|
Optical Coupler
An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. Opto-isolators prevent high voltages from affecting the system receiving the signal.Lee et al., p. 2. Commercially available opto-isolators withstand input-to-output voltages up to 10 kVHasse, p. 145. and voltage transients with speeds up to 25 kV/μs.Joffe and Kai-Sang Lock, p. 279. A common type of opto-isolator consists of an LED and a phototransistor in the same opaque package. Other types of source-sensor combinations include LED-photodiode, LED- LASCR, and lamp-photoresistor pairs. Usually opto-isolators transfer digital (on-off) signals and can act as an electronic switch, but some techniques allow them to be used with analog signals. History The value of optically coupling a solid state light emitter to a semiconductor detector for the purpose of electrical isolation was rec ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Optoisolator Pinout
An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical Signal, signals between two isolated circuits by using light. Opto-isolators prevent high voltages from affecting the system receiving the signal.Lee et al., p. 2. Commercially available opto-isolators withstand input-to-output voltages up to 10 Volt, kVHasse, p. 145. and voltage transients with speeds up to 25 kV/microsecond, μs.Joffe and Kai-Sang Lock, p. 279. A common type of opto-isolator consists of an Light emitting diode, LED and a phototransistor in the same opaque package. Other types of source-sensor combinations include LED-photodiode, LED-thyristor#Photothyristors, LASCR, and lamp (electrical component), lamp-photoresistor pairs. Usually opto-isolators transfer digital (on-off) signals and can act as an electronic switch, but some techniques allow them to be used with analog signals. History The value of optically coupling a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Infrared
Infrared (IR; sometimes called infrared light) is electromagnetic radiation (EMR) with wavelengths longer than that of visible light but shorter than microwaves. The infrared spectral band begins with the waves that are just longer than those of red light (the longest waves in the visible spectrum), so IR is invisible to the human eye. IR is generally (according to ISO, CIE) understood to include wavelengths from around to . IR is commonly divided between longer-wavelength thermal IR, emitted from terrestrial sources, and shorter-wavelength IR or near-IR, part of the solar spectrum. Longer IR wavelengths (30–100 μm) are sometimes included as part of the terahertz radiation band. Almost all black-body radiation from objects near room temperature is in the IR band. As a form of EMR, IR carries energy and momentum, exerts radiation pressure, and has properties corresponding to both those of a wave and of a particle, the photon. It was long known that fires e ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Lightning
Lightning is a natural phenomenon consisting of electrostatic discharges occurring through the atmosphere between two electrically charged regions. One or both regions are within the atmosphere, with the second region sometimes occurring on the land, ground. Following the lightning, the regions become partially or wholly electrically neutralized. Lightning involves a near-instantaneous release of energy on a scale averaging between 200 megajoules and 7 gigajoules. The air around the lightning flash rapidly heats to temperatures of about . There is an emission of electromagnetic radiation across a wide range of wavelengths, some visible as a bright flash. Lightning also causes thunder, a sound from the shock wave which develops as heated gases in the vicinity of the discharge experience a sudden increase in pressure. The most common occurrence of a lightning event is known as a thunderstorm, though they can also commonly occur in other types of energetic weather systems, such ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Optocoupler With Class Y1 Caps
An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. Opto-isolators prevent high voltages from affecting the system receiving the signal.Lee et al., p. 2. Commercially available opto-isolators withstand input-to-output voltages up to 10 kVHasse, p. 145. and voltage transients with speeds up to 25 kV/μs.Joffe and Kai-Sang Lock, p. 279. A common type of opto-isolator consists of an LED and a phototransistor in the same opaque package. Other types of source-sensor combinations include LED-photodiode, LED- LASCR, and lamp-photoresistor pairs. Usually opto-isolators transfer digital (on-off) signals and can act as an electronic switch, but some techniques allow them to be used with analog signals. History The value of optically coupling a solid state light emitter to a semiconductor detector for the purpose of electrical isolation was rec ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Slotted Optical Switch
The slotted optical switch, sometimes known as opto switch or optical switch but not to be confused with the optical component, is a device comprising a photoemitter (e.g. LED) and a photodetector (e.g. photodiode) mounted in a single package so that the photoemitter normally illuminates the photodetector, but an opaque object can be inserted in a slot between them so as to break the beam. Associated Electronic_circuit, circuitry is provided which changes state when the beam is interrupted. For example, the carriage of a computer printer may be fitted with a projection which interrupts the beam of a slotted switch when it reaches the end of its travel, causing circuitry to react appropriately. Another application of the slotted switch is in the type of Mechanical mouse, computer mouse with a rotating ball. The ball measures distances moved by rotating orthogonal shafts which drive optical chopper wheels turning in the slots of slotted switches. This device uses the same basic ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
MOSFET
upright=1.3, Two power MOSFETs in amperes">A in the ''on'' state, dissipating up to about 100 watt">W and controlling a load of over 2000 W. A matchstick is pictured for scale. In electronics, the metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, MOS FET, or MOS transistor) is a type of field-effect transistor (FET), most commonly fabricated by the controlled oxidation of silicon. It has an insulated gate, the voltage of which determines the conductivity of the device. This ability to change conductivity with the amount of applied voltage can be used for amplifying or switching electronic signals. The term ''metal–insulator–semiconductor field-effect transistor'' (''MISFET'') is almost synonymous with ''MOSFET''. Another near-synonym is ''insulated-gate field-effect transistor'' (''IGFET''). The main advantage of a MOSFET is that it requires almost no input current to control the load current under steady-state or low-frequency conditions ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Solid-state Relay
file:Solid-state-contactor.jpg, Solid state contactor file:Solid-state relay.jpg, PCB mount solid-state DIL relay A solid state relay (SSR) is an Electronic switch, electronic switching device that switches on or off when an external voltage (AC or DC) is applied across its control terminals. They serve the same function as an electromechanical relay, but solid-state electronics contain no moving parts and have a longer operational lifetime. Solid state relays were invented in 1971 by the Crydom Controls division of International Rectifier. SSRs consist of a sensor which responds to an appropriate input (control signal), an electronic switching device which switches power to the load circuitry, and a coupling mechanism to enable the control signal to activate this switch without mechanical parts. They may be designed to switch either Alternating current, AC or Direct current, DC loads. Packaged SSRs use power semiconductor devices such as thyristors and transistors, to switch cur ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
TRIAC
A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericized trademark. TRIACs are a subset of thyristors (analogous to a relay in that a small voltage and current can control a much larger voltage and current) and are related to silicon controlled rectifiers (SCRs). TRIACs differ from SCRs in that they allow current flow in both directions, whereas an SCR can only conduct current in a single direction. Most TRIACs can be triggered by applying either a positive or negative voltage to the gate (an SCR requires a positive voltage). Once triggered, SCRs and TRIACs continue to conduct, even if the gate current ceases, until the main current drops below a certain level called the holding current. Gate turn-off thyristors (GTOs) are similar to TRIACs but provide more control by turning off when the gate s ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Silicon-controlled Rectifier
A silicon controlled rectifier or semiconductor controlled rectifier (SCR) is a four-layer solid-state current-controlling device. The name "silicon controlled rectifier" is General Electric's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell Laboratories in 1956. The practical demonstration of silicon controlled switching and detailed theoretical behavior of a device in agreement with the experimental results was presented by Dr Ian M. Mackintosh of Bell Laboratories in January 1958. The SCR was developed by a team of power engineers led by Gordon Hall and commercialized by Frank W. "Bill" Gutzwiller in 1957. Some sources define silicon-controlled rectifiers and thyristors as synonymous while other sources define silicon-controlled rectifiers as a proper subset of the set of thyristors; the latter being devices with at least four layers of alternating n- and p-type mate ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Electric Current
An electric current is a flow of charged particles, such as electrons or ions, moving through an electrical conductor or space. It is defined as the net rate of flow of electric charge through a surface. The moving particles are called charge carriers, which may be one of several types of particles, depending on the Electrical conductor, conductor. In electric circuits the charge carriers are often electrons moving through a wire. In semiconductors they can be electrons or Electron hole, holes. In an Electrolyte#Electrochemistry, electrolyte the charge carriers are ions, while in Plasma (physics), plasma, an Ionization, ionized gas, they are ions and electrons. In the International System of Units (SI), electric current is expressed in Unit of measurement, units of ampere (sometimes called an "amp", symbol A), which is equivalent to one coulomb per second. The ampere is an SI base unit and electric current is a ISQ base quantity, base quantity in the International System of Qua ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Modulation
Signal modulation is the process of varying one or more properties of a periodic waveform in electronics and telecommunication for the purpose of transmitting information. The process encodes information in form of the modulation or message signal onto a carrier signal to be transmitted. For example, the message signal might be an audio signal representing sound from a microphone, a video signal representing moving images from a video camera, or a digital signal representing a sequence of binary digits, a bitstream from a computer. This carrier wave usually has a much higher frequency than the message signal does. This is because it is impractical to transmit signals with low frequencies. Generally, receiving a radio wave requires a radio antenna with a length that is one-fourth of the wavelength of the transmitted wave. For low frequency radio waves, wavelength is on the scale of kilometers and building such a large antenna is not practical. Another purpose of modulation ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
