reserve static line on:
[Wikipedia]
[Google]
[Amazon]
A reserve static line, occasionally called a Stevens Lanyard, is a device that automatically opens the reserve parachute container when the main parachute is SIM > Read > Section 5"">"U.S. Parachute Association > SIM > Read > Section 5"
USPA.org. Retrieved 2010-07-06 An RSL also offers protection in the event a jumper cuts-away but does not (or can not) reach for the reserve deployment handle. The RSL can be disengaged by a skydiver in situations where it is desirable to detach the main parachute without deploying the reserve. Examples of such situations may include certain high-wind landings (in case the parachute must be cut away if the skydiver is being dragged across the ground), when performing canopy formations or when landing over water. The RSL attaches to the risers through a small metal loop that will disconnect when a fabric tab is pulled.
A reserve static line, occasionally called a Stevens Lanyard, is a device that automatically opens the reserve parachute container when the main parachute is cut-away
{{Unreferenced, date=December 2009
Cut-away is a skydiving term referring to disconnecting the main parachute from the harness-container in case of a malfunction in preparation for opening the reserve parachute. The 3-ring release system on parach ...
. The RSL is a lanyard connecting one or both of the main parachute risers to the reserve ripcord.
The primary advantage of using an RSL is a faster reserve parachute deployment compared with using emergency handles alone; after a cut-away, the RSL will usually activate before the reserve deployment ripcord is pulled. However, proper emergency procedures require the reserve ripcord to be pulled in the event that the RSL is disconnected or not functioning correctly.USPA.org. Retrieved 2010-07-06 An RSL also offers protection in the event a jumper cuts-away but does not (or can not) reach for the reserve deployment handle. The RSL can be disengaged by a skydiver in situations where it is desirable to detach the main parachute without deploying the reserve. Examples of such situations may include certain high-wind landings (in case the parachute must be cut away if the skydiver is being dragged across the ground), when performing canopy formations or when landing over water. The RSL attaches to the risers through a small metal loop that will disconnect when a fabric tab is pulled.
See also
*Skyhook (skydiving)
A Main-Assisted Reserve Deployment (MARD) system is a skydiving safety device for parachute systems. While there are many variations, the operation and intended outcome for each is the same: open the reserve parachute container and extract the ...
Notes
Parachuting {{Aviation-stub