|
Coffman Engine Starter
The Coffman engine starter (also known as a "shotgun starter") was a starting system used on many piston engines in aircraft and armored vehicles of the 1930s and 1940s. It used a cordite cartridge to move a piston, which cranked the engine. The Coffman system was one of the most common brands; another was the Breeze cartridge system, which was produced under Coffman patents. Most American military aircraft and tanks which used radial engines were equipped with this system. Some versions of the Rolls-Royce Merlin engine used in the British Supermarine Spitfire used the Coffman system as a starter. The Hawker Typhoon and Hawker Tempest also used the Coffman system to start their Napier Sabre engines. Cartridge starters used on a number of jet engines, including such engines as the Rolls-Royce Avon, which were used in the English Electric Canberra and Hawker Hunter aircraft, used a high gas volume cartridge driving a turbine instead of a piston. Some Snowcat and similar ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
 |
Piston
A piston is a component of reciprocating engines, reciprocating pumps, gas compressors, hydraulic cylinders and pneumatic cylinders, among other similar mechanisms. It is the moving component that is contained by a cylinder (engine), cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In a pump, the function is reversed and force is transferred from the crankshaft to the piston for the purpose of compressing or ejecting the fluid in the cylinder. In some engines, the piston also acts as a valve by covering and uncovering Porting (engine)#Two-stroke porting, ports in the cylinder. __TOC__ Piston engines Internal combustion engines An internal combustion piston engine, internal combustion engine is acted upon by the pressure of the expanding combustion gases in the combustion chamber space at the top of the cylinder. This force then acts dow ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
 |
Starter (engine)
A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power. Starters can be electric motor, electric, pneumatic motor, pneumatic, or hydraulic motor, hydraulic. The starter can also be another internal-combustion engine in the case, for instance, of very large engines, or diesel engines in agricultural or excavation applications. Internal combustion engines are feedback systems, which, once started, rely on the inertia from each cycle to initiate the next cycle. In a four-stroke engine, the third stroke releases energy from the fuel, powering the fourth (exhaust) stroke and also the first two (intake, compression) strokes of the next cycle, as well as powering the engine's external load. To start the first cycle at the beginning of any particular session, the first two strokes must be powered in some other way than from the engine itself. The starter ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
Hearst Magazines
Hearst Magazines is a division of Hearst Communications that oversees its magazine publishing business in the United States and abroad. Its headquarters are located at Hearst Tower in the Midtown Manhattan of New York City. It has an audience of more than 165 million readers and site visitors, directly engaging with 70 percent of all millennials and 69 percent of all Gen Z age of 18. In 2019, it acquired the rights to '' Autoweek'' from Crain Communications. In December 2024, Hearst Communications acquired Motor Trend Group and most of its assets from Warner Bros. Discovery. The division was placed into Hearst Magazines. International Hearst Magazines International comprises eight owned and operated companies, nine joint ventures, and 45 licensing partners in 57 countries. The international division of Hearst Magazines controls more than 200 publications and 150 websites worldwide. The division was expanded after it acquired the international division of Hachette Filipacc ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
 |
Popular Mechanics
''Popular Mechanics'' (often abbreviated as ''PM'' or ''PopMech'') is a magazine of popular science and technology, featuring automotive, home, outdoor, electronics, science, do it yourself, and technology topics. Military topics, aviation and transportation of all types, space, tools and gadgets are commonly featured. It was founded in 1902 by Henry Haven Windsor, who was the editor and—as owner of the Popular Mechanics Company—the publisher. For decades, the tagline of the monthly magazine was "Written so you can understand it." In 1958, PM was purchased by the Hearst Corporation, now Hearst Communications. In 2013, the US edition changed from twelve to ten issues per year, and in 2014 the tagline was changed to "How your world works." The magazine added a podcast in recent years, including regular features ''Most Useful Podcast Ever'' and ''How Your World Works''. History ''Popular Mechanics'' was founded as a weekly in Chicago by Henry Haven Windsor, with the first ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
 |
Flame Holder
A flame holder is a Components of jet engines, component of a jet engine used as an Pyrotechnic initiator, ignitor to help maintain continual combustion. In a scramjet engine the residence time of the fuel is very low and complete penetration of the fuel into the flow will not occur. To avoid these conditions flame holders are used. All continuous-combustion jet engines require a flame holder. A flame holder creates a low-speed eddy (fluid dynamics), eddy in the engine to prevent the flame from being blown out. The design of the flame holder is an issue of balance between a stable eddy and Drag (physics), drag. The simplest design, often used in amateur projects, is the can-type flame holder, which consists of a Tin can, can covered in small holes. Much more effective is the H-gutter flame holder, which is shaped like a letter H with a curve facing and opposing the flow of air. Even more effective, however, is the V-gutter flame holder, which is shaped like a V with the point in ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
 |
Components Of Jet Engines
This article briefly describes the components and systems found in jet engines. Major components Major components of a turbojet including references to turbofans, turboprops and turboshafts: *Cold section: **Air intake (inlet) — For subsonic aircraft, the inlet is a duct which is required to ensure smooth airflow into the engine despite air approaching the inlet from directions other than straight ahead. This occurs on the ground from cross winds and in flight with aircraft pitch and yaw motions. The duct length is minimised to reduce drag and weight. Air enters the compressor at about half the speed of sound so at flight speeds lower than this the flow will accelerate along the inlet and at higher flight speeds it will slow down. Thus the internal profile of the inlet has to accommodate both accelerating and diffusing flow without undue losses. For supersonic aircraft, the inlet has features such as cones and ramps to produce the most efficient series of shockwaves which for ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
Monopropellant
Monopropellants are propellants consisting of chemicals that release energy through exothermic chemical decomposition. The molecular bond energy of the monopropellant is released usually through use of a catalyst. This can be contrasted with bipropellants that release energy through the chemical reaction between an oxidizer and a fuel. While stable under defined storage conditions, monopropellants decompose very rapidly under certain other conditions to produce a large volume of its own energetic (hot) gases for the performance of mechanical work. Although solid deflagrants such as nitrocellulose, the most commonly used propellant in firearms, could be thought of as monopropellants, the term is usually reserved for liquids in engineering literature. Uses The most common use of monopropellants is in low-impulse monopropellant rocket motors, such as reaction control thrusters, the usual propellant being hydrazine, p. 230 which is generally decomposed by exposure to an irid ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
|
Isopropyl Nitrate
In organic chemistry, a propyl group is a three-carbon alkyl substituent with chemical formula for the linear form. This substituent form is obtained by removing one hydrogen atom attached to the terminal carbon of propane. A propyl substituent is often represented in organic chemistry with the symbol Pr (not to be confused with the element praseodymium). An isomeric form of propyl is obtained by moving the point of attachment from a terminal carbon atom to the central carbon atom, named isopropyl or 1-methylethyl. To maintain four substituents on each carbon atom, one hydrogen atom has to be moved from the middle carbon atom to the carbon atom which served as attachment point in the ''n''-propyl variant, written as . Linear propyl is sometimes termed normal and hence written with a prefix ''n''- (i.e., ''n-''propyl), as the absence of the prefix ''n''- does not indicate which attachment point is chosen, i.e. absence of prefix does not automatically exclude the possibility of i ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
|
 |
Air-start System
An air-start system is a power source used to provide the initial rotation to start large diesel engines and gas turbines. Diesel engines Direct starting Compared to a gasoline (petrol) engine, a diesel engine has a very high compression ratio, an essential design feature, as it is the heat of compression that ignites the fuel. An electric starter with sufficient power to turn a large diesel engine would itself be so large as to be impractical so there is a need for an alternative system. An air start system has three main components along with various safety components, namely the air start injector, the distributor and the air receivers. When the system is initiated, starting air from the receivers is distributed by the distributor unit to each respective air start valve according to the firing order of the engine’s cylinders. Safety components include flame traps, to prevent air line explosions, a turning gear interlock which ensures that air-start cannot be initiated when t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
 |
Aircraft Engine Starting
Many variations of aircraft engine starting have been used since the Wright brothers made their first powered flight in 1903. The methods used have been designed for weight saving, simplicity of operation and reliability. Early piston engines were started by hand. Geared hand starting, electrical and cartridge-operated systems for larger engines were developed between the First and Second World Wars. Gas turbine aircraft engines such as turbojets, turboshafts and turbofans often use air/pneumatic starting, with the use of ''bleed air'' from built-in auxiliary power units (APUs) or external air compressors now seen as a common starting method. Often only one engine needs be started using the APU (or remote compressor). After the first engine is started using APU bleed air, ''cross-bleed air'' from the running engine can be used to start the remaining engine(s). Piston engines Hand starting/propeller swinging Hand starting of aircraft piston engines by swinging the propeller is t ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |
 |
Steel
Steel is an alloy of iron and carbon that demonstrates improved mechanical properties compared to the pure form of iron. Due to steel's high Young's modulus, elastic modulus, Yield (engineering), yield strength, Fracture, fracture strength and low raw material cost, steel is one of the most commonly manufactured materials in the world. Steel is used in structures (as concrete Rebar, reinforcing rods), in Bridge, bridges, infrastructure, Tool, tools, Ship, ships, Train, trains, Car, cars, Bicycle, bicycles, Machine, machines, Home appliance, electrical appliances, furniture, and Weapon, weapons. Iron is always the main element in steel, but other elements are used to produce various grades of steel demonstrating altered material, mechanical, and microstructural properties. Stainless steels, for example, typically contain 18% chromium and exhibit improved corrosion and Redox, oxidation resistance versus its carbon steel counterpart. Under atmospheric pressures, steels generally ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] [Amazon] |