Blaw-Knox tower

The Blaw-Knox company was an American manufacturer of steel structures and construction equipment based in Pittsburgh, Pennsylvania. The company is today best known for its radio towers, most of which were constructed during the 1930s in the United States. Although Blaw-Knox built many kinds of towers, the term Blaw-Knox tower (or radiator) usually refers to the company's unusual "diamond cantilever" design, which is stabilized by guy wires attached only at the vertical center of the mast, where its cross-section is widest. During the 1930s AM radio broadcasting stations adopted single mast radiator antennas, and the Blaw-Knox design was the first type used. A 1942 advertisement claims that 70% of all radio towers in the United States at the time were built by Blaw-Knox.

The distinctive diamond-shaped towers became an icon of early radio. Several are listed on the United States National Register of Historic Places,WSM tower gets 'historic' status
''The Tennessean'', April 14, 2011 the distinctive diamond antenna design has been incorporated into logos of various organizations related to radio and a very large (scale) replica of the WSM (AM) Blaw-Knox tower has been built into the Country Music Hall of Fame and Museum.

Design

The diamond-shaped tower was patented by Nicholas Gerten and Ralph Jenner for Blaw-Knox July 29, 1930.US patent 1897373, Nicholas Gerten, Ralph Lindsay Jenner,
Wave Antenna
', filed July 29, 1930, granted March 14, 1933 and was one of the first mast radiators. Previous antennas for medium and longwave broadcasting usually consisted of wires strung between masts, but in the Blaw-Knox antenna, as in modern AM broadcasting mast radiators, the metal mast structure functioned as the antenna. To prevent the high frequency potential on the mast from short-circuiting to ground, the narrow lower end of the tower rested on a ceramic insulator about three-foot wide, shaped like a ball and socket joint. Thus, the tower required guy-wires to hold it upright.

The distinguishing feature of the Blaw-Knox tower was its wide diamond (or rhomboidal, rhombohedron) shape, which served to make it rigid, to resist shear stresses. One advantage of this was to reduce the number of guys needed. Blaw-Knox masts required only one set of three or four guys, attached at the tower's wide "waist". In contrast, narrow masts require two to four sets of guys, attached at different heights, to prevent the tower from buckling. The advantage of fewer guys was to simplify the electrical design of the antenna, because conductive guys interfered with its radiation pattern. The guys acted as " parasitic" resonant elements, reradiating the radio waves in other directions and thus altering the antenna's radiation pattern. In some Blaw-Knox mast designs ''(see WBT towers, right)'' the upper pyramidal section was made longer than the lower, to keep the attachment point of the guys as low as possible, to minimize their interference.

Another advantage mentioned in the patent was that the tower could be erected in two parts. Half of the mast could be built, then its wide central section could be used as a stable base on which to erect the other half.

A disadvantage of the diamond mast shape was that the current distribution on the tower caused less radio power to be radiated in horizontal directions and more at an angle into the sky, compared to a slender uniform width mast. Since AM radio stations covered their listening areas with '' ground waves'', radio waves that traveled horizontally close to the ground surface, this meant the listening area was smaller. The realization of the nonideal radiation pattern of the design caused the diamond-shaped tower to fall out of favor in the 1940s in radio stations, replaced by the narrow uniform width lattice mast used today.

List of Blaw-Knox towers

Many Blaw-Knox towers, of both conventional (uniform cross-section) and diamond design, remain in use in the United States. Few of the diamond towers were built, and several remain; all transmit AM radio signals. The most well-known example in Europe is the Lakihegy Tower, located in Szigetszentmiklós-Lakihegy, Hungary. Several additional diamond cantilever towers were built at stations in the Central Valley of California, but are less well known. These towers were much smaller in both height and cross-section than the towers listed elsewhere; only one — KSTN, Stockton — remains in use for broadcasting.

indicates a structure that is no longer standing.

indicates a structure that has had a change in height.

indicates a structure that has been rebuilt.

Three other Blaw Knox towers of unknown heights also used to exist but have since been removed for the following stations; WABC in Wayne, N.J., WCAU's in Newtown Square, Pennsylvania and WHO in Des Moines, Iowa.

Blaw-Knox also constructed a 469-foot (143 m) tall tower in 1948Antenna Structure Registration 1007142
FCCInfo.com, a service of Cavell, Mertz & Associates, Inc. Retrieved 2020-08-15. for WKQI (then known as WLDM) located on Ten Mile Road in the Detroit suburb of Oak Park, Michigan. However, unlike its namesake diamond cantilever form, this structure was built as a conventional four-sided self-supporting lattice tower.

Gallery

File:Radio-transmitter-antena-at-Vakarel.jpg, Vakarel radio transmitter
File:WBNS Blaw-Knox.jpg, 380 ft Blaw-Knox tower owned by WBNS Radio in Columbus, Ohio
File:WLW-AM RadioTower.PNG, WLW's diamond-shaped Blaw-Knox radio tower has been in use since 1934

See also

* Radio masts and towers
* Blawnox, Pennsylvania

Notes

References

{{Reflist

External links

Blaw-Knox Technical Origins



Telecommunications equipment
Radio masts and towers in the United States