Foil Kite
Foil kites are soft kites based on the design of the parafoil. They consist of a number of cells running fore to aft, some or all of which are open at the front to allow air to inflate the kite so it takes on an aerofoil section. Due to the amount of power that these kites can generate, they can be used for a variety of different activities including kitesurfing, kite landboarding, snowkiting, kite buggying, kite-energy systems or airborne wind energy, and recreational kiting. Foil kites are flown with various line set-ups that includes 2-, 3- and 4-line systems; 2-line systems consisting of rings, wrist bands or bar compared to depowerable 4-line systems using a bar or handles. (See also: kite control systems) In order to make them suitable for use on water some foils have limited air inlets in the centre of the leading edge, with valves to keep the air in and (hopefully) the water out. Internal holes in the cell sides allow the whole kite to inflate. These kites are natura ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Ripstop Nylon
__NOTOC__ Ripstop is a woven fabric, often made of nylon, using a reinforcing technique that makes it more resistant to tearing and wear. During weaving, stronger (and often thicker) reinforcement yarns are interwoven at regular intervals in a crosshatch pattern. The intervals are typically 5 to 8 millimeters (0.2 to 0.3 in). Thin and lightweight ripstop fabrics have a two-dimensional structure due to the thicker yarns being interwoven in thinner cloth. Older lightweight ripstop fabrics display the thicker interlocking thread patterns in the material quite prominently, but more modern weaving techniques make the ripstop threads less obvious. A similar effect can be achieved by weaving two or three fine yarns together at smaller intervals. Advantages of ripstop are the favourable strength-to-weight ratio and that small tears can not easily spread. Fibers used to make ripstop include cotton, silk, polyester, and polypropylene, with nylon content often limited to the crosshatc ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Windsports
A windsport is any type of sport which involves wind-power, often involving a non-rigid airfoil such as a sail or a power kite. The activities can be land-based, on snow, on ice or on water. Windsport activity may be regulated in some countries by aviation/maritime authorities if they are likely to interfere with other activities. Local authorities may also regulate activity in certain areas, especially on crowded beaches and parks. *Ice boating - using a masted sail attached to a vessel with skates * Kite boating - sailing a boat in displacement or planing mode using a kite *Kite landboarding - using a power kite with a wheeled board while standing *Kite buggy - using a wheeled buggy with seats attached to a power kite *Kite flying - flight of a small airfoil by a standing ground operator using 1-4 flying lines *Kite skating - as for kite jumping but while using specialized skates *Kite surfing - using a surfboard attached to a power kite *Land sailing - a masted sail attached to ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Power Kite
A power kite or traction kite is a large kite designed to provide significant pull to the user. Types The two most common forms are the foil, and the leading edge inflatable. There are also other less common types of power kite including rigid-framed kites and soft single skin kites. There are several different control systems used with these kites which have two to five lines and a bar or handles. Foil kites consist of a number of cells with cloth ribs in each cell. It is the profile of these ribs that gives the kite its aerofoil shape and enable it to generate lift. The most common type is the ram-air foil, where each cell has a gauze-covered opening at the front, meaning air is forced in during flight, giving the kite its stiffness and enabling it to hold its profile. Some ram-air foils are closed-cell, where a one-way valve locks the air inside the cells, giving some increased water relaunch capability. Leading edge inflatable kites (LEIs) are made of a single skin of f ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Parafoil
A parafoil is a nonrigid (textile) airfoil with an aerodynamic cell structure which is inflated by the wind. Ram-air inflation forces the parafoil into a classic wing cross-section. Parafoils are most commonly constructed out of ripstop nylon. The device was developed in 1964 by Domina Jalbert (1904–1991). Jalbert had a history of designing kites and was involved in the development of hybrid balloon-kite aerial platforms for carrying scientific instruments. He envisaged the parafoil would be used to suspend an aerial platform or for the recovery of space equipment. A patent was granted in 1966. Deployment shock prevented the parafoil's immediate acceptance as a parachute. It was not until the addition of a drag canopy on the riser lines (known as a " slider") which slowed their spread that the parafoil became a suitable parachute. Compared to a simple round canopy, a parafoil parachute has greater steerability, will glide further and allows greater control of the rate of desc ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
LEI Kite
A leading edge inflatable kite (LEI) is a single skin kite flying, kite with inflatable Pneumatic bladder, bladders providing structure. It is useful as a power kite, power or traction kite. These kites are flown using 2, 4 or 5 control lines and a bar. (See also: kite control systems) A LEI is a great kite for water use because the inflated bladders cause it to float on the water surface. A LEI can sit on the water for an indefinite time and still be relaunched because, unlike a foil kite, there are no chambers that can fill with water. Generally used for kitesurfing and kiteboarding, leading edge inflatable kites come in many different sizes, most commonly from 5 to 18 square metres. Based on their design Leading Edge Inflatable kites can be broken down into four categories: C-kites, hybrid kites, delta kites, and bow kites. C-kites C-kites are the oldest style of LEI used for traction kiting. They typically come with four lines, and some have the option of an additional 5t ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Kite Buggying
A kite buggy is a light, purpose-built vehicle powered by a traction kite (power kite). It is single-seated and has one steerable front wheel and two fixed rear wheels. The driver sits in the seat located in the middle of the vehicle and accelerates and slows down by applying steering manoeuvres in coordination with flying manoeuvres of the kite. This activity is called kite buggying. The speed achieved in kite buggies by skilled drivers can range up to around 110 km/h (70 mph), hence protective clothing, including a safety helmet, is commonly worn. The kite buggy was promulgated by George Pocock (inventor) in the UK in 1827 and kite buggies were available commercially in US and UK in the late 1970s. Peter Lynn is generally attributed with the modern popularization of buggies and kite buggying with his introduction of strong, lightweight, affordable buggies in the early 1990s. Kite buggying is similar to land yachting, windsurfing or even yachting, and therefore much ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Kite Landboarding
Kite landboarding, also known as land kiteboarding or flyboarding, is based on the sport of kitesurfing, where a rider on a surf-style board is pulled over water by a kite. Kite landboarding involves the use of a mountain board or landboard, which is essentially an oversized skateboard with large pneumatic wheels and foot-straps. Kite landboarding is a growing sport, and there are several competitions. Kite landboarding is attracting growing publicity although it is not yet as popular or as well known as kitesurfing. Technique Typically, kite landboarding takes place in large open areas where the wind is constant and there are no obstructions such as trees or people. Large hard-packed sandy beaches are typical landboarding locations because of the large space available and wind conditions. The rider starts off by getting the kite into a neutral position overhead. Once strapped onto the board, the rider can orient the kite such that it pulls the rider across the ground. This is do ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Kite Surfing
Kiteboarding or kitesurfing is a sport that involves using wind power with a large power kite to pull a rider across a water, land, snow, sand, or other surface. It combines the aspects of paragliding, surfing, windsurfing, skateboarding, snowboarding, and wakeboarding. Kiteboarding is among the less expensive and more convenient sailing sports. After some concepts and designs that emerged in the late 1970s and early 1980s were successfully tested, the sport received a wider audience in the late 1990s and became mainstream at the turn of the century. It has freestyle, wave-riding, and racing competitions. The sport held the speed sailing record, reaching before being eclipsed by the Vestas Sailrocket. Worldwide, there are 1.5 million kitesurfers, while the industry sells around 100,000 to 150,000 kites per year. Most power kites are leading edge inflatable kite, leading-edge inflatable kites or foil kites attached by about of flying lines to a control bar and a harn ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Stunt Kite
A stunt is an unusual, difficult, dramatic physical feat that may require a special skill, performed for artistic purposes usually for a public audience, as on television or in theaters or cinema. Stunts are a feature of many action films. Before computer-generated imagery special effects, these depictions were limited to the use of models, false perspective and other in-camera effects, unless the creator could find someone willing to carry them out, even such dangerous acts as jumping from car to car in motion or hanging from the edge of a skyscraper: the stunt performer or stunt double. Types of stunt effects Practical effects One of the most-frequently used practical stunts is stage combat. Although contact is normally avoided, many elements of stage combat, such as sword fighting, martial arts, and acrobatics required contact between performers in order to facilitate the creation of a particular effect, such as noise or physical interaction. Stunt performances are highl ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |
|
Kite
A kite is a tethered heavier than air flight, heavier-than-air craft with wing surfaces that react against the air to create Lift (force), lift and Drag (physics), drag forces. A kite consists of wings, tethers and anchors. Kites often have a bridle and tail to guide the face of the kite so the wind can lift it. Some kite designs do not need a bridle; box kites can have a single attachment point. A kite may have fixed or moving anchors that can balance the kite. The name is derived from the kite (bird), kite, the hovering bird of prey. There are several shapes of kites. The Lift (force), lift that sustains the kite in flight is generated when air moves around the kite's surface, producing low pressure above and high pressure below the wings. The interaction with the wind also generates horizontal Drag (physics), drag along the direction of the wind. The resultant force vector from the lift and drag force components is opposed by the tension of one or more of the rope, lines ... [...More Info...]       [...Related Items...]     OR:     [Wikipedia]   [Google]   [Baidu]   |