Absolute Radio-frequency Channel Number

In GSM cellular networks, an absolute radio-frequency channel number (ARFCN) is a code that specifies a pair of physical radio carriers used for transmission and reception in a land mobile radio system, one for the uplink signal and one for the downlink signal. ARFCNs for GSM are defined in Specification 45.005 Section 2. There are also other variants of the ARFCN numbering scheme that are in use for other systems that are not GSM. One such example is the TETRA system that has 25 kHz channel spacing and uses different base frequencies for numbering.

Different frequencies (ARFCNs) are used for the frequency-based component of GSMs multiple access scheme (FDMA — frequency-division multiple access). Uplink/downlink channel pairs in GSM are identified by ARFCN. Together with the time-based component (TDMA — time-division multiple access) the physical channel is defined by selecting a certain ARFCN and a certain time slot. Note not to confuse this physical channel with the logical channels (e.g. BCCH — Broadcast Control Channel) that are time-multiplexed onto it under the rules of GSM Specification 05.03.

ARFCN table for common GSM systems

This table shows the common channel numbers and corresponding uplink and downlink frequencies associated with a particular ARFCN, as well as the way to calculate the frequency from the ARFCN number and vice versa.

Observe this table only deals with GSM systems. There are other mobile telecommunications systems that do use ARFCN to number their channels, but they may use different offsets, channel spacing and so on.

Other versions of ARFCN

TETRA uses different channel spacing compared to GSM systems. The standard is 25 kHz spacing and the center frequency of each channel may be offset in a number of fashions such as ±12.5 kHz or even ±6.25 kHz. This makes it more tricky to correlate the ARFCN strictly to a pair of frequencies, you need to know the specifics of the system. Also the duplex spacing is generally 10 MHz in TETRA although other versions are available for certain applications.

In TETRA the ARFCN is always given for the downlink frequency, the uplink is by standard 10 MHz lower in frequency than the downlink frequency.

In UMTS for 3G and 4G mobile telephone systems, ARFCN is replaced with UARFCN and EARFCN which are simpler and always has a direct relation between the frequency and the channel number.

Example ARFCN for TETRA

In many countries in Europe there is a standardised set of frequencies used for ''blue light services'' i.e. the police, firebrigade, rescue and so on. This set of frequencies correspond to ARFCN with a base of 300 MHz and an offset of 12.5 kHz.

To calculate the ARFCN from frequency the following method is used:

$\mathrm = \frac$

Where:
:''f'' is the actual frequency Hz:''f_b'' is the base frequency Hz:''f_o'' is the offset frequency Hz:''f_c'' is the channel spacing frequency Hz
The range of frequencies used in these tetra systems are defined by 380-385 MHz for the uplink (mobile to radio base station) paired with 390-395 MHz for the downlink (radio base station to mobile). Therefore, the base frequency ''f_b'' is 300 MHz (the baseband frequency to relate from) and the offset is 0.0125 MHz (12.5 kHz) and thus we get the relation:

$\mathrm=\frac$

Inseting the frequency for the first channel 390.0125 MHz gives us an ARFCN of 3600.

Calculating the frequency from ARFCN is just the reverse of this:

$f = f_c \cdot \mathrm + f_b + f_o$

See also

* Mobile Allocation Index Offset

References

{{Reflist

GSM standard