|
Types Of Radio Emissions
The International Telecommunication Union uses an internationally agreed system for classifying radio frequency signals. Each type of radio emission is classified according to its Bandwidth (signal processing), bandwidth, method of modulation, nature of the modulating signal, and type of information transmitted on the carrier signal. It is based on characteristics of the ''signal'', not on the transmitter used. An emission designation is of the form ''BBBB 123 45'', where ''BBBB'' is the bandwidth of the signal, ''1'' is a letter indicating the type of modulation used of the main carrier (not including any subcarriers which is why FM stereo is F8E and not D8E), ''2'' is a digit representing the type of modulating signal again of the main carrier, ''3'' is a letter corresponding to the type of information transmitted, ''4'' is a letter indicating the practical details of the transmitted information, and ''5'' is a letter that represents the method of multiplexing. The ''4'' and ' ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
International Telecommunication Union
The International Telecommunication Union (ITU)In the other common languages of the ITU: * * is a list of specialized agencies of the United Nations, specialized agency of the United Nations responsible for many matters related to information and communications technology, information and communication technologies. It was established on 17 May 1865 as the International Telegraph Union, the first formal and permanent international organization. The organization significantly predates the UN, making it the oldest UN agency. Doreen Bogdan-Martin is the Secretary-General of ITU, the first woman to serve as its head. The ITU was initially aimed at helping connect Telegraphy, telegraphic networks between countries, with its mandate consistently broadening with the advent of new communications technologies; it adopted its current name in 1932 to reflect its expanded responsibilities over radio and the telephone. On 15 November 1947, the ITU entered into an agreement with the newly cr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Frequency Modulation
Frequency modulation (FM) is a signal modulation technique used in electronic communication, originally for transmitting messages with a radio wave. In frequency modulation a carrier wave is varied in its instantaneous frequency in proportion to a property, primarily the instantaneous amplitude, of a message signal, such as an audio signal. The technology is used in telecommunications, radio broadcasting, signal processing, and Run-length limited#FM: .280.2C1.29 RLL, computing. In Analog signal, analog frequency modulation, such as radio broadcasting of voice and music, the instantaneous frequency deviation, i.e. the difference between the frequency of the carrier and its center frequency, has a functional relation to the modulating signal amplitude. Digital data can be encoded and transmitted with a type of frequency modulation known as frequency-shift keying (FSK), in which the instantaneous frequency of the carrier is shifted among a set of frequencies. The frequencies m ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Radioteletype
Radioteletype (RTTY) is a telecommunications system consisting originally of two or more electromechanical teleprinters in different locations connected by radio rather than a wired link. Radioteletype evolved from earlier landline teleprinter operations that began in the mid-1800s. The US Navy Department successfully tested printing telegraphy between an airplane and ground radio station in 1922. Later that year, the Radio Corporation of America ( RCA) successfully tested printing telegraphy via their Chatham, Massachusetts, radio station to the RMS ''Majestic''. Commercial RTTY systems were in active service between San Francisco and Honolulu as early as April 1932 and between San Francisco and New York City by 1934. The US military used radioteletype in the 1930s and expanded this usage during World War II. From the 1980s, teleprinters were replaced by personal computers (PCs) running software to emulate teleprinters. The term radioteletype is used to describe both the or ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Morse Code
Morse code is a telecommunications method which Character encoding, encodes Written language, text characters as standardized sequences of two different signal durations, called ''dots'' and ''dashes'', or ''dits'' and ''dahs''. Morse code is named after Samuel Morse, one of the early developers of the system adopted for electrical telegraphy. International Morse code encodes the 26 ISO basic Latin alphabet, basic Latin letters to , one Diacritic, accented Latin letter (), the Arabic numerals, and a small set of punctuation and procedural signals (Prosigns for Morse code, prosigns). There is no distinction between upper and lower case letters. Each Morse code symbol is formed by a sequence of ''dits'' and ''dahs''. The ''dit'' duration can vary for signal clarity and operator skill, but for any one message, once the rhythm is established, a beat (music), half-beat is the basic unit of time measurement in Morse code. The duration of a ''dah'' is three times the duration ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Reduced-carrier Transmission
Reduced-carrier transmission is an amplitude modulation (AM) transmission in which the carrier signal level is reduced to reduce wasted electrical power. Suppressed-carrier transmission is a special case in which the carrier level is reduced below that required for demodulation by a normal receiver. Reduction of the carrier level permits higher power levels in the sidebands than would be possible with conventional AM transmission. Carrier power must be restored by the receiving station to permit demodulation, usually by means of a beat frequency oscillator (BFO). Failure of the BFO to match the original carrier frequency when receiving such a signal will cause a heterodyne. Suppressed carriers are often used for single sideband (SSB) transmissions, such as for amateur radio on shortwave. That system is referred to in full as SSB suppressed carrier ( SSBSC) or (SSB-SC). International broadcasters agreed in 1985 to also use SSBSC entirely by 2015, though IBOC and IBAC ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-position Modulation
Pulse-position modulation (PPM) is a form of signal modulation in which ''M'' message bits are encoded by transmitting a single pulse in one of 2^M possible required time shifts. This is repeated every ''T'' seconds, such that the transmitted bit rate is M/T bits per second. It is primarily useful for optical communications systems, which tend to have little or no multipath interference. History An ancient use of pulse-position modulation was the Greek hydraulic semaphore system invented by Aeneas Stymphalus around 350 B.C. that used the water clock principle to time signals. In this system, the draining of water acts as the timing device, and torches are used to signal the pulses. The system used identical water-filled containers whose drain could be turned on and off, and a float with a rod marked with various predetermined codes that represented military messages. The operators would place the containers on hills so they could be seen from each other at a distance. To send ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
WWVB
WWVB is a longwave time signal radio station near Fort Collins, Colorado, and is operated by the National Institute of Standards and Technology (NIST). Most radio clock, radio-controlled clocks in North America use WWVB's transmissions to set the correct time. The normal signal transmitted from WWVB is 70 kW Effective radiated power, ERP and uses a 60 Hertz, kHz carrier wave yielding a frequency uncertainty of less than 1 part in 10. The time code signal is derived from a set of atomic clocks located at the site, and transmitted using the IRIG timecode, IRIG "H" format and modulated onto the carrier wave using pulse-width modulation and amplitude-shift keying at one bit per second. A single complete frame of time code begins at the start of each minute, lasts one minute, and conveys the year, day of year, hour, minute, and other information . WWVB is co-located with WWV (radio station), WWV, a time signal station that broadcasts in both voice and time code on multiple ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-width Modulation
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal. The average value of voltage (and current) fed to the load is controlled by switching the supply between 0 and 100% at a rate faster than it takes the load to change significantly. The longer the switch is on, the higher the total power supplied to the load. Along with maximum power point tracking (MPPT), it is one of the primary methods of controlling the output of solar panels to that which can be utilized by a battery. PWM is particularly suited for running inertial loads such as motors, which are not as easily affected by this discrete switching. The goal of PWM is to control a load; however, the PWM switching frequency must be sele ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Pulse-amplitude Modulation
Pulse-amplitude modulation (PAM) is a form of signal modulation in which the message information is encoded in the amplitude of a pulse train interrupting the carrier frequency. Demodulation is performed by detecting the amplitude level of the carrier at every single period. Types There are two types of pulse amplitude modulation: * In ''single polarity PAM'', a suitable fixed DC bias is added to the signal to ensure that all the pulses are positive. * In ''double polarity PAM'', the pulses are both positive and negative. Pulse-amplitude modulation is widely used in modulating signal transmission of digital data, with non- baseband applications having been largely replaced by pulse-code modulation, and, more recently, by pulse-position modulation. The number of possible pulse amplitudes in analog PAM is theoretically infinite. Digital PAM reduces the number of pulse amplitudes to some natural number. Uses Ethernet Some versions of the Ethernet communication standard are ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Shortwave
Shortwave radio is radio transmission using radio frequencies in the shortwave bands (SW). There is no official definition of the band range, but it always includes all of the high frequency band (HF), which extends from 3 to 30 MHz (approximately 100 to 10 metres in wavelength). It lies between the medium frequency band (MF) and the bottom of the VHF band. Radio waves in the shortwave band can be reflected or refracted from a layer of electrically charged atoms in the atmosphere called the ionosphere. Therefore, short waves directed at an angle into the sky can be reflected back to Earth at great distances, beyond the horizon. This is called skywave or "skip" propagation. Thus shortwave radio can be used for communication over very long distances, in contrast to radio waves of higher frequency, which travel in straight lines (line-of-sight propagation) and are generally limited by the visual horizon, about 64 km (40 miles). Shortwave broadcasts of radio pr ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
Single-sideband Suppressed Carrier Transmission
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of signal modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently. Amplitude modulation produces an output signal the bandwidth of which is twice the maximum frequency of the original baseband signal. Single-sideband modulation avoids this bandwidth increase, and the power wasted on a carrier, at the cost of increased device complexity and more difficult tuning at the receiver. Basic concept Radio transmitters work by mixing a radio frequency (RF) signal of a specific frequency, the carrier wave, with the audio signal to be broadcast. In AM transmitters this mixing usually takes place in the final RF amplifier (high level modulation). It is less common and much less efficient to do the mixing at low power and then amplify it in a li ... [...More Info...] [...Related Items...] OR: [Wikipedia] [Google] [Baidu] |
