sailing Sailing employs the wind—acting on sails, wingsails or kites—to propel a craft on the surface of the ''water'' (sailing ship, sailboat, raft, windsurfer, or kitesurfer), on ''ice'' (iceboat) or on ''land'' ( land yacht) over a chose ...

, a halyard or halliard is a line (

rope A rope is a group of yarns, plies, fibres, or strands that are twisted or braided together into a larger and stronger form. Ropes have tensile strength and so can be used for dragging and lifting. Rope is thicker and stronger than similarl ...

) that is used to hoist a

ladder A ladder is a vertical or inclined set of rungs or steps used for climbing or descending. There are two types: rigid ladders that are self-supporting or that may be leaned against a vertical surface such as a wall, and rollable ladders, such ...

sail A sail is a tensile structure—which is made from fabric or other membrane materials—that uses wind power to propel sailing craft, including sailing ships, sailboats, windsurfers, ice boats, and even sail-powered land vehicles. Sails ma ...

flag A flag is a piece of fabric (most often rectangular or quadrilateral) with a distinctive design and colours. It is used as a symbol, a signalling device, or for decoration. The term ''flag'' is also used to refer to the graphic design empl ...

or yard. The term ''halyard'' comes from the phrase "to haul yards". Halyards, like most other parts of the running rigging, were classically made of natural fibre like

manila Manila ( , ; fil, Maynila, ), officially the City of Manila ( fil, Lungsod ng Maynila, ), is the capital of the Philippines, and its second-most populous city. It is highly urbanized and, as of 2019, was the world's most densely populated ...

hemp Hemp, or industrial hemp, is a botanical class of '' Cannabis sativa'' cultivars grown specifically for industrial or medicinal use. It can be used to make a wide range of products. Along with bamboo, hemp is among the fastest growing plants ...

Sail types

* A

square rig Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called '' yards'' ...

sail with a halyard is mounted on a lifting yard that is free to slide on a short section of the mast. The halyard is used to raise (hail or hal) the yard when setting the sail. * A gaff rigged sail has two; a throat halyard to lift the end of the gaff nearer the mast, and a peak halyard to lift the outer end. * A more modern triangular (Bermuda or "Marconi") sail has only one halyard which is attached at its uppermost point (the ''head'').

Fastenings

Halyards can be attached a number of ways to the head of a triangular sail. The most common methods are as follows: # A

shackle A shackle (or shacklebolt), also known as a gyve, is a U-shaped piece of metal secured with a clevis pin or bolt across the opening, or a hinged metal loop secured with a quick-release locking pin mechanism. The term also applies to handcuff ...

through a headboard on the sail. # A bowline through a hole in the head. # A half hitch with a figure-eight knot, preferred over a bowline because it allows the sail to get closer to the top of the mast. The other end of the halyard is usually attached to the mast at its foot by way of a cleat. It is convention in some places to fasten the main halyard (for the mainsail) on the

starboard Port and starboard are nautical terms for watercraft and aircraft, referring respectively to the left and right sides of the vessel, when aboard and facing the bow (front). Vessels with bilateral symmetry have left and right halves which ar ...

side of the mast and the jib halyard to the

port A port is a maritime facility comprising one or more wharves or loading areas, where ships load and discharge cargo and passengers. Although usually situated on a sea coast or estuary, ports can also be found far inland, such as H ...

side. This allows quicker access to the lines in a time-critical situation.

Jumping/sweating the halyard

"Jumping the halyard" is a technique used to raise a large sail quickly by employing a few crew members to work simultaneously on the halyard. The person ''jumping'' stands next to the mast and manually grabs the halyard as high as they can (sometimes this necessitates jumping) and pulling it down as fast and far as possible. While this crew member reaches for the next heave, a second crew member 'tails' or takes up the slack created by the jumper, on a

winch A winch is a mechanical device that is used to pull in (wind up) or let out (wind out) or otherwise adjust the tension of a rope or wire rope (also called "cable" or "wire cable"). In its simplest form, it consists of a spool (or drum) attach ...

. When the person jumping can no longer pull up the sail simply by hanging on the halyard, they must "sweat" the line. To "sweat" the halyard is to take as much slack out of it as possible. This may be done with a winch, or manually. To manually sweat a halyard, the sweater grasps the line and, in a fluid motion, hauls it laterally towards themself, then down toward the deck, letting the ''tailer'' take up the new slack.

References

External links

{{Sail Types Sailing rigs and rigging Sailboat components