|
Nickel–cadmium Battery
The nickel–cadmium battery (Ni–Cd battery or NiCad battery) is a type of rechargeable battery using nickel oxide hydroxide and metallic cadmium as electrodes. The abbreviation ''Ni–Cd'' is derived from the chemical symbols of nickel (Ni) and cadmium (Cd): the abbreviation ''NiCad'' is a registered trademark of Saft Groupe S.A., SAFT Corporation, although this brand name is genericized trademark, commonly used to describe all Ni–Cd batteries. Battery (electricity)#Wet cell, Wet-cell nickel–cadmium batteries were invented in 1899. A Ni–Cd battery has a terminal voltage during discharge of around 1.2 volts which decreases little until nearly the end of discharge. The maximum electromotive force offered by a Ni–Cd cell is 1.3V. Ni–Cd batteries are made in a wide range of sizes and capacities, from portable sealed types interchangeable with carbon–zinc dry cells, to large ventilated cells used for standby power and motive power. Compared with other types of rechargeab ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Flashlight
A flashlight (US English) or electric torch (Commonwealth English), usually shortened to torch, is a portable hand-held electric lamp. Formerly, the light source typically was a miniature incandescent light bulb, but these have been displaced by light-emitting diodes (LEDs) since the early 2000s. A typical flashlight consists of the light source mounted in a reflector, a transparent cover (sometimes combined with a lens) to protect the light source and reflector, a battery, and a switch, all enclosed in a case. The invention of the dry cell and miniature incandescent electric lamps made the first battery-powered flashlights possible around 1899. Today, flashlights use mostly light-emitting diodes and run on disposable or rechargeable batteries. Some are powered by the user turning a crank, shaking the lamp, or squeezing it. Some have solar panels to recharge the battery. Flashlights are used as a light source outdoors, in places without permanently installed lighting, during ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Lithium Polymer Battery
A lithium polymer battery, or more correctly, lithium-ion polymer battery (abbreviated as LiPo, LIP, Li-poly, lithium-poly, and others), is a rechargeable battery derived from lithium-ion and lithium-metal battery technology. The primary difference is that instead of using a liquid Lithium salt (such as lithium hexafluorophosphate, LiPF6) held in an organic solvent (such as EC/ DMC/ DEC) as the electrolyte, the battery uses a solid (or semi-solid) polymer electrolyte such as polyethylene glycol (PEG), polyacrylonitrile (PAN), poly(methyl methacrylate) (PMMA) or poly(vinylidene fluoride) (PVdF). Other terms used in the literature for this system include hybrid polymer electrolyte (HPE), where "hybrid" denotes the combination of the polymer matrix, the liquid solvent, and the salt. Polymer electrolytes can be divided into two large categories: dry solid polymer electrolytes (SPE) and gel polymer electrolytes (GPE). In comparison to liquid electrolytes and solid organic ele ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Internal Combustion
An internal combustion engine (ICE or IC engine) is a heat engine in which the combustion of a fuel occurs with an oxidizer (usually air) in a combustion chamber that is an integral part of the working fluid flow circuit. In an internal combustion engine, the expansion of the high-temperature and high-pressure gases produced by combustion applies direct force to some component of the engine. The force is typically applied to pistons (piston engine), turbine blades (gas turbine), a rotor (Wankel engine), or a nozzle (jet engine). This force moves the component over a distance. This process transforms chemical energy into kinetic energy which is used to propel, move or power whatever the engine is attached to. The first commercially successful internal combustion engines were invented in the mid-19th century. The first modern internal combustion engine, the Otto engine, was designed in 1876 by the German engineer Nicolaus Otto. The term ''internal combustion engine'' usually r ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
D Battery
A D battery (D cell or IEC R20) is a standardized size of a dry cell. A D cell is cylindrical with an electrical contact at each end; the positive end has a nub or bump. D cells are typically used in high current drain applications, such as in large flashlights, radio receivers, and transmitters, and other devices that require an extended running time. A D cell may be either rechargeable or non-rechargeable. Its terminal voltage and capacity depend upon its cell chemistry. The National Carbon Company introduced the first D cell in 1898. Before smaller cells became more common, D cells were widely known as ''flashlight batteries.'' The U.S. military designation for this battery has been BA-30 since sometime before World War II. During World War II, it was designated the Type C battery by the U.S. Navy, leading to confusion with the smaller C cell battery (BA-42). In 2007, D batteries accounted for 8% of alkaline primary battery sales (numerically) in the U.S. In 2008, Swiss p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
AA Battery
The AA battery (or double-A battery) is a standard size single cell cylindrical Dry cell, dry battery. ANSI and IEC battery nomenclature gives several designations for cells in this size, depending on cell features and chemistry. The Battery nomenclature, IEC 60086 system calls the size R6, and American National Standards Institute, ANSI C18 calls it 15.Classic (LR6) datasheet from energizer.com It is named UM-3 by Japanese Industrial Standards, JIS of Japan. Historically, it is known as D14 (hearing aid battery), U12 – later U7 (standard cell), or HP7 (for zinc chloride 'high power' version) in official documentation in the United Kingdom, or a ''pen cell''. AA batteries are common in portable Electronics, electronic devices. An AA battery is composed of a single electrochemical cell that may be either a primary battery (dispos ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Jelly Roll (battery)
The jelly roll or Swiss roll design is the design used in the majority of cylindrical rechargeable batteries, including nickel–cadmium (Ni-Cd), nickel-metal hydride (Ni-MH), and lithium-ion (Li-ion) batteries. The design has this name because the cross section of the battery looks like a Swiss roll. In this design, an insulating sheet is laid down, then a thin layer of an anode material is laid down, a separator layer is applied, and a cathode material is layered on top. This sandwich is then rolled up and inserted into a hollow cylinder casing. The battery is sealed, metal contacts are attached, and an optional button top is applied if the battery is intended to replace an AAA/AA/C/D alkaline battery. A label with the brand name is then applied, or a blank protective label, often green (for Ni-MH) or blue (for Ni-Cd) for a generic or OEM battery. Occasionally, the design is also used for primary (non-rechargeable) batteries, like lithium iron disulfide (Li-FeS2) patented b ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Internal Resistance
In electrical engineering, a practical electric power source which is a linear circuit may, according to Thévenin's theorem, be represented as an ideal voltage source in series with an impedance. This impedance is termed the internal resistance of the source. When the power source delivers current, the measured voltage output is lower than the no- load voltage; the difference is the voltage drop (the product of current and resistance) caused by the internal resistance. The concept of internal resistance applies to all kinds of electrical sources and is useful for analyzing many types of circuits. Battery A battery may be modeled as a voltage source in series with a resistance. These types of models are known as equivalent circuit models. Another common model being physiochemical models that are physical in nature involving concentrations and reaction rates. In practice, the internal resistance of a battery is dependent on its size, state of charge, chemical properties ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sintering
Sintering or frittage is the process of compacting and forming a solid mass of material by pressure or heat without melting it to the point of liquefaction. Sintering happens as part of a manufacturing process used with metals, ceramics, plastics, and other materials. The atoms/molecules in the sintered material diffuse across the boundaries of the particles, fusing the particles together and creating a solid piece. Since the sintering temperature does not have to reach the melting point of the material, sintering is often chosen as the shaping process for materials with extremely high melting points, such as tungsten and molybdenum. The study of sintering in metallurgy, metallurgical powder-related processes is known as powder metallurgy. An example of sintering can be observed when ice cubes in a glass of water adhere to each other, which is driven by the temperature difference between the water and the ice. Examples of pressure-driven sintering are the compacting of snowfa ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
United States
The United States of America (USA), also known as the United States (U.S.) or America, is a country primarily located in North America. It is a federal republic of 50 U.S. state, states and a federal capital district, Washington, D.C. The 48 contiguous states border Canada to the north and Mexico to the south, with the semi-exclave of Alaska in the northwest and the archipelago of Hawaii in the Pacific Ocean. The United States asserts sovereignty over five Territories of the United States, major island territories and United States Minor Outlying Islands, various uninhabited islands in Oceania and the Caribbean. It is a megadiverse country, with the world's List of countries and dependencies by area, third-largest land area and List of countries and dependencies by population, third-largest population, exceeding 340 million. Its three Metropolitan statistical areas by population, largest metropolitan areas are New York metropolitan area, New York, Greater Los Angeles, Los Angel ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sweden
Sweden, formally the Kingdom of Sweden, is a Nordic countries, Nordic country located on the Scandinavian Peninsula in Northern Europe. It borders Norway to the west and north, and Finland to the east. At , Sweden is the largest Nordic country by both area and population, and is the List of European countries by area, fifth-largest country in Europe. Its capital and largest city is Stockholm. Sweden has a population of 10.6 million, and a low population density of ; 88% of Swedes reside in urban areas. They are mostly in the central and southern half of the country. Sweden's urban areas together cover 1.5% of its land area. Sweden has a diverse Climate of Sweden, climate owing to the length of the country, which ranges from 55th parallel north, 55°N to 69th parallel north, 69°N. Sweden has been inhabited since Prehistoric Sweden, prehistoric times around 12,000 BC. The inhabitants emerged as the Geats () and Swedes (tribe), Swedes (), who formed part of the sea-faring peopl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Waldemar Jungner
Ernst Waldemar Jungner (19 June 1869 – 30 August 1924) was a Swedish inventor and engineer. In 1898 he invented the nickel-iron electric storage battery (NiFe), the nickel-cadmium battery (NiCd), and the rechargeable alkaline silver-cadmium battery (AgCd). As an inventor, he also fabricated a fire alarm based on different dilutions of metals. He also worked on the electrolytic production of sodium carbonate and patented a rock drilling device. Early life Ernst Waldemar Jungner was born on 19 June 1869 in Västra Götaland County, Sweden. His parents were ministers, and his father died when Waldemar was 13 years old. In 1869, the year he was born, failed harvests caused famine throughout Sweden, which affected Jungner's health. He also contracted measles and scarlet fever. Education Jungner attended Skara upper secondary school, and studied chemistry, mathematics, astronomy, botany, geology and Latin at Uppsala University. He went on to carry out further studies at th ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
