Group 4 element

Group 4 is the second group of transition metals in the periodic table. It contains the four elements titanium (Ti), zirconium (Zr), hafnium (Hf), and rutherfordium (Rf). The group is also called the titanium group or titanium family after its lightest member.

As is typical for early transition metals, zirconium and hafnium have only the group oxidation state of +4 as a major one, and are quite electropositive and have a less rich coordination chemistry. Due to the effects of the lanthanide contraction, they are very similar in properties. Titanium is somewhat distinct due to its smaller size: it has a well-defined +3 state as well (although +4 is more stable).

All the group 4 elements are hard, refractory metals. Their inherent reactivity is completely masked due to the formation of a dense oxide layer that protects them from corrosion, as well as attack by many acids and alkalis. The first three of them occur naturally. Rutherfordium is strongly radioactive: it does not occur naturally and must be produced by artificial synthesis, but its observed and theoretically predicted properties are consistent with it being a heavier homologue of hafnium. None of them have any biological role.

History

Zircon was known as a gemstone from ancient times, but it was not known to contain a new element until the work of German chemist Martin Heinrich Klaproth in 1789. He analysed the zircon-containing mineral jargoon and found a new earth (oxide), but was unable to isolate the element from its oxide. Cornish chemist Humphry Davy also attempted to isolate this new element in 1808 through electrolysis, but failed: he gave it the name zirconium. In 1824, Swedish chemist Jöns Jakob Berzelius isolated an impure form of zirconium, obtained by heating a mixture of potassium and potassium zirconium fluoride in an iron tube.

Cornish mineralogist William Gregor first identified titanium in ilmenite sand beside a stream in Cornwall, Great Britain in the year 1791. After analyzing the sand, he determined the weakly magnetic sand to contain iron oxide and a metal oxide that he could not identify. During that same year, mineralogist Franz Joseph Muller produced the same metal oxide and could not identify it. In 1795, chemist Martin Heinrich Klaproth independently rediscovered the metal oxide in rutile from the Hungarian village Boinik. He identified the oxide containing a new element and named it for the Titans of Greek mythology. Berzelius was also the first to prepare titanium metal (albeit impurely), doing so in 1825.Greenwood and Earnshaw, p. 954

The X-ray spectroscopy done by Henry Moseley in 1914 showed a direct dependency between spectral line and effective nuclear charge. This led to the nuclear charge, or atomic number of an element, being used to ascertain its place within the periodic table. With this method, Moseley determined the number of lanthanides and showed that there was a missing element with atomic number 72. This spurred chemists to look for it. Georges Urbain asserted that he found element 72 in the rare earth elements in 1907 and published his results on ''celtium'' in 1911. Neither the spectra nor the chemical behavior he claimed matched with the element found later, and therefore his claim was turned down after a long-standing controversy.

By early 1923, several physicists and chemists such as Niels Bohr and Charles Rugeley Bury suggested that element 72 should resemble zirconium and therefore was not part of the rare earth elements group. These suggestions were based on Bohr's theories of the atom, the X-ray spectroscopy of Moseley, and the chemical arguments of Friedrich Paneth. Encouraged by this, and by the reappearance in 1922 of Urbain's claims that element 72 was a rare earth element discovered in 1911, Dirk Coster and Georg von Hevesy were motivated to search for the new element in zirconium ores. Hafnium was discovered by the two in 1923 in Copenhagen, Denmark. The place where the discovery took place led to the element being named for the Latin name for "Copenhagen", ''Hafnia'', the home town of Niels Bohr.

Hafnium was separated from zirconium through repeated recrystallization of the double ammonium or potassium fluorides by Valdemar Thal Jantzen and von Hevesy. Anton Eduard van Arkel and Jan Hendrik de Boer were the first to prepare metallic hafnium by passing hafnium tetraiodide vapor over a heated tungsten filament in 1924. The long delay between the discovery of the lightest two group 4 elements and that of hafnium was partly due to the rarity of hafnium, and partly due to the extreme similarity of zirconium and hafnium, so that all previous samples of zirconium had in reality been contaminated with hafnium without anyone knowing.

The last element of the group, rutherfordium, does not occur naturally and had to be made by synthesis. The first reported detection was by a team at the Joint Institute for Nuclear Research (JINR), which in 1964 claimed to have produced the new element by bombarding a plutonium-242 target with neon-22 ions, although this was later put into question. More conclusive evidence was obtained by researchers at the University of California, Berkeley, who synthesised element 104 in 1969 by bombarding a californium-249 target with carbon-12 ions. A controversy erupted on who had discovered the element, which each group suggesting its own name: the Dubna group named the element ''kurchatovium'' after Igor Kurchatov, while the Berkeley group named it ''rutherfordium'' after Ernest Rutherford. Eventually a joint working party of IUPAC and IUPAP, the Transfermium Working Group, decided that credit for the discovery should be shared. After various compromises were attempted, in 1997 IUPAC officially named the element rutherfordium following the American proposal.

Characteristics

Chemical

Like other groups, the members of this family show patterns in their electron configurations, especially the outermost shells, resulting in trends in chemical behavior. Most of the chemistry has been observed only for the first three members of the group; chemical properties of rutherfordium are not well-characterized, but what is known and predicted matches its position as a heavier homolog of hafnium.

Titanium, zirconium, and hafnium are reactive metals, but this is masked in the bulk form because they form a dense oxide layer that sticks to the metal and reforms even if removed. As such, the bulk metals are very resistant to chemical attack; most aqueous acids have no effect unless heated, and aqueous alkalis have no effect even when hot. Oxidizing acids such as nitric acids indeed tend to reduce reactivity as they induce the formation of this oxide layer. The exception is hydrofluoric acid, as it forms soluble fluoro complexes of the metals. When finely divided, their reactivity shows as they become pyrophoric, directly reacting with oxygen and hydrogen, and even nitrogen in the case of titanium. All three are fairly electropositive, although less so than their predecessors in group 3.Greenwood and Earnshaw, pp. 958–61 The oxides TiO₂, ZrO₂ and HfO₂ are white solids with high melting points and unreactive against most acids.

The chemistry of group 4 elements is dominated by the group oxidation state. Zirconium and hafnium are in particular extremely similar, with the most salient differences being physical rather than chemical (melting and boiling points of compounds and their solubility in solvents). This is an effect of the lanthanide contraction: the expected increase of atomic radius from the 4d to the 5d elements is wiped out by the insertion of the 4f elements before. Titanium, being smaller, is distinct from these two: its oxide is less basic than those of zirconium and hafnium, and its aqueous chemistry is more hydrolyzed. Rutherfordium should have a still more basic oxide than zirconium and hafnium.Periodic table poster
by A. V. Kulsha and T. A. Kolevich

The chemistry of all three is dominated by the +4 oxidation state, though this is too high to be well-described as totally ionic. Low oxidation states are not well-represented for zirconium and hafnium (and should be even less well-represented for rutherfordium); the +3 oxidation state of zirconium and hafnium reduces water. For titanium, this oxidation state is merely easily oxidised, forming a violet Ti³⁺ aqua cation in solution. The elements have a significant coordination chemistry: zirconium and hafnium are large enough to readily support the coordination number of 8. All three metals however form weak sigma bonds to carbon and because they have few d electrons, pi backbonding is not very effective either.

Physical

The trends in group 4 follow those of the other early d-block groups and reflect the addition of a filled f-shell into the core in passing from the fifth to the sixth period. All the stable members of the group are silvery refractory metals, though impurities of carbon, nitrogen, and oxygen make them brittle.Greenwood and Earnshaw, pp. 956–8 They all crystallize in the hexagonal close-packed structure at room temperature,Greenwood and Earnshaw, pp. 946–8 and rutherfordium is expected to do the same. At high temperatures, titanium, zirconium, and hafnium transform to a body-centered cubic structure. While they are better conductors of heat and electricity than their group 3 predecessors, they are still poor compared to most metals. This, along with the higher melting and boiling points, and enthalpies of fusion, vaporization, and atomization, reflects the extra d electron available for metallic bonding.

The table below is a summary of the key physical properties of the group 4 elements. The four question-marked values are extrapolated.

Titanium

Zirconium

Hafnium

Rutherfordium

Production

The production of the metals itself is difficult due to their reactivity. The formation of oxides, nitrides, and carbides must be avoided to yield workable metals; this is normally achieved by the Kroll process. The oxides (MO₂) are reacted with coal and chlorine to form the chlorides (MCl₄). The chlorides of the metals are then reacted with magnesium, yielding magnesium chloride and the metals.

Further purification is done by a chemical transport reaction developed by Anton Eduard van Arkel and Jan Hendrik de Boer. In a closed vessel, the metal reacts with iodine at temperatures above 500 °C forming metal(IV) iodide; at a tungsten filament of nearly 2000 °C the reverse reaction happens and the iodine and metal are set free. The metal forms a solid coating on the tungsten filament and the iodine can react with additional metal resulting in a steady turnover.
::M + 2 I₂ (low temp.) → MI₄
::MI₄ (high temp.) → M + 2 I₂

Occurrence

The abundance of the group 4 metals decreases with increase of atomic mass. Titanium is the seventh most abundant metal in Earth's crust and has an abundance of 6320 ppm, while zirconium has an abundance of 162 ppm and hafnium has only an abundance of 3 ppm.

All three stable elements occur in heavy mineral sands ore deposits, which are placer deposits formed, most usually in beach environments, by concentration due to the specific gravity of the mineral grains of erosion material from mafic and ultramafic rock. The titanium minerals are mostly anatase and rutile, and zirconium occurs in the mineral zircon. Because of the chemical similarity, up to 5% of the zirconium in zircon is replaced by hafnium. The largest producers of the group 4 elements are Australia, South Africa and Canada.

Applications

Titanium metal and its alloys have a wide range of applications, where the corrosion resistance, the heat stability and the low density (light weight) are of benefit. The foremost use of corrosion-resistant hafnium and zirconium has been in nuclear reactors. Zirconium has a very low and hafnium has a high thermal neutron-capture cross-section. Therefore, zirconium (mostly as zircaloy) is used as cladding of fuel rods in nuclear reactors, while hafnium is used in control rods for nuclear reactors, because each hafnium atom can absorb multiple neutrons.

Smaller amounts of hafnium and zirconium are used in super alloys to improve the properties of those alloys.

Biological occurrences

The group 4 elements are not known to be involved in the biological chemistry of any living systems. They are hard refractory metals with low aqueous solubility and low availability to the biosphere. Titanium is one of the only two first row d-block transition metals with no known or suspected biological role (the other being scandium). Rutherfordium's radioactivity of just a couple of hours would make it toxic to living cells. However, it is a synthetic element, so it does not occur in nature or the human body.

Precautions

Titanium is non-toxic even in large doses and does not play any natural role inside the human body. An estimated quantity of 0.8 milligrams of titanium is ingested by humans each day, but most passes through without being absorbed in the tissues. It does, however, sometimes bio-accumulate in tissues that contain silica. One study indicates a possible connection between titanium and yellow nail syndrome.

Zirconium powder can cause irritation, but only contact with the eyes requires medical attention. OSHA recommendations for zirconium are 5 mg/m³ time weighted average limit and a 10 mg/m³ short-term exposure limit.

Only limited data exists on the toxicology of hafnium. Care needs to be taken when machining hafnium because it is pyrophoric—fine particles can spontaneously combust when exposed to air. Compounds that contain this metal are rarely encountered by most people. The pure metal is not considered toxic, but hafnium compounds should be handled as if they were toxic because the ionic forms of metals are normally at greatest risk for toxicity, and limited animal testing has been done for hafnium compounds.

References

Bibliography

*

{{DEFAULTSORT:Group 04
Groups (periodic table)