HDCAM SR
   HOME

TheInfoList



OR:

HDCAM is a
high-definition video High-definition video (HD video) is video of higher resolution and quality than standard-definition. While there is no standardized meaning for ''high-definition'', generally any video image with considerably more than 480 vertical scan lines ...
digital recording In digital recording, an audio or video signal is converted into a stream of discrete numbers representing the changes over time in air pressure for audio, or chroma and luminance values for video. This number stream is saved to a storage ...
videocassette Videotape is magnetic tape used for storing video and usually sound in addition. Information stored can be in the form of either an analog or digital signal. Videotape is used in both video tape recorders (VTRs) and, more commonly, videocasset ...
version of Digital Betacam introduced in 1997 that uses an 8-bit discrete cosine transform (DCT) compressed 3:1:1 recording, in
1080i 1080i (also known as Full HD or BT.709) is a combination of frame resolution and scan type. 1080i is used in high-definition television (HDTV) and high-definition video. The number "1080" refers to the number of horizontal lines on the scree ...
-compatible down-sampled resolution of 1440×1080, and adding
24p In video technology, 24p refers to a video format that operates at 24 frames per second (typically, 23.976 frame/s when using equipment based on NTSC frame rates, but now 24.000 in many cases) frame rate with progressive scanning (not interlaced). O ...
and 23.976 progressive segmented frame (PsF) modes to later models. The HDCAM codec uses rectangular pixels and as such the recorded 1440×1080 content is upsampled to 1920×1080 on playback. The recorded video bit rate is 144 Mbit/s. Audio is also similar, with four channels of AES3 20-bit, 48 kHz
digital audio Digital audio is a representation of sound recorded in, or converted into, digital form. In digital audio, the sound wave of the audio signal is typically encoded as numerical samples in a continuous sequence. For example, in CD audio, samp ...
. Like Betacam, HDCAM tapes were produced in small and large cassette sizes; the small cassette uses the same form factor as the original
Betamax Betamax (also known as Beta, as in its logo) is a consumer-level analog recording and cassette format of magnetic tape for video, commonly known as a video cassette recorder. It was developed by Sony and was released in Japan on May 10, 1975, ...
. The main competitor to HDCAM was the DVCPRO HD format offered by Panasonic, which uses a similar compression scheme and bit rates ranging from 40 Mbit/s to 100 Mbit/s depending on frame rate. HDCAM is standardized as SMPTE 367M, also known as SMPTE D-11. Like most videotape formats, HDCAM is no longer in widespread use, having been superseded by memory cards, disk-based recording formats, and SSDs. Sony officially discontinued the format in 2016.


SMPTE 367M

SMPTE 367M, also known as SMPTE D-11, is the
SMPTE The Society of Motion Picture and Television Engineers (SMPTE) (, rarely ), founded in 1916 as the Society of Motion Picture Engineers or SMPE, is a global professional association of engineers, technologists, and executives working in the m ...
standard for HDCAM. The standard specifies compression of high-definition digital video. D11 source picture rates can be 24, 24/1.001, 25 or 30/1.001 frames per second
progressive scan Progressive scanning (alternatively referred to as noninterlaced scanning) is a format of displaying, storing, or transmitting moving images in which all the lines of each frame are drawn in sequence. This is in contrast to interlaced video use ...
, or 50 or 60/1.001 fields per second
interlaced Interlaced video (also known as interlaced scan) is a technique for doubling the perceived frame rate of a video display without consuming extra bandwidth. The interlaced signal contains two fields of a video frame captured consecutively. This ...
; compression yields output bit rates ranging from 112 to 140 Mbit/s. Each D11 source frame is composed of a
luminance Luminance is a photometric measure of the luminous intensity per unit area of light travelling in a given direction. It describes the amount of light that passes through, is emitted from, or is reflected from a particular area, and falls with ...
channel at 1920 x 1080 pixels and a
chrominance Chrominance (''chroma'' or ''C'' for short) is the signal used in video systems to convey the color information of the picture (see YUV color model), separately from the accompanying luma signal (or Y' for short). Chrominance is usually represen ...
channel at 960 x 1080 pixels. During compression, each frame's luminance channel is subsampled at 1440 x 1080, while the chrominance channel is subsampled at 480 x 1080.


HDCAM SR

HDCAM SR was introduced in 2003 and standardised in SMPTE 409M-2005. It uses a higher particle density tape and is capable of recording in 10 bits 4:2:2 or 4:4:4 RGB with a video bit rate of 440 Mbit/s, and a total data rate of approximately 600 Mbit/s.Sony HDCAM SR FAQ
The increased bit rate (over HDCAM) allows HDCAM SR to capture much more of the full bandwidth of the HD-SDI signal (1920×1080). Some HDCAM SR VTRs can also use a 2× mode with an even higher video bit rate of 880 Mbit/s, allowing for a single 4:4:4 stream at a lower compression or two 4:2:2 video streams simultaneously. HDCAM SR uses
MPEG-4 Part 2 MPEG-4 Part 2, MPEG-4 Visual (formally ISO/IEC 14496-2) is a video compression format developed by the Moving Picture Experts Group (MPEG). It belongs to the MPEG-4 ISO/IEC standards. It uses block-wise motion compensation and a discrete cosi ...
Simple Studio Profile for compression, and expands the number of audio channels up to 12 at 48 kHz/24-bit. There are 12 channels of audio recorded uncompressed at 24 bit 48 kHz sampling. Each channel is capable of recording AES3 non-audio data. HDCAM SR was used commonly for HDTV television production. In the mid-2000s, many prime-time network television shows used HDCAM SR as a master recording medium, but it is no longer in widespread use. Some HDCAM VTRs play back older Betacam variants, for example the Sony SRW-5500 HDCAM SR recorder plays back and records HDCAM and HDCAM SR tapes, and with optional hardware also plays and upconverts Digital Betacam tapes to HD format. Tape lengths are the same as for Digital Betacam, up to 40 minutes for S and 124 minutes for L tapes. In 24p mode the runtime increases to 50 and 155 minutes, respectively. HDCAM tapes are black with an orange lid, and HDCAM SR tapes black with a cyan lid. 440 Mbit/s mode is known as SQ, and 880 Mbit/s mode is known as HQ. Sony also announced a higher compression mode called SR Lite. As with the 440 and 880 mode, SR Lite utilizes the MPEG-4 Part 2 Simple Studio Profile but decreases the bit rate to 220 Mbit/s for 60i and 183 Mbit/s for 50i. SR Lite is locked at 4:2:2 color sampling but still maintains 10 bit pixel depth. It also allows for 50 and 60p at the cost of a doubled data rate (440 Mbit/s for 60p). The Sony SRW-5800 HDCAM SR VTR has the ability to record both the left eye and right eye of 3D content to a single tape. It syncs the two eyes together and takes up twice as much space on the tape as a normal recording. Other HDSR decks also support 3D such as the SRW-1 HDCAM SR Portable VTR and the SRW-5500/5000 which can play back either channel A or channel B of the Dual Stream 4:2:2 recording.


See also

*
XDCAM XDCAM is a series of products for digital recording using random access solid-state memory media, introduced by Sony in 2003. Four different product lines the XDCAM SD, XDCAM HD, XDCAM EX and XDCAM HD422 differ in types of en ...
* XAVC


References


External links


Guide To DTV Standards: Video Recording

Overview of Digital Video Standards
-- PowerPoint presentation {{Sony Corp Video storage Film and video technology SMPTE standards