|
DB(A)
A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. A-weighting is applied to instrument-measured sound levels in an effort to account for the relative loudness perceived by the human ear, as the ear is less sensitive to low audio frequencies. It is employed by arithmetically adding a table of values, listed by octave or third-octave bands, to the measured sound pressure levels in dB. The resulting octave band measurements are usually added (logarithmic method) to provide a single A-weighted value describing the sound; the units are written as dB(A). Other weighting sets of values – B, C, D and now Z – are discussed below. The curves were originally defined for use at different average sound levels, but A-weighting, though originally intended only for the measurement of low-level sounds (aro ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Noise Health Effects
Noise health effects are the physical and psychological health consequences of regular exposure to consistent elevated sound levels. Noise from traffic, in particular, is considered by the World Health Organization to be one of the worst environmental stressors for humans, second only to air pollution. Elevated workplace or environmental noise can cause hearing impairment, tinnitus, hypertension, ischemic heart disease, annoyance, and sleep disturbance. Changes in the immune system and birth defects have been also attributed to noise exposure. Although age-related health effects ( presbycusis) occur naturally with age, in many countries the cumulative impact of noise is sufficient to impair the hearing of a large fraction of the population over the course of a lifetime. Noise exposure has been known to induce noise-induced hearing loss, tinnitus, hypertension, vasoconstriction, and other cardiovascular adverse effects. Chronic noise exposure has been associated with sleep distur ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Aircraft Noise
Aircraft noise pollution refers to noise produced by aircraft in flight that has been associated with several negative stress-mediated health effects, from sleep disorders to cardiovascular disorders. Governments have enacted extensive controls that apply to aircraft designers, Aerospace manufacturer, manufacturers, and operators, resulting in improved procedures and cuts in pollution. Mechanisms of sound pollution Aircraft noise is noise pollution produced by an aircraft or its components, whether on the ground while parked such as auxiliary power units, while taxiing, on run-up from propeller and jet exhaust, during takeoff, underneath and lateral to departure and arrival paths, over-flying while en route, or during landing. A moving aircraft including the jet engine or Propeller (aircraft), propeller causes Compression (physics), compression and rarefaction of the air, producing motion of air molecules. This movement propagates through the air as pressure waves. If these p ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Acoustic Weighting Curves (1)
A-weighting is a form of weighting, frequency weighting and the most commonly used of a weighting filter, family of curves defined in the International standard International Electrotechnical Commission, IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. A-weighting is applied to instrument-measured sound levels in an effort to account for the relative loudness perceived by the human ear, as the ear is less sensitive to low audio frequencies. It is employed by arithmetically adding a table of values, listed by octave band, octave or third-octave bands, to the measured sound pressure levels in decibel, dB. The resulting octave band measurements are usually added (logarithmic method) to provide a single A-weighted value describing the sound; the units are written as dB(A). Other weighting sets of values – B, C, D and now Z – are discussed below. The curves were originally defined for use at different average sound levels, but A ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Noise-induced Hearing Loss
Noise-induced hearing loss (NIHL) is a Hearing loss, hearing impairment resulting from exposure to loud sound. People may have a loss of perception of a narrow range of Frequency, frequencies or impaired perception of sound including hyperacusis, sensitivity to sound or tinnitus, ringing in the ears. When exposure to hazards such as noise occur at work and is associated with hearing loss, it is referred to as occupational hearing loss. Hearing may deteriorate gradually from chronic and repeated noise exposure (such as loud music or background noise) or suddenly from exposure to impulse noise, which is a short high intensity noise (such as a gunshot or Air horn, airhorn). In both types, loud sound overstimulates delicate hearing cells, leading to the permanent injury or death of the cells. Once lost this way, hearing cannot be restored in humans. There are a variety of prevention strategies available to avoid or reduce hearing loss. Lowering the volume of sound at its source, ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Decibel
The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel (B). It expresses the ratio of two values of a Power, root-power, and field quantities, power or root-power quantity on a logarithmic scale. Two signals whose level (logarithmic quantity), levels differ by one decibel have a power ratio of 101/10 (approximately ) or root-power ratio of 101/20 (approximately ). The strict original usage above only expresses a relative change. However, the word decibel has since also been used for expressing an Absolute scale, absolute value that is relative to some fixed reference value, in which case the dB symbol is often suffixed with letter codes that indicate the reference value. For example, for the reference value of 1 volt, a common suffix is "#Voltage, V" (e.g., "20 dBV"). As it originated from a need to express power ratios, two principal types of scaling of the decibel are used to provide consistency depending on whether the scaling refer ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Environmental Noise
Environmental noise is an accumulation of noise pollution that occurs outside. This noise can be caused by transport, industrial, and Sport, recreational activities. Noise is frequently described as 'unwanted sound'. Within this context, environmental noise is generally present in some form in all areas of human, animal, or environmental activity. The effects in humans of exposure to environmental noise may vary from emotional to physiological and psychological. Noise at low levels is not necessarily harmful. Environmental noise can also convey a sense of liveliness in an area, which can be desirable. The adverse effects of noise exposure (i.e. noise pollution) could include: interference with speech or other 'desired' sounds, annoyance, sleep disturbance, anxiety, hearing damage and stress-related cardiovascular health problems. As a result, environmental noise is studied, regulated, and monitored by many governments and institutions around the world. This creates a number of ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Weighting Filter
A weighting filter is used to emphasize or suppress some aspects of a phenomenon compared to others, for measurement or other purposes. Audio applications In each field of audio measurement, special units are used to indicate a weighted measurement as opposed to a basic physical measurement of energy level. For sound, the unit is the phon (1 kHz equivalent level). Sound Sound has three basic components, the wavelength, frequency, and Speed of sound, speed. In sound measurement, we measure the loudness of the sound in decibels (dB). Decibels are logarithmic scale, logarithmic with 0 Dbx (noise reduction), dB as the reference. There are also a range of frequencies that sounds can have. Frequency is the number of times a sine wave repeats itself in a second. Normal auditory systems can usually hear between 20 and 20,000 Hz. When we measure sound, the measurement instrument takes the incoming auditory signal and analyzes it for these different features. Weighting fi ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Roadway Noise
Roadway noise is the collective sound energy emanating from motor vehicles. It consists chiefly of road surface, tire, engine/transmission, aerodynamic, and Brake, braking elements. Noise of rolling tires driving on pavement is found to be the biggest contributor of highway noise and increases with higher vehicle speeds. In developed country, developed and developing country, developing countries, roadway noise contributes a proportionately large share of the total societal noise pollution. In the U.S., it contributes more to environmental noise exposure than any other noise source. History Roadway noise began to be measured in a widespread manner in the 1960s, as computer modeling of this phenomenon began to become meaningful. After passage of the National Environmental Policy Act and Noise Control Act, the demand for detailed analysis soared, and decision makers began to look to acoustical scientists for answers regarding the planning of new roadways and the design of no ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Fletcher–Munson Curves
An equal-loudness contour is a measure of sound pressure level, over the frequency spectrum, for which a listener perceives a constant loudness when presented with pure steady tones. The unit of measurement for loudness levels is the phon and is arrived at by reference to equal-loudness contours. By definition, two sine waves of differing frequencies are said to have equal-loudness level measured in phons if they are perceived as equally loud by the average young person without significant hearing impairment. The Fletcher–Munson curves are one of many sets of equal-loudness contours for the human ear, determined experimentally by Harvey Fletcher and Wilden A. Munson, and reported in a 1933 paper entitled "Loudness, its definition, measurement and calculation" in the ''Journal of the Acoustical Society of America''. Fletcher–Munson curves have been superseded and incorporated into newer standards. The definitive curves are those defined in ISO 226 from the International O ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Sound Pressure
Sound pressure or acoustic pressure is the local pressure deviation from the ambient (average or equilibrium) atmospheric pressure, caused by a sound wave. In air, sound pressure can be measured using a microphone, and in water with a hydrophone. The SI unit of sound pressure is the pascal (Pa). Mathematical definition A sound wave in a transmission medium causes a deviation (sound pressure, a ''dynamic'' pressure) in the local ambient pressure, a ''static'' pressure. Sound pressure, denoted ''p'', is defined by p_\text = p_\text + p, where * ''p''total is the total pressure, * ''p''stat is the static pressure. Sound measurements Sound intensity In a sound wave, the complementary variable to sound pressure is the particle velocity. Together, they determine the sound intensity of the wave. ''Sound intensity'', denoted I and measured in W· m−2 in SI units, is defined by \mathbf I = p \mathbf v, where * ''p'' is the sound pressure, * v is the particle velocity. Acous ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
