|
Flight Hours
Flight time or block time is an aviation term referring to the total amount of time spent piloting aircraft, and serves as the primary measure of a pilot's experience. Flight time is defined by International Civil Aviation Organization (ICAO) as "The total time from the moment an aeroplane first moves for the purpose of taking off until the moment it finally comes to rest at the end of the flight", and thus includes time spent taxiing and performing pre-flight checks on the ground, provided the engine is running. It is colloquially referred to as "blocks to blocks" or " chocks to chocks" time. In commercial aviation, this means the time from pushing back at the departure gate to arriving at the destination gate. Air time is defined as "the time from the moment an aircraft leaves the surface until it comes into contact with the surface at the next point of landing". For gliders without self-launch capability, flight time "commences when the glider is towed for the purpose of fl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Hobbs Meter
Hobbs meter is a generic trademark for devices used in aviation to measure the time that an aircraft is in use. The meters typically display hours and tenths of an hour, but there are several ways in which the meter may be activated: # It can measure the time that the electrical system is on. This maximizes the recorded time. # It can be activated by oil pressure running into a pressure switch, and therefore runs while the engine is running. Many rental aircraft use this method to remove the incentive to fly with the master electrical switch off. # It can be activated by another switch, either an airspeed sensing vane under a wing (as in the Cessna Caravan) or a pressure switch attached to the landing gear (as in many twin engine planes). In these cases, the meter only measures the time the aircraft is actually flying. Metrics such as Time In Service and Turbine Actual Runtime are kept to monitor overhaul cycles, and are usually used by commercial operators under Federal Aviation R ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pilot Licensing And Certification
Pilot licensing or certification refers to permits for operating aircraft. Flight crew licences are issued by the civil aviation authority of each country, which must establish that the holder has met minimum knowledge and experience before issuing licences. The licence, along with the required class or type rating, allows a pilot to fly aircraft registered in the licence issuing state. Regulators The International Civil Aviation Organization's "Annex 1 – Personnel Licensing" acts as the international minimum standard for licensing. However, states can deviate from these standards by notifying ICAO about the changes. In the United States, pilot certification is regulated by the Federal Aviation Administration (FAA), a branch of the U.S. Department of Transportation (DOT). A pilot is certified under the authority of Parts 61 and 141 of Title 14 of the Code of Federal Regulations, also known as the Federal Aviation Regulations (FARs). [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Endurance (aeronautics)
In aviation, endurance is the maximum length of time that an aircraft can spend in cruising flight. In other words, it is the amount of time an aircraft can stay in the air with one load of fuel. Endurance is different from range, which is a measure of distance flown. For example, a typical sailplane exhibits high endurance characteristics but poor range characteristics. Endurance can be defined as: :E=\int_^dt=-\int_^\frac=\int_^\frac where W stands for fuel weight, F for fuel flow, and t for time. Endurance can factor into aviation design in a number of ways. Some aircraft, such as the P-3 Orion or U-2 spy plane, require high endurance characteristics as part of their mission profile (often referred to as loiter time (on target)). Endurance plays a prime factor in finding out the fuel fraction for an aircraft. Endurance, like range, is also related to fuel efficiency Fuel efficiency (or fuel economy) is a form of thermal efficiency, meaning the ratio of effort to r ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Flight Length
In aviation, the flight length or flight distance refers to the distance of a flight. Aircraft do not necessarily follow the great-circle distance, but may opt for a longer route due to weather, traffic, to utilise a jet stream, or to refuel. Commercial flights are often categorized into long-, medium- or short-haul by commercial airlines based on flight length, although there is no international standard definition. The related term flight time is defined by ICAO (International Civil Aviation Organization) as "The total time from the moment an aeroplane first moves for the purpose of taking off until the moment it finally comes to rest at the end of the flight", and is referred to colloquially as "blocks to blocks" or " chocks to chocks" time. In commercial aviation, this means the time from pushing back at the departure gate to arriving at the destination gate. Flight time is measured in hours and minutes as it is independent of geographic distance travelled. Flight time can ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Crew Rest Compartment
A crew rest compartment is a section of an airliner dedicated for breaks and sleeping by crew members during off-duty periods. Federal Aviation Regulations have provisions requiring crew rest areas be provided in order to operate a long-haul flight by using multiple crew shifts. Passengers are restricted from accessing crew rest compartments by regulations; their entrances may be secured by locks and may require using a ladder for access. Crew rest compartments are normally segregated, with separate compartments for the flight deck crew and the cabin crew. Many crew rest compartments may not normally be used during taxi, takeoff, or landing maneuvers unless equipped with a standard seat.In the United States, the Federal Aviation Administration (FAA) defines three classes of crew rest facilities, dependent on the number of crew and the duration of the flight. Crew rest periods may be provided in higher classed rest areas than required. The FAA rest facility classifications from ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Airliner
An airliner is a type of airplane for transporting passengers and air cargo. Such aircraft are most often operated by airlines. The modern and most common variant of the airliner is a long, tube shaped, and jet powered aircraft. The largest of them are wide-body jets which are also called twin-aisle because they generally have two separate aisles running from the front to the back of the passenger cabin. These are usually used for long-haul flights between airline hubs and major cities. A smaller, more common class of airliners is the narrow-body or single-aisle. These are generally used for short to medium-distance flights with fewer passengers than their wide-body counterparts. Regional airliners typically seat fewer than 100 passengers and may be powered by turbofans or turboprops. These airliners are the non- mainline counterparts to the larger aircraft operated by the major carriers, legacy carriers, and flag carriers, and are used to feed traffic into the large a ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Federal Aviation Regulations
The Federal Aviation Regulations (FARs) are rules prescribed by the Federal Aviation Administration (FAA) governing all aviation activities in the United States. The FARs comprise Title 14 of the Code of Federal Regulations (14 CFR). A wide variety of activities are regulated, such as aircraft design and maintenance, typical airline flights, pilot training activities, hot-air ballooning, lighter-than-air aircraft, human-made structure heights, obstruction lighting and marking, model rocket launches, commercial space operations, model aircraft operations, unmanned aircraft systems (UAS) and kite flying. The rules are designed to promote safe aviation, protecting pilots, flight attendants, passengers and the general public from unnecessary risk. FAR vs. 14 CFR Since 1958, these rules have typically been referred to as "FARs", short for Federal Aviation Regulations. However, another set of regulations (Title 48) is titled "Federal Acquisition Regulations", and this has led ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Federal Aviation Administration
The Federal Aviation Administration (FAA) is a Federal government of the United States, U.S. federal government agency within the United States Department of Transportation, U.S. Department of Transportation that regulates civil aviation in the United States and surrounding international waters. Its powers include air traffic control, certification of personnel and aircraft, setting standards for airports, and protection of U.S. assets during the launch or re-entry of commercial space vehicles. Powers over neighboring international waters were delegated to the FAA by authority of the International Civil Aviation Organization. The FAA was created in as the Federal Aviation Agency, replacing the Civil Aeronautics Administration (United States), Civil Aeronautics Administration (CAA). In 1967, the FAA became part of the newly formed U.S. Department of Transportation and was renamed the Federal Aviation Administration. Major functions The FAA's roles include: *Regulating U.S. co ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
EASA
The European Union Aviation Safety Agency (EASA) is an agency of the European Commission with responsibility for civil aviation safety in the European Union. It carries out certification, regulation and standardisation and also performs investigation and monitoring. It collects and analyses safety data, drafts and advises on safety legislation and co-ordinates with similar organisations in other parts of the world. The idea of a European-level aviation safety authority goes back to 1996, but the agency was legally established only in 2002; it began its work in 2003. History Based in Cologne, Germany, the agency was created on 15 July 2002 as the "European Aviation Safety Agency", and reached full functionality in 2008, taking over functions of the Joint Aviation Authorities. It was renamed the "European Union Aviation Safety Agency" in 2018. European Free Trade Association countries participate in the agency. The United Kingdom was a member until the end of the Brexit trans ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
General Aviation
General aviation (GA) is defined by the International Civil Aviation Organization (ICAO) as all civil aviation aircraft operations except for commercial air transport or aerial work, which is defined as specialized aviation services for other purposes. However, for statistical purposes, ICAO uses a definition of general aviation which includes aerial work. General aviation thus represents the " private transport" and recreational components of aviation, most of which is accomplished with light aircraft. Definition The International Civil Aviation Organization (ICAO) defines civil aviation aircraft operations in three categories: General Aviation (GA), Aerial Work (AW) and Commercial Air Transport (CAT). Aerial work operations are separated from general aviation by ICAO by this definition. Aerial work is when an aircraft is used for specialized services such as agriculture, construction, photography, surveying, observation and patrol, search and rescue, and aerial adver ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Aviation
Aviation includes the activities surrounding mechanical flight and the aircraft industry. ''Aircraft'' include fixed-wing and rotary-wing types, morphable wings, wing-less lifting bodies, as well as lighter-than-air aircraft such as hot air balloons and airships. Aviation began in the 18th century with the development of the hot air balloon, an apparatus capable of atmospheric displacement through buoyancy. Clément Ader built the "Ader Éole" in France and made an uncontrolled, powered hop in 1890. This was the first powered aircraft, although it did not achieve controlled flight. Some of the most significant advancements in aviation technology came with the controlled gliding flying of Otto Lilienthal in 1896. A major leap followed with the construction of the '' Wright Flyer'', the first powered airplane by the Wright brothers in the early 1900s. Since that time, aviation has been technologically revolutionized by the introduction of the jet engine which enabl ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
