender floats mounted under the fuselage to provide buoyancy. By contrast, a flying boat uses its fuselage for buoyancy. Either type of seaplane may also have landing gear suitable for land, ...

prototype, built for the

Imperial German Navy The Imperial German Navy or the ''Kaiserliche Marine'' (Imperial Navy) was the navy of the German Empire, which existed between 1871 and 1919. It grew out of the small Prussian Navy (from 1867 the North German Federal Navy), which was mainly for ...

during the First World War. Only one was built.

Design and development

The W.3 was designed from the outset as a torpedo bomber, a large two bay biplane powered by two Benz Bz.III engines in

pusher configuration In aeronautical and naval engineering, pusher configuration is the term used to describe a drivetrain of air- or watercraft with propulsion device(s) after the engine(s). This is in contrast to the more conventional tractor configuration, wh ...

mounted on top of the lower wing; these drove two blade

propeller A propeller (often called a screw if on a ship or an airscrew if on an aircraft) is a device with a rotating hub and radiating blades that are set at a pitch to form a helical spiral which, when rotated, exerts linear thrust upon a working flu ...

s, The wings had straight

leading edge The leading edge is the part of the wing that first contacts the air;Crane, Dale: ''Dictionary of Aeronautical Terms, third edition'', page 305. Aviation Supplies & Academics, 1997. alternatively it is the foremost edge of an airfoil sectio ...

s, squared tips and almost constant chord, though the upper

trailing edge The trailing edge of an aerodynamic surface such as a wing is its rear edge, where the airflow separated by the leading edge meets.Crane, Dale: ''Dictionary of Aeronautical Terms, third edition'', page 521. Aviation Supplies & Academics, 1997. ...

was complicated by cut-outs for the propellers and by

ailerons An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft. Ailerons are used in pairs to control the aircraft in roll (or movement around ...

, fitted only to this wing, which increased in chord outwards. There was no stagger, so each pair of

interplane strut In aeronautics, bracing comprises additional structural members which stiffen the functional airframe to give it rigidity and strength under load. Bracing may be applied both internally and externally, and may take the form of struts, which act in ...

s was perpendicular to the wing; the forward member of each pair was at the leading edge and the other at mid-chord. The

fuselage The fuselage (; from the French language, French ''fuselé'' "spindle-shaped") is an aircraft's main body section. It holds Aircrew, crew, passengers, or cargo. In single-engine aircraft, it will usually contain an Aircraft engine, engine as wel ...

was flat sided, with two open,

tandem Tandem, or in tandem, is an arrangement in which two or more animals, machines, or people are lined up one behind another, all facing in the same direction. ''Tandem'' can also be used more generally to refer to any group of persons or objects w ...

cockpit A cockpit or flight deck is the area, on the front part of an aircraft, spacecraft, or submersible, from which a pilot controls the vehicle. The cockpit of an aircraft contains flight instruments on an instrument panel, and the controls th ...

s in the nose ahead of the leading edge and deepest between nose and trailing edge, forming a belly which housed the torpedo. Aft, it became quite slender, with a broad chord, triangular

fin A fin is a thin component or appendage attached to a larger body or structure. Fins typically function as foils that produce lift or thrust, or provide the ability to steer or stabilize motion while traveling in water, air, or other fluids. F ...

and rounded,

balanced rudder Balanced rudders are used by both ships and aircraft. Both may indicate a portion of the rudder surface ahead of the hinge, placed to lower the control loads needed to turn the rudder. For aircraft the method can also be applied to elevator (air ...

. Twin floats, only about half as long as the fuselage, were mounted on individual sets of struts to allow torpedo release between them. One Albatros W.3 was built and supplied to the Imperial German Navy in July 1916. The design was developed into the W.5, five of which were built for the Navy in 1917.

Specifications

References

Bibliography

* * * {{Albatros aircraft W.3 Biplanes 1910s German bomber aircraft Aircraft first flown in 1916