Lockheed Martin X-35

The Lockheed Martin X-35 is a concept demonstrator aircraft (CDA) developed by Lockheed Martin for the Joint Strike Fighter program. The X-35 was declared the winner over the competing Boeing X-32 and a developed, armed version went on to enter production in the early 21st century as the F-35 Lightning II.

Development

The Joint Strike Fighter evolved out of several requirements for a common fighter to replace existing types. The actual JSF development contract was signed on 16 November 1996. The JSF program was created to replace various aircraft while keeping development, production, and operating costs down. This was pursued by building three variants of one aircraft, with the initial goal of the variants sharing over 70% of their parts.

The first is the F-35A, a conventional takeoff and landing (CTOL) variant. It is the smallest and lightest version, and is intended primarily to replace the U.S. Air Force's aging F-16 Fighting Falcons and A-10 Thunderbolt IIs. This is the only version with an internal gun, the GAU-22. The F-35B is the short-takeoff and vertical-landing (STOVL) variant due to replace the U.S. Marine Corps AV-8 Harrier IIs and F/A-18 Hornets, and Royal Air Force/Royal Navy Harrier GR7/GR9s beginning in 2015.

The Royal Navy will use this to replace its Harrier GR7s and the RAF replace its Harrier GR9s. The U.S. Marine Corps will use the F-35B to replace both its AV-8B Harrier IIs and F/A-18 Hornets with a design similar in size to the Air Force F-35A, trading fuel volume for vertical flight systems. Like the Harrier, guns will be carried in a pod. Vertical flight is by far the riskiest, and in the end, a decisive factor in design. Lastly, the F-35C, a carrier-based (CV) variant, will replace the "legacy" F/A-18 Hornets and serve as a stealthy complement to the F/A-18E/F Super Hornet.

It will have a larger, folding wing and larger control surfaces for improved low-speed control, and stronger landing gear for the stresses of carrier landings. The larger wing area provides increased range and payload, achieving much the same goal as the much heavier Super Hornet. The U.S. Navy initially planned to purchase 480 JSF; this number was eventually revised to 260 aircraft, with an additional 80 for the U.S. Marine Corps.

The primary customers and financial backers are the United States and the United Kingdom. Eight other nations are also funding the aircraft's development. Total program development costs, less procurement, are estimated at over US$40 billion, of which the bulk has been underwritten by the United States. Production costs are estimated at US$102 million per unit for 2,400 units.

There are three levels of international participation. The United Kingdom is the sole 'Level 1' partner, contributing slightly over US$2 billion, about 10% of the development costs. Level 2 partners are Italy, which is contributing US$1 billion, and the Netherlands, US$800 million. At Level 3 are Canada, US$440 million; Turkey, US$175 million; Australia, US$144 million; Norway, US$122 million; and Denmark, US$110 million. The levels generally reflect the financial stake in the program, the amount of technology transfer and subcontracts open for bid by national companies, and the priority order in which countries can obtain production aircraft. Israel and Singapore have also joined as Security Cooperative Participants. Due to delays in development and testing, the introduction date of the F-35 was gradually pushed from 2010 to 2015.

Design

Elements of the X-35 design were pioneered by the F-22 Raptor, and portions of the VTOL exhaust duct design were previously used by the Convair Model 200, a 1972 supersonic VTOL fighter requirement for the Sea Control Ship; in particular, the three-bearing swivel nozzle used in the X-35B was pioneered by the Convair design.

Additionally, Lockheed purchased technical data from the canceled Yakovlev Yak-141 in 1991 for examination and analysis of its swivel nozzle. Although helmet-mounted display systems have already been integrated into some fourth-generation fighters such as the JAS 39 Gripen, the F-35 will be the first modern combat aircraft in which helmet-mounted displays will replace a head-up display altogether.Jenkins, Jim
"Chief test pilot gives brief on F-35."
''DC military'', 2001. Retrieved 6 July 2008.

During concept definition, two demonstrator airframes for each contractor team would be flight-tested. Lockheed Martin's demonstrator aircraft consisted of the X-35A (which was later converted into the X-35B), and the larger-winged X-35C. Both the X-32 and X-35 power plants were derived from Pratt & Whitney's F119, with the STOVL variant of the latter incorporating a Rolls-Royce Lift Fan module. Because these were proof of concept demonstrators for STOVL risk reduction, the demonstrator aircraft did not need to have the internal structure or most subsystems of the final aircraft as a weapon system.

Shaft-driven lift fan

Instead of lift engines or using a direct lift engine like the Rolls-Royce Pegasus in the Harrier jump jet, the X-35B was powered by the F119-PW-611 which used the new shaft-driven lift fan system, patented by Lockheed Martin engineer Paul Bevilaqua, and developed by Rolls-Royce.. In normal wing-borne flight, the F119-PW-611 was configured as a normal medium-bypass reheated turbofan. The turbofan acted somewhat like a turboshaft engine embedded into the fuselage (but with a much smaller percentage of total heat energy being extracted by the turbine stage).

A portion of engine power was extracted via a turbine, and used to drive a shaft running forward via a clutch-and-bevel gearbox to a vertically mounted, contra-rotating lift fan. This was located forward of the main engine in the center of the aircraft (this can also be viewed the same as a high-bypass turbofan but with the low-pressure fan stages mounted remotely from the engine core on an extended, clutched shaft, and creating thrust downwards rather than back around the engine core as in a conventional turbofan).

Bypass air from the cruise engine medium-bypass turbofan compressor stages exhausted through a pair of roll-post nozzles in the wings on either side of the fuselage, while the thrust from the lift fan balanced the thrust of the hot core stream exhausting through vectored cruise nozzle at the tail. The X-35B powerplant effectively acted as a flow multiplier, much as a turbofan achieves efficiencies by moving unburned air at a lower velocity, and getting the same effect as the Harrier's huge, but supersonically impractical main fan.

Like lift engines, this added machinery was dead weight during flight, but the increased lift thrust enhanced take-off payload by even more. The cool fan also reduced the harmful effects of hot, high-velocity air which could harm runway pavement or an aircraft carrier deck. Though risky and complicated, it was made to work to the satisfaction of DoD officials, and flight testing of the X-35 demonstrators reduced risk to Technology Readiness Level 6.

Operational history

Flight test evaluation

The X-35A first flew on 24 October 2000 and tested air vehicle performance and handling characteristics. After 28 test flights, the aircraft was converted to the X-35B, which added the shaft-drive lift fan, aft swivel nozzle, and roll posts. On 20 July 2001, to demonstrate the X-35's STOVL capability, the X-35B took off in less than , went supersonic, and landed vertically."Propulsion system in Lockheed Martin Joint Strike Fighter wins Collier Trophy."
''Lockheed Martin'', 28 February 2003. Retrieved 9 January 2010. The X-35C first flew on 16 December 2000 and tested simulated carrier recovery and power approach.

In the fly-off between the X-32 and the X-35, the latter was judged to be the winner. As a result, a contract for System Development and Demonstration (SDD) of the F-35 was awarded on 26 October 2001 to Lockheed Martin.Bolkcom, Christopher
"JSF: Background, Status, and Issues," p. CRS-4.
''DTIC'', 16 June 2003. Retrieved 18 September 2010.

F-35 production

There are a number of differences between the X-35 and F-35, which was designed to be an operational weapon system. The forward fuselage was lengthened by to make room for mission avionics, while the horizontal stabilizers were correspondingly moved aft to retain balance and control. The diverterless supersonic inlet cowl shape changed from a four-sided to a three-sided shape and was moved aft. To accommodate weapons bays, the fuselage section was fuller with the top surface raised by along the centerline. Following the designation of the X-35 prototypes, the three variants were designated F-35A (CTOL), F-35B (STOVL), and F-35C (CV).

Aircraft on display

The X-35A was converted into the X-35B for the STOVL part of the competition. It now resides at the National Air and Space Museum Steven F. Udvar-Hazy Center, near Washington Dulles International Airport in Virginia.

Following the end of the competition, the X-35C was transferred to the Patuxent River Naval Air Museum in St. Mary's County, Maryland.

Specifications (X-35A)

Differences between variants

See also

Notes

References

Bibliography

*
*
*
* .
* .
* .
* .

External links

* .
* .
* .
* .
* .

{{Stealth aircraft

Edwards Air Force Base
X-035
2000s United States experimental aircraft
Single-engined jet aircraft
Mid-wing aircraft
Lift fan
Lockheed Martin F-35 Lightning II
Articles containing video clips
Aircraft first flown in 2000
Stealth aircraft