|
Source-address Dependent Routing
Source-specific routing, also called source-address dependent routing (SADR), is a routing technique in which a routing decision is made by looking at the source address of a packet in addition to its destination address. The main application of source-specific routing is to allow a cheap form of multihoming without the need for provider-independent addresses or any cooperation from upstream ISPs. The problem In traditional ''next-hop routing'', a packet is routed according to its destination only, towards the closest router that announces a route that matches that destination. Consider a multihomed end-user network connected to two ISPs, BT&T and PacketCast; such a network will typically have two ''edge routers'', each of which is connected to one ISP. Both edge routers announce a default route, meaning that they are willing to accept packets destined for the Internet. If a packet with a source in BT&T's network is routed through PacketCast's edge router, PacketCast will ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Routing
Routing is the process of selecting a path for traffic in a Network theory, network or between or across multiple networks. Broadly, routing is performed in many types of networks, including circuit-switched networks, such as the public switched telephone network (PSTN), and computer networks, such as the Internet. In packet switching networks, routing is the higher-level decision making that directs network packets from their source toward their destination through intermediate network nodes by specific packet forwarding mechanisms. Packet forwarding is the transit of network packets from one Network interface controller, network interface to another. Intermediate nodes are typically network hardware devices such as Router (computing), routers, gateway (telecommunications), gateways, Firewall (computing), firewalls, or network switch, switches. General-purpose computers also forward packets and perform routing, although they have no specially optimized hardware for the task. T ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Network Packet
In telecommunications and computer networking, a network packet is a formatted unit of Data (computing), data carried by a packet-switched network. A packet consists of control information and user data; the latter is also known as the ''Payload (computing), payload''. Control information provides data for delivering the payload (e.g., source and destination network addresses, error detection codes, or sequencing information). Typically, control information is found in packet Header (computing), headers and Trailer (computing), trailers. In packet switching, the Bandwidth (computing), bandwidth of the transmission medium is shared between multiple communication sessions, in contrast to circuit switching, in which circuits are preallocated for the duration of one session and data is typically transmitted as a continuous bit stream. Terminology In the seven-layer OSI model of computer networking, ''packet'' strictly refers to a protocol data unit at layer 3, the network layer. A ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Multihoming
Multihoming is the practice of connecting a Host (network), host or a computer network to more than one network. This can be done in order to increase reliability or performance. A typical host or end-user network is connected to just one network. Connecting to multiple networks can increase reliability because if one connection fails, packets can still be routed through the remaining connection. Connecting to multiple networks can also improve performance because data can be transmitted and received through the multiple connections simultaneously multiplying throughput and, depending on the destination, it may be more efficient to route through one network or the other. Variants There are several different ways to perform multihoming. Host multihoming A single host may be connected to multiple networks. For example, a mobile phone might be simultaneously connected to a WiFi network and a 4G network, and a desktop computer might be connected to both a home network and a V ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Multihoming
Multihoming is the practice of connecting a Host (network), host or a computer network to more than one network. This can be done in order to increase reliability or performance. A typical host or end-user network is connected to just one network. Connecting to multiple networks can increase reliability because if one connection fails, packets can still be routed through the remaining connection. Connecting to multiple networks can also improve performance because data can be transmitted and received through the multiple connections simultaneously multiplying throughput and, depending on the destination, it may be more efficient to route through one network or the other. Variants There are several different ways to perform multihoming. Host multihoming A single host may be connected to multiple networks. For example, a mobile phone might be simultaneously connected to a WiFi network and a 4G network, and a desktop computer might be connected to both a home network and a V ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IP Address Spoofing
In computer networking, IP address spoofing or IP spoofing is the creation of Internet Protocol (IP) packets with a false source IP address, for the purpose of impersonating another computing system. Background The basic protocol for sending data over the Internet network and many other computer networks is the Internet Protocol (IP). The protocol specifies that each IP packet must have a header which contains (among other things) the IP address of the sender of the packet. The source IP address is normally the address that the packet was sent from, but the sender's address in the header can be altered, so that to the recipient it appears that the packet came from another source. The protocol requires the receiving computer to send back a response to the source IP address therefore spoofing is mainly used when the sender can anticipate the network response or does not care about the response. The source IP address provides only limited information about the sender. It may pr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Shim6
The Site Multihoming by IPv6 Intermediation (SHIM6) protocol is an Internet Layer defined in RFC 5533. Architecture The SHIM6 architecture defines failure detection and locator pair exploration functions. The first is used to detect outages through the path defined by the current locator pair for a communication. To achieve this, hints provided by upper protocols such as Transmission Control Protocol The Transmission Control Protocol (TCP) is one of the main communications protocol, protocols of the Internet protocol suite. It originated in the initial network implementation in which it complemented the Internet Protocol (IP). Therefore, th ... (TCP) are used, or specific SHIM6 packet probes. The second function is used to determine valid locator pairs that could be used when an outage is detected. The ability to change locators while a communication is being held introduces security problems, so mechanisms based on applying cryptography to the address generation process ( Cry ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Multipath TCP
Multipath TCP (MPTCP) is an ongoing effort of the Internet Engineering Task Force's (IETF) Multipath TCP working group, that aims at allowing a Transmission Control Protocol (TCP) connection to use multiple paths to maximize throughput and increase redundancy. In January 2013, the IETF published the Multipath specification as an Experimental standard in . It was replaced in March 2020 by the Multipath TCP v1 specification in . Benefits The redundancy offered by Multipath TCP enables inverse multiplexing of resources, and thus increases TCP throughput to the sum of all available link-level channels instead of using a single one as required by standard TCP. Multipath TCP is backward compatible with standard TCP. Multipath TCP is particularly useful in the context of wireless networks; using both Wi-Fi and a mobile network is a typical use case. In addition to the gains in throughput from inverse multiplexing, links may be added or dropped as the user moves in or out of coverage w ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Mosh (software)
In computing, Mosh (mobile shell) is a tool used to connect from a client computer to a server over the Internet, to run a remote terminal."Mosh: the mobile shell" Retrieved on 28 March 2013. Mosh is similarBrockmeier, Joe "Into the Mosh Pit: A Mobile Shell Replacement for SSH" , ''linux.com'', 10 April 2012. Retrieved on 28 March 2013. to SSH, with additional features meant to improve usability for mobile users. The major ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Babel (protocol)
The Babel routing protocol is a distance-vector routing protocol for Internet Protocol packet-switched networks that is designed to be robust and efficient on both wireless mesh networks and wired networks. Babel is described in RFC 8966. Babel is based on the ideas in Destination-Sequenced Distance Vector routing (DSDV), Ad hoc On-Demand Distance Vector Routing (AODV), and Cisco Cisco Systems, Inc. (using the trademark Cisco) is an American multinational digital communications technology conglomerate corporation headquartered in San Jose, California. Cisco develops, manufactures, and sells networking hardware, s ...'s Enhanced Interior Gateway Routing Protocol (EIGRP), but uses different techniques for loop avoidance. Babel has provisions for using multiple dynamically computed metrics; by default, it uses hop-count on wired networks and a variant of expected transmission count on wireless links, but can be configured to take radio diversity into account or to aut ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Bird Internet Routing Daemon
BIRD (recursive acronym for ''BIRD Internet Routing Daemon'') is an open-source software, open-source implementation for routing Internet Protocol packets on Unix-like operating systems. It was developed as a school project at the Faculty of Mathematics and Physics, Charles University, Faculty of Mathematics and Physics, Charles University in Prague, Charles University, Prague, and is distributed under the GNU General Public License. BIRD supports IPv4, Internet Protocol version 4 and IPv6, version 6 by running separate Daemon (computer software), daemons. It establishes multiple routing tables, and uses Border Gateway Protocol, BGP, Routing Information Protocol, RIP, and Open Shortest Path First, OSPF routing protocols, as well as statically defined routes. Its design differs significantly from GNU Zebra, Quagga (software), Quagga and FRRouting. Currently BIRD is included in many Linux distributions, such as Debian, Ubuntu (operating system), Ubuntu and Fedora (operating system) ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
IS-IS
Intermediate System to Intermediate System (IS-IS, also written ISIS) is a routing protocol designed to move information efficiently within a computer network, a group of physically connected computers or similar devices. It accomplishes this by determining the best route for data through a packet switching network. The IS-IS protocol is defined in ISO/IEC 10589:2002 as an international standard within the Open Systems Interconnection (OSI) reference design. In 2005, IS-IS was called "the ''de facto'' standard for large service provider network backbones". Description IS-IS is an interior gateway protocol, designed for use within an administrative domain or network. This is in contrast to exterior gateway protocols, primarily Border Gateway Protocol (BGP), which is used for routing between autonomous systems. IS-IS is a link-state routing protocol, operating by reliably flooding link state information throughout a network of routers. Each IS-IS router independent ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
