Production–possibility frontier

A production–possibility frontier (PPF), production possibility curve (PPC), or production possibility boundary (PPB), or transformation curve/boundary/frontier is a curve which shows various combinations of the amounts of two goods which can be produced within the given resources and technology/a graphical representation showing all the possible options of output for two products that can be produced using all factors of production, where the given resources are fully and efficiently utilized per unit time. A PPF illustrates several economic concepts, such as allocative efficiency, economies of scale, opportunity cost (or marginal rate of transformation), productive efficiency, and scarcity of resources (the fundamental economic problem that all societies face).

This tradeoff is usually considered for an economy, but also applies to each individual, household, and economic organization. One good can only be produced by diverting resources from other goods, and so by producing less of them.

Graphically bounding the production set for fixed input quantities, the PPF curve shows the maximum possible production level of one commodity for any given production level of the other, given the existing state of technology. By doing so, it defines productive efficiency in the context of that production set: a point on the frontier indicates efficient use of the available inputs (such as points B, D and C in the graph), a point beneath the curve (such as A) indicates inefficiency, and a point beyond the curve (such as X) indicates impossibility.

PPFs are normally drawn as bulging upwards or outwards from the origin ("concave" when viewed from the origin), but they can be represented as bulging downward (inwards) or linear (straight), depending on a number of assumptions.

An outward shift of the PPC results from growth of the availability of inputs, such as physical capital or labour, or from technological progress in knowledge of how to transform inputs into outputs. Such a shift reflects, for instance, economic growth of an economy already operating at its full productivity (on the PPF), which means that more of ''both'' outputs can now be produced during the specified period of time without sacrificing the output of either good. Conversely, the PPF will shift inward if the labour force shrinks, the supply of raw materials is depleted, or a natural disaster decreases the stock of physical capital.

However, most economic contractions reflect not that less can be produced but that the economy has started operating below the frontier, as typically, both labour and physical capital are underemployed, remaining therefore idle.

In microeconomics, the PPF shows the options open to an individual, household, or firm in a two good world. By definition, each point on the curve is productively efficient, but, given the nature of market demand, some points will be more profitable than others. Equilibrium for a firm will be the combination of outputs on the PPF that is most profitable.

From a macroeconomic perspective, the PPF illustrates the production possibilities available to a nation or economy during a given period of time for broad categories of output. It is traditionally used to show the movement between committing all funds to consumption on the ''y''-axis versus investment on the ''x''-axis. However, an economy may achieve productive efficiency without necessarily being allocatively efficient. Market failure (such as imperfect competition or externalities) and some institutions of social decision-making (such as government and tradition) may lead to the wrong combination of goods being produced (hence the wrong mix of resources being allocated between producing the two goods) compared to what consumers would prefer, given what is feasible on the PPF.

Position

The two main determinants of the position of the PPF at any given time are the state of technology and management expertise (which are reflected in the available production functions) and the available quantities of factors of production (materials, direct labor, and factory overhead).

Only points on or within a PPF are actually possible to achieve in the short run. In the long run, if technology improves or if the supply of factors of production increases, the economy's capacity to produce both goods increases; if this potential is realized, economic growth occurs. That increase is shown by a shift of the production-possibility frontier to the right. Conversely, a natural, military or ecological disaster might move the PPF to the left in response to a reduction in an economy's productive capability. Thus all points on or within the curve are part of the production set: combinations of goods that the economy could potentially produce.

If the two production goods depicted are capital investment (to increase future production possibilities) and current consumption goods, the higher the investment this year, the more the PPF would shift out in following years. Shifts of the curve can represent how technological progress that favors production possibilities of one good, say guns, more than the other shifts the PPF outwards more along the favored good's axis, "biasing" production possibilities in that direction. Similarly, if one good makes more use of say capital and if capital grows faster than other factors, growth possibilities might be biased in favor of the capital-intensive good.Also a shift in the PPF could depict that there's an improvement in technology or good use of capital goods.

Properties

Efficiency

Production-Possibility Frontier delineates the maximum amount/quantities of outputs (goods/services) an economy can achieve, given fixed resources (factors of production) and fixed technological progress.

*Points that lie either on or below the production possibilities frontier/curve are possible/attainable: the quantities can be produced with currently available resources and technology.
*Points that lie above the production possibilities frontier/curve are not possible/unattainable because the quantities cannot be produced using currently available resources and technology.
*Points that lie strictly below the frontier/curve are inefficient, because the economy can produce more of at least one good without sacrificing the production of any other good, with existing resources and technology.
*Points that lie on the frontier/curve are efficient.
Points that are unattainable can be achieved through external trade and economic growth. Examples include importations of resources and technology, and the increase in the production of goods and services.

Specifically, at all points on the frontier, the economy achieves productive efficiency: no more output of any good can be achieved from the given inputs without sacrificing output of some good.

Some productive efficient points are Pareto efficient: impossible to find any trade that will make no consumer worse off. Pareto efficiency is achieved when the marginal rate of transformation (slope of the frontier/opportunity cost of goods) is equal to all consumers' marginal rate of substitution.

Similarly, not all Pareto efficient points on the frontier are Allocative efficient. Allocative efficient is only achieved when the economy produces at quantities that match societal preference.

A PPF typically takes the form of the curve illustrated above. An economy that is operating on the PPF is said to be efficient, meaning that it would be impossible to produce more of one good without decreasing production of the other good. In contrast, if the economy is operating below the curve, it is said to be operating inefficiently because it could reallocate resources in order to produce more of both goods or some resources such as labor or capital are sitting idle and could be fully employed to produce more of both goods.

For example, if one assumes that the economy's available quantities of factors of production do not change over time and that technological progress does not occur, if the economy is operating on the PPF, production of guns would need to be sacrificed to produce more butter. If production is efficient, the economy can choose between combinations (points) on the PPF: ''B'' if guns are of interest, ''C'' if more butter is needed, ''D'' if an equal mix of butter and guns is required.

In the PPF, all points ''on'' the curve are points of maximum productive efficiency (no more output of any good can be achieved from the given inputs without sacrificing output of some good); all points inside the frontier (such as ''A'') can be produced but are productively ''inefficient''; all points outside the curve (such as ''X'') cannot be produced with the given, existing resources. Not all points on the curve are Pareto efficient, however; only in the case where the marginal rate of transformation is equal to all consumers' marginal rate of substitution and hence equal to the ratio of prices will it be impossible to find any trade that will make no consumer worse off.

Any point that lies either on the production possibilities curve or to the left of it is said to be an attainable point: it can be produced with currently available resources. Points that lie to the right of the production possibilities curve are said to be unattainable because they cannot be produced using currently available resources. Points that lie strictly to the left of the curve are said to be inefficient, because existing resources would allow for production of more of at least one good without sacrificing the production of any other good. An efficient point is one that lies on the production possibilities curve. At any such point, more of one good can be produced only by producing less of the other.

For an extensive discussion of various types of efficiency measures ( Farrell, Hyperbolic, Directional, Cost, Revenue, Profit, Additive, etc.) and their relationships, see Sickles and Zelenyuk (2019, Chapter 3).

Marginal rate of transformation

The slope of the production–possibility frontier (PPF) at any given point is called the marginal rate of transformation (MRT). The slope defines the rate at which production of one good can be redirected (by reallocation of productive resources) into production of the other. It is also called the (marginal) "opportunity cost" of a commodity, that is, it is the opportunity cost of ''X'' in terms of ''Y'' at the margin. It measures how much of good Y is given up for one more unit of good ''X'' or vice versa. The shape of a PPF is commonly drawn as concave to the origin to represent increasing opportunity cost with increased output of a good. Thus, MRT increases in absolute size as one moves from the top left of the PPF to the bottom right of the PPF.

The marginal rate of transformation can be expressed in terms of either commodity. The marginal opportunity costs of guns in terms of butter is simply the reciprocal of the marginal opportunity cost of butter in terms of guns. If, for example, the (absolute) slope at point ''BB'' in the diagram is equal to 2, to produce one more packet of butter, the production of 2 guns must be sacrificed. If at ''AA'', the marginal opportunity cost of butter in terms of guns is equal to 0.25, the sacrifice of one gun could produce four packets of butter, and the opportunity cost of guns in terms of butter is 4.

Shape

The production-possibility frontier can be constructed from the contract curve in an Edgeworth production box diagram of factor intensity. The example used above (which demonstrates increasing opportunity costs, with a curve concave to the origin) is the most common form of PPF. It represents a disparity, in the factor intensities and technologies of the two production sectors. That is, as an economy specializes more and more into one product (such as moving from point ''B'' to point ''D''), the opportunity cost of producing that product increases, because we are using more and more resources that are less efficient in producing it. With increasing production of butter, workers from the gun industry will move to it. At first, the least qualified (or most general) gun workers will be transferred into making more butter, and moving these workers has little impact on the opportunity cost of increasing butter production: the loss in gun production will be small. However, the cost of producing successive units of butter will increase as resources that are more and more specialized in gun production are moved into the butter industry.

If opportunity costs are constant, a straight-line (linear) PPF is produced. This case reflects a situation where resources are not specialised and can be substituted for each other with no added cost. Products requiring similar resources (bread and pastry, for instance) will have an almost straight PPF and so almost constant opportunity costs. More specifically, with constant returns to scale, there are two opportunities for a linear PPF: if there was only one factor of production to consider or if the factor intensity ratios in the two sectors were constant at all points on the production-possibilities curve. With varying returns to scale, however, it may not be entirely linear in either case.

With economies of scale, the PPF would curve inward, with the opportunity cost of one good falling as more of it is produced. Specialization in producing successive units of a good determines its opportunity cost (say from mass production methods or specialization of labor).

Opportunity cost

From a starting point on the frontier, if there is no increase in productive resources, increasing the production of a first good entails decreasing the production of a second, because resources must be transferred to the first and away from the second. Points along the curve describe the tradeoff between the goods. The sacrifice in the production of the second good is called the ''opportunity cost'' (because increasing production of the first good entails losing the opportunity to produce some amount of the second). Opportunity cost is measured in the number of units of the second good forgone for one or more units of the first good.

In the context of a PPF, opportunity cost is directly related to the shape of the curve (see below). If the shape of the PPF curve is a straight-line, the opportunity cost is constant as the production of different goods is changing. But, opportunity cost usually will vary depending on the start and end points. In Figure 7, producing 10 more packets of butter, at a low level of butter production, costs the loss of 5 guns (shown as a movement from ''A'' to ''B''). At point ''C'', the economy is already close to its maximum potential butter output. To produce 10 more packets of butter, 50 guns must be sacrificed (as with a movement from ''C'' to ''D''). The ratio of gains to losses is determined by the ''marginal rate of transformation.'

Notes

References

Production Possibility Curve (PPC)HTML5 Interactive on Production Possibilities Curve
*
*
*
*
* Samuelson, Paul A. (1947, Enlarged ed. 1983). ''Foundations of Economic Analysis''. Ch. VIII for welfare-theoretical mathematical expression of PPF.
*
*
*Sickles, R., & Zelenyuk, V. (2019). Measurement of Productivity and Efficiency: Theory and Practice. Cambridge: Cambridge University Press. https://assets.cambridge.org/97811070/36161/frontmatter/9781107036161_frontmatter.pdf

{{DEFAULTSORT:Production-possibility frontier
Production economics
Economics curves