Lug Sail
   HOME

TheInfoList



OR:

The lug sail, or lugsail, is a
fore-and-aft A fore-and-aft rig is a sailing ship rig with sails set mainly in the median plane of the keel, rather than perpendicular to it, as on a square-rigged vessel. Description Fore-and-aft rigged sails include staysails, Bermuda rigged sails, gaff ...
, four-cornered sail that is suspended from a spar, called a
yard The yard (symbol: yd) is an English units, English unit of length in both the British imperial units, imperial and US United States customary units, customary systems of measurement equalling 3 foot (unit), feet or 36 inches. Sinc ...
. When raised, the sail area overlaps the mast. For "standing lug" rigs, the sail may remain on the same side of the mast on both the port and starboard tacks. For "dipping lug" rigs, the sail is lowered partially or totally to be brought around to the
leeward In geography and seamanship, windward () and leeward () are directions relative to the wind. Windward is ''upwind'' from the point of reference, i.e., towards the direction from which the wind is coming; leeward is ''downwind'' from the point o ...
side of the mast in order to optimize the efficiency of the sail on both tacks. The lug sail is evolved from the
square sail Square rig is a generic type of sail and rigging arrangement in which a sailing vessel's primary driving sails are carried on horizontal spars that are perpendicular (or square) to the median plane of the keel and masts of the vessel. These sp ...
to improve how close the vessel can sail into the wind. Square sails, on the other hand, are symmetrically mounted in front of the mast and are manually angled to catch the wind on opposite tacks. Since it is difficult to orient square sails fore and aft or to tension their leading edges ( luffs), they are not as efficient upwind, compared with lug sails. The lug rig differs from the
gaff rig Gaff rig is a sailing rig (configuration of sails, mast and stays) in which the sail is four-cornered, fore-and-aft rigged, controlled at its peak and, usually, its entire head by a spar (pole) called the ''gaff''. Because of the size and sh ...
, also fore-and-aft, whose sail is instead attached at the luff to the mast and is suspended from a spar (gaff), which is attached to, and raised at an angle from, the mast.


Types

Lug sails are divided into three types: ''standing lug'', ''balance lug'' (or ''balanced lug'') and ''dipping lug''. *''Dipping lug'': This is a boom-less sail whose yard is lowered or "dipped" when tacking to bring the sail around to the leeward side of the mast. In some cases this can be done by partially lowering the yard - there are a number of variations in this procedure. The
tack Thermoproteati is a kingdom of archaea. Its synonym, "TACK", is an acronym for Thaumarchaeota (now Nitrososphaerota), Aigarchaeota, Crenarchaeota (now Thermoproteota), and Korarchaeota (now Thermoproteota), the first groups discovered. They ...
fastens to a point some distance forward of the mast. For a foresail this may be the stemhead or, in some boats, one of a choice of hooks set along each gunwale. The dipping lug is a powerful sail and was widely used in working craft. *''Standing lug'': The sail and yard remain on one side of the mast and the tack of the sail is set close to the mast. When the wind blows onto the side of the mast where the sail is mounted, it deforms the sail over the mast. A standing lug can be used with or without a boom - the latter being the preference for working craft. The standing lug differs from the balance rig. On a standing lug the yard extends past the mast, but the of the sail does not. *''Balance lug'' (or ''balanced lug''): The sail has both a yard and a boom, which both extend past the mast and remain on the same side of the mast on either tack. The tanja rig (sometimes inaccurately called "balance lug") and junk rig (a fully battened sail that crosses the mast at the head and foot) are similar to a balance lug.


Procedures for tacking by dipping

Whereas a standing lug may be tacked conventionally by moving the sail across the vessel, as the wind crosses the bow, a dipping lug must be brought around to the leeward side by a multi-step procedure: #Hauling in the sheets to get the sail over the boat. #Lowering the halyard so that the peak of the sail can be reached, yet the yard is free of interfering with the rest of the boat. #Gathering the after part of the sail and bringing it around forward of the mast. #Bringing the peak down and passing it under the luff of the sail to the new leeward side. #Bringing the halyard to windward aft of the mast. #Shackling on the sheets and bringing the sail aft. #Rehoisting the sail and sheeting in. This procedure is also necessary for gybing a dipping lug. Reportedly, this action can be completed expeditiously on a larger boat with four hands. On smaller boats, the sail is simply lowered and the mast unstepped to allow the sail to be moved beneath it to the other side and the mast to be re-stepped and the sail raised. On larger luggers, like the Fifie, large dipping lug sails were possible only with the introduction of steam-powered capstans to facilitate with dipping.


Extent of use

The rig was widely used in Europe from the seventeenth through the nineteenth centuries for small fishing vessels and other coasters because of their good performance to windward. This popularity extended to smugglers and privateers and the French ''
chasse-marée In English, a chasse-marée is a specific, archaic type of decked commercial sailing vessel. In French, ''un chasse-marée'' was 'a wholesale fishmonger', originally on the English Channel, Channel coast of France and later, on the Atlantic coa ...
'' fishing boats. Currently, lug rigs are used on certain small sailing craft, like the International Twelve Foot Dinghy, a
dinghy A dinghy is a type of small boat, often carried or Towing, towed by a Watercraft, larger vessel for use as a Ship's tender, tender. Utility dinghies are usually rowboats or have an outboard motor. Some are rigged for sailing but they diffe ...
, the SCAMP, a
pocket cruiser A pocket cruiser is a sailboat designed for recreational Cruising (maritime), cruising and club racing, under in length. Like the similar and usually smaller trailer sailer, they have design features such as light weight and short Sailing ball ...
, and the Oz Goose sailing dinghy. There are several lug rigged boat classes of long history that have been raced more or less continuously for a century. One example is the balance lug rigged Lymington Scow that has become highly developed in almost continuous racing since 1905.


See also

*
Lugger A lugger is a sailing vessel defined by its rig, using the lug sail on all of its one or more masts. Luggers were widely used as working craft, particularly off the coasts of France, England, Ireland and Scotland. Luggers varied extensively ...
* Junk rig, also known as the Chinese lugsail *
Tanja sail Tanja sail ( Malay: ''layar tanjak'') or tanja rig is a type of sail commonly used by the Austronesian people, particularly in Maritime Southeast Asia. It is also known as the tilted square sail, canted rectangular sail, rectangular balance lug ...
, a type of sail from Nusantara archipelago


References


External links


Tacking dipping lugsail, Beer lugger-style
Method of dipping a Beer Lugger's sail

by John C. Harris
"Lugsail setup and performance articles"
by Michael Storer
"Drawings, Photos of the Major Lug Types with short explanation of differences"
by Really Simple Sails {{Sail types Sailing rigs and rigging