|
Network Topology
Network topology is the arrangement of the elements (Data link, links, Node (networking), nodes, etc.) of a communication network. Network topology can be used to define or describe the arrangement of various types of telecommunication networks, including command and control radio networks, industrial Fieldbus, fieldbusses and computer networks. Network topology is the topological structure of a network and may be depicted physically or logically. It is an application of graph theory wherein communicating devices are modeled as nodes and the connections between the devices are modeled as links or lines between the nodes. Physical topology is the placement of the various components of a network (e.g., device location and cable installation), while logical topology illustrates how data flows within a network. Distances between nodes, physical interconnections, transmission rates, or signal types may differ between two different networks, yet their logical topologies may be identica ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Data Link
A data link is a means of telecommunications link, connecting one location to another for the purpose of transmitting and receiving digital information (data communication). It can also refer to a set of electronics assemblies, consisting of a transmitter and a receiver (two pieces of data terminal equipment) and the interconnecting data telecommunication circuit. These are governed by a link protocol enabling digital data to be transferred from a data source to a data sink. Types There are at least three types of basic data-link configurations that can be conceived of and used: * Simplex communications, most commonly meaning all communications in one direction only. * Half-duplex communications, meaning communications in both directions, but not both ways simultaneously. * Duplex (telecommunications), Duplex communications, communications in both directions simultaneously. Aviation In civil aviation, a data-link system (known as Controller Pilot Data Link Communications) is use ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Controller Area Network
A controller area network bus (CAN bus) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts. This broadcast-based, message-oriented protocol ensures data integrity and prioritization through a process called arbitration, allowing the highest priority device to continue transmitting if multiple devices attempt to send data simultaneously, while others back off. Its reliability is enhanced by differential signaling, which mitigates electrical noise. Common versions of the CAN protocol include CAN 2.0, CAN FD, and CAN XL which vary in their data rate capabilities and maximum data payload sizes. History Development of the CAN bus started in 1983 at Robert Bosch GmbH. The protocol was officially released in 1986 at the Society o ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Router (computing)
A router is a computer and networking device that Packet forwarding, forwards data packets between computer networks, including internetworks such as the global Internet. Routers perform the "traffic directing" functions on the Internet. A router is connected to two or more data lines from different IP networks. When a data packet comes in on a line, the router reads the network address information in the packet header to determine the ultimate destination. Then, using information in its routing table or routing policy, it directs the packet to the next network on its journey. Data packets are forwarded from one router to another through an internetwork until it reaches its destination Node (networking), node. The most familiar type of Internet Protocol, IP routers are Residential gateway, home and small office routers that forward IP packet (other), IP packets between the home computers and the Internet. More sophisticated routers, such as enterprise routers, conne ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Media Access Control
In IEEE 802 LAN/MAN standards, the medium access control (MAC), also called media access control, is the layer that controls the hardware responsible for interaction with the wired (electrical or optical) or wireless transmission medium. The MAC sublayer and the logical link control (LLC) sublayer together make up the data link layer. The LLC provides flow control and multiplexing for the logical link (i.e. EtherType, 802.1Q VLAN tag etc), while the MAC provides flow control and multiplexing for the transmission medium. These two sublayers together correspond to layer 2 of the OSI model. For compatibility reasons, LLC is optional for implementations of IEEE 802.3 (the frames are then "raw"), but compulsory for implementations of other IEEE 802 physical layer standards. Within the hierarchy of the OSI model and IEEE 802 standards, the MAC sublayer provides a control abstraction of the physical layer such that the complexities of physical link control are invisible to ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
